The Mastic Doctor team standing beside their branded vans outside an office building
East Sussex · England

Fire Stopping in Upper Horsebridge

We carry out fire-rated and intumescent sealing of service penetrations and linear gaps in Upper Horsebridge. Send photographs or drawings for a fixed quote.

  • Non-fire-rated filler around services
  • Hidden openings found during inspections
  • Openings left by services added after handover
1
Send details
Tell us about the site, with photos if you have them.
2
Get a quote
One fixed quote covering the agreed scope.
3
We seal
Prepared joints, the specified product, a tidy finish.
4
Guaranteed
Backed by a 12-month workmanship guarantee.
South East, London & Scotland
CHAS accredited
£5m public liability

Need fire stopping in Upper Horsebridge?

Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.

What sealant work can’t fix

Honesty saves time and money. New sealant won’t cure:

  • Fire doors, dampers or other fire safety equipment
  • Writing the fire-stopping specification
  • Issuing fire ratings or certificates for seals

If in doubt, call 01277 525 020 or send photos by email and we’ll say what we think before you book.

Joints and surfaces we work on

  • Cable penetrations
  • Joints between fire-resisting walls and floors
  • Small duct penetrations where the tested detail allows
  • Service gaps in risers
  • Linear gaps at wall heads
  • Pipe penetrations

How we handle fire stopping in Upper Horsebridge

Opened ceilings and riser doors often reveal service openings nobody sealed. Where the walls and floors already have a fire-stopping specification, we can work to it. Where there isn’t one, the designer or fire engineer needs to set one first. We work on linear gaps at wall heads, service gaps in risers and cable penetrations, and the usual reasons a site gets in touch are seals disturbed by maintenance and left open and unsealed joints where partitions meet the slab. Whoever orders the work in Upper Horsebridge, the brief is usually the same: a clear scope, tidy work and joints that don’t fail again.

In places the size of Upper Horsebridge, fire-resisting walls and floors are found in schools, care homes, health centres and mixed-use buildings. Specified fire-rated sealant goes around new services there, built to match the manufacturer’s detail.

The 12-month guarantee is for workmanship rather than wear and tear. How long a sealant joint lasts depends on movement, exposure, cleaning and use, so we are clear about what is covered before work starts.

Where
Upper Horsebridge (BN27)
Region
East Sussex
Guarantee
12 months on every job
Quote
A fixed quote before we start
Phone
01277 525 020
Updated
3 November 2026
Mastic Doctor team members lined up next to their branded vans outside an office building

What happens if it’s left?

It is cheaper to seal service penetrations as each services package finishes than to come back for them later. While the area is still open, every opening is easy to see and reach and each detail can be checked as we go. Sealant hardens, cracks and loses grip with age, UV and movement. Renewing it in good time keeps the building weathertight.

Larger quantities, tricky access or phasing all shape the price. Site requirements like inductions and permits play a part as well.

Why us?

  • Fully insured
  • One number for every site we cover
  • Specification-led, product-correct work
  • Clear, fixed quotes

See our cost guide or our accreditations.

Questions we’re asked in Upper Horsebridge

What does the BS 476 change mean for fire-rated sealant in Upper Horsebridge?

References to BS 476 classes are being removed from Approved Document B from 2 September 2029, after which BS EN 13501-2 classification is the route, subject to transitional arrangements. Our part doesn’t change: the specified product, to its tested detail.

Do you seal service penetrations in hotels around Upper Horsebridge?

Yes, where fire-rated sealant is the specified product. Work is done room by room so the hotel keeps trading; design and sign-off stay with the designer and building control.

Can you work to our specification?

Yes. The specification and the manufacturer’s installation guidance are what we work to, and we raise anything unclear before work begins.

Can one quote cover more than one building?

Yes. A group of buildings can go on one quote, with one point of contact across South East England, Greater London and Scotland.

How soon can the area be used again?

Curing time varies by product, and we confirm it on the day, and sign any area that should be left alone.

Will you just go over the old sealant?

No, never. Sealing over old material is one of the classic causes of early joint failure, so everything comes out first.

What happens if old sealant might contain asbestos?

Asbestos is possible in some older mastics, particularly in buildings from before 2000. We check the asbestos register before cutting out old sealant in an older building, and if asbestos is suspected, work stops until it’s tested. Removing asbestos is a job for asbestos specialists, not us.

Looking after the joints

Cleaning and maintenance staff play a part too. Pass these on to them:

  • Look above ceilings when tiles are lifted for other jobs
  • Put resealing into every M&E and fit-out package
  • File the specified details where the next contractor can find them
  • Foam or ordinary sealant is never a fire-seal repair

After the work, brief anyone else working in the area that the openings are now sealed. Any seal cut back for a new service needs reinstating to its tested detail using the same product.

Regular walk-rounds of service areas are worth the time. A cracked or disturbed seal found early is a small job compared with dozens found at once.

Compartments and services around Upper Horsebridge

For England, the fire stopping of penetrations is dealt with in Approved Document B. Its BS 476 references are being withdrawn from 2 September 2029, with BS EN 13501-2 classification taking over, subject to transitional arrangements. We install whatever has been specified, to the product’s tested detail. There are a number of hotels within about 2 miles of Upper Horsebridge. A hotel refit often runs new services through compartment walls between bedrooms and corridors, and each opening needs the specified seal.

In a school such as Hawkes Farm Academy, fire-rated sealant goes in around service penetrations where it is specified. For a hospital such as Amberstone Hospital (1 mile east of Upper Horsebridge), penetration sealing is normally phased ward by ward, with infection-control rules agreed first.

Upper Horsebridge is about 7 miles north of Eastbourne, in East Sussex. We cover commercial sites throughout Upper Horsebridge, for single jobs and planned programmes alike. Our East Sussex coverage takes in 308 places, from busy centres to rural villages. Our Brighton page has more on work in that area, about 17 miles away.

If you need fire stopping in BN27, the process matches everywhere else we work: details, then a fixed price, then sealing and a 12-month guarantee. Streets here include New Road, Park Road and Hawks Road, and sites on any of them can send details for a fixed quote. You will find Upper Horsebridge on or near the A271, so getting applicators and materials to site is simple. If your building is just outside Upper Horsebridge, we cover Hellingly (1 mile north-east), Lower Horsebridge (1 mile west), Tile Hurst (1 mile south-west), Hailsham (1 mile south) and Magham Down (1 mile east). Nearby towns on our patch include Eastbourne (7 miles south), Hastings (14 miles east), Bexhill-on-Sea (9 miles east), Seaford (9 miles south-west), Lewes (11 miles west) and Crowborough (13 miles north).

What’s near Upper Horsebridge

In Upper Horsebridge, that means premises near The Grenadier pub and Hailsham Community College and the streets around them. The nearest railway station is Polegate station, about 3.9 miles south. Nearby you will also find Hellingly Hospital Railway (0.7 miles north) and Sussex Farm Museum (3.9 miles north).

Map of Upper Horsebridge © OpenStreetMap contributors

How a job runs

Site rules come first: sign-in, induction and whatever permit system the building uses. With the paperwork done, we take the joints in the sequence agreed with you, and each area is checked before we leave it. What matters most for a job in Upper Horsebridge is a clear list of what needs doing, so send photographs of each area. You’ll then get a fixed price for the work.

  1. We read the specification, drawings or penetration schedule you send.
  2. Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
  3. Unsuitable fillers and loose debris are taken out of each opening.
  4. We fit the backing the detail asks for, to the stated depth.
  5. Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
  6. If an opening needs something other than sealant, we tell you instead of improvising.

Getting the site ready

  • Send any specification or drawings in advance
  • Agree which areas must stay open
  • Let us know about inductions and permits

Quotes

If there’s a specification, drawings or a tender package, send it with your enquiry, and we’ll price against exactly what is specified. Smaller jobs need nothing more than photos and a few notes.

Get a quick quote

Related advice

Quoting for work in Upper Horsebridge

The price varies from site to site. Expect it to depend on:

  • Location, for remote and island sites
  • Access and working height
  • Whether old sealant has to be cut out first
  • Phasing around occupants

A quote for service penetrations depends on quantities, condition and access, and any specification that applies. Ask us for a fixed quote.

Details that help us quote

A few photographs plus some basic facts will normally do. Please tell us:

  • What the building is and how it’s used
  • Photos of the joints, close up and from further back
  • Drawings or a marked-up plan, if available
  • Access details, including height

A good quote starts with a clear picture: the joints involved, quantities, access and the product called for. Share whatever details you have and we’ll fill any gaps with a visit.

What we are called out for in Upper Horsebridge

Mixing products or improvising a detail breaks the link with the test evidence. Gaps beyond the tested size, shallow sealant, no backing where it was needed, or products from different systems mixed together are the usual culprits.

Site and facilities staff are often the first to spot these:

  • Fire-stopping items raised at inspection or handover
  • Fire sealant pulled out of the opening
  • Damaged fire seals in risers and voids
  • Unsealed openings around new pipes and cables

On estates like Crown Close Industrial Estate, 1.2 miles to the south of Upper Horsebridge, the wall between office and warehouse is often fire-resisting, and cables through it need the specified seal.

What your quote should include

  • Health and safety accreditation such as CHAS
  • Is depth set with backing rod, or bond-breaker tape in shallow joints?
  • Whether primer will be used where the manufacturer specifies it
  • How long is the guarantee, and what does it include?

Choosing a commercial sealant contractor

Accreditations

Trusted. Accredited. Insured.