Touchen-end fire stopping
Work needed on a service penetration in Touchen-end? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Unsealed penetrations discovered above suspended ceilings
- Open linear gaps along the top of fire-resisting walls
- Snag lists that include open service penetrations
Fire stopping across Touchen-end
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Your questions answered
Do you cover business parks and estates near Touchen-end, such as Trade Park?
Yes, sites like Trade Park are within our area, along with the rest of Touchen-end. Send details of the unit and the work through our quote form for a quick quote.
What happens to BS 476 references for fire stopping in Touchen-end?
Approved Document B loses its BS 476 references from 2 September 2029, and BS EN 13501-2 becomes the route, subject to transitional arrangements. Our part doesn’t change: the specified product, to its tested detail.
How long does a job like this take?
We plan the time on site around your programme and access. You will have an expected duration with the quote.
Can weather delay the job?
It can, for external work. Wet joints and cold, damp or frosty conditions stop the sealant bonding properly, so we watch the forecast and rearrange outside work if we have to. Indoors, the weather is rarely a problem.
Will you just go over the old sealant?
No, never. Sealing over old material is one of the classic causes of early joint failure, so it all comes out first.
Will your applicators have CSCS cards?
Yes. Should the site need card details in advance, let us know and we’ll send them with the quote.
What will the job cost?
That depends on the job: the volume of work, the access, the specified product and how it’s phased. Call for a quote.
Fire stopping in Touchen-end, done properly
We should be clear about what we do and don’t do. The designer, fire engineer or building control decides which fire stopping is required. What we bring is careful installation of the specified sealant, to the maker’s guidance on buildings around Touchen-end. If you’re dealing with non-fire-rated filler around services and hidden openings found during inspections, we can put it right. Most enquiries from Touchen-end start with one failed joint and grow into a wider look at the building: we check the joints around it and give you an honest view of what needs doing now and what can wait.
For a smaller site near Touchen-end, we plan to do all the penetrations in one go, so send the specification and photos first. Design and sign-off belong to the designer or building control; we install what’s specified.
Our 12-month guarantee is about workmanship, not wear and tear. How long a sealant joint lasts depends on movement, exposure, cleaning and use, so we are clear about what is covered before work starts.
- Where
- Touchen-end (SL6)
- Wider area
- Windsor and Maidenhead
- Cover
- A 12-month guarantee
- Quotes
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
Nearby places to Touchen-end
More services for Touchen-end
Fire stopping in Touchen-end: the local picture
Touchen-end lies roughly 27 miles out from central London. Offices around the capital are refitted often, and the cabling that follows can breach fire-resisting walls; the gaps need the specified seal. In England, Approved Document B covers fire stopping of openings and penetrations. Its BS 476 references are being withdrawn from 2 September 2029, with BS EN 13501-2 classification taking over, subject to transitional arrangements. We install whatever has been specified, to the product’s tested detail.
Hospital estates such as St Mark's Hospital, 3 miles north of Touchen-end, are divided into fire compartments, and any service penetration through them should be sealed to the specified, tested detail. Schools such as Holyport College often have new data and services installed during holidays, and penetrations through fire-resisting walls should be checked afterwards.
Touchen-end is about 3 miles south of Maidenhead, in Windsor and Maidenhead. Any commercial site in Touchen-end is covered, whether it’s a single job or part of a planned programme. Touchen-end is one of 60 places we cover in Windsor and Maidenhead. Reading is covered too, around 11 miles from Touchen-end.
We take on service penetrations across the SL6 postcode area, for business premises of every kind. If your building is just outside Touchen-end, we cover Stud Green (1 mile north), Moneyrow Green (1 mile north-east), Holyport (1 mile north-east), Paley Street (1 mile west) and Braywoodside (1 mile south-west). Nearby towns on our patch include Maidenhead (3 miles north), Windsor (4 miles east), Cookham (5 miles north), Furze Platt (4 miles north), Dedworth (3 miles east) and Broomhall (8 miles south-east).
Around Touchen-end
We work on buildings around Jolly Gardener pub, Ockwells Park and Holyport CofE Primary School, among other places. Touchen-end’s nearest station is Maidenhead station, roughly 2.4 miles north of the centre. Nearby you will also find The Reitlinger Bequest Museum (2.9 miles north) and St Mark's Hospital (2.9 miles north). For a walk, there’s Bray Pit and Weycock Hill.
Building owners, agents and FMs in Touchen-end
Facilities managers want contractors who arrive with the paperwork sorted. Let us know the documents you need (RAMS, insurance certificate, CSCS details) and we will confirm them with the quote.
Building owners and managing agents use us on sealant work across single buildings or whole portfolios. One quote can cover more than one site, so there’s one set of paperwork to deal with.
On site: what to expect
In a busy building, the work is phased so only one area is out of use at a time. Each area is protected, prepared and sealed, then handed back before we move to the next. For a building around Touchen-end, tell us how to find it and who will meet us. Send that with the details and we’ll confirm the plan with the quote.
- First we confirm the product and tested details named in the specification.
- We sort the openings by the detail each one needs.
- Old or wrong materials are cut out.
- Mineral wool or other backing is fitted where required.
- We gun the sealant in to the specified depth around each service and tool it.
- We walk the completed areas with you and confirm the records agreed at quote stage.
What we need from you
- Flag any permit to work we will need
- Tell us which areas need to stay in use
- Send any specification or drawings in advance
Getting a fixed quote
A good quote starts with a clear picture: what’s there, how much of it, how we reach it and what’s specified. Share whatever details you have and we’ll fill any gaps with a visit.
Advice
Honest limits
Not every problem is a sealant problem, and we’d rather tell you before you spend money. It won’t fix:
- Large openings beyond what any sealant detail covers
- Writing the fire-stopping specification
- Gaps in walls that were never built as compartment walls
If you’re not sure, just ring 01277 525 020 or send photos by email and we will give you a straight answer before you book.
Surfaces we seal
- Joints between fire-resisting walls and floors
- Cable penetrations
- Linear gaps at wall heads
- Service gaps in risers
- Pipe penetrations
- Small duct penetrations where the tested detail allows
Common problems we fix in Touchen-end
Plenty of openings were simply never closed. Inspections, refurbishments and ceiling access typically bring them to light.
These are often picked up first by site or facilities staff:
- Old intumescent sealant that has split away
- Unsealed joints where partitions meet the slab
- Non-fire-rated filler around services
- Seals that don’t match their tested detail
Where a unit on an estate such as Trade Park, which lies north-east of Touchen-end, has fire-resisting walls between offices and warehouse, any new service through them should be sealed to the tested detail.
What your quote should include
- Can the work be phased to keep areas open?
- How joint depth will be controlled
- Their public liability cover
- Will RAMS and insurance details be available?
Should maintenance staff do it?
Some joints are best left to specialists: for example fire-rated seals that must match a tested detail, trafficked floor joints and external movement joints. A poor seal in places like these tends to cost more to put right later.
Paperwork matters too. Many sites expect CSCS cards, RAMS and proof of insurance, and we will confirm the paperwork you need with the quote.
Quoting for work in Touchen-end
A fixed quote reflects the actual work. It takes account of:
- Joint width, depth and condition
- Removal of failed or old sealant
- Whether the work must be split into stages
- How much there is to seal
No two sites price the same: joint size, product, access and site hours all play a part. A fixed quote follows once we understand the job.
Details that help us quote
However big the job, the same details help:
- What the building is and how it’s used
- Drawings or a marked-up plan, if available
- Your programme or deadline
- Clear photos of the problem areas
We quote a fixed sum against the scope you give us, so you know the figure before anyone is on site. To ask for one, call the office on 01277 525 020 or email the details over.