Fire-rated sealing and fire stopping in Toddington, West Sussex
Fire stopping in Toddington, backed by over 20 years in commercial sealing. Fully insured, with a 12-month guarantee.
- Fire sealant pulled out of the opening
- Seals disturbed by maintenance and left open
- Service penetrations left open after M&E works
Need fire stopping in Toddington?
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
About our fire stopping in Toddington
Fire-rated sealant suits many small service penetrations: copper and steel pipes, cables and some small ducts where the tested detail allows. Larger openings and some plastic pipes call for collars, wraps, batts or boards instead. We use sealant where it is the specified product, and we tell you when a detail calls for something else. We work on cable penetrations, joints between fire-resisting walls and floors and linear gaps at wall heads, and the usual reasons a site gets in touch are openings left by services added after handover and old intumescent sealant that has split away. Searching for sealant specialists in Toddington? Mastic Doctor has worked for contractors, FMs and building owners since 2005, CHAS accredited and a Constructionline member.
In places the size of Toddington, fire-resisting walls and floors are found in schools, care homes, health centres and mixed-use buildings. Specified fire-rated sealant goes around new services there, built to match the manufacturer’s detail.
Work we carry out comes with a 12-month guarantee. Should something we installed fail, ring 01277 525 020 or send details through our quote form and we will come back to it.
- Place
- Toddington (BN17)
- Wider area
- West Sussex
- Guarantee
- 12 months on our workmanship
- Price
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Updated
- 3 November 2026
How the job changes by surface
Small ducts
Small ductwork can sometimes be sealed with sealant where the tested detail includes it. Larger or fire-rated ductwork normally needs a different solution set by the designer and we flag that rather than guess.
Risers and ceiling voids
Risers and ceiling voids hold most of a building’s service penetrations. Access is often tight, so we agree it with you in advance.
From enquiry to sign-off
At the end of each section, we remove the tape, clean down and inspect every joint, ready for your sign-off. Where the sealant needs time to cure before use, we tell you and sign the area. Several jobs near Toddington can be grouped on one trip. Mention the building’s opening times and we will work within them.
- We start with your penetration schedule, drawings or specification.
- Access, permits and the order of areas are agreed with the site team.
- We compare every service penetration with its tested detail before sealing.
- Unsuitable material is removed and the opening cleaned so the seal starts clean.
- The specified backing and sealant go in to depth and are finished neatly.
- We tell you about openings that need a different product.
Getting the site ready
- Let building users know which areas are affected
- Point out parking and an unloading spot
- Move anything stored against the joints
Get a fixed quote
Tell us about the building, the joints and when you need the work done, and a fixed quote will follow. The easiest way is to phone 01277 525 020 or send details through our quote form.
Advice
Should maintenance staff do it?
General builders and handymen seal joints, but it isn’t their main trade. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint.
There’s also the paperwork. Many sites expect CSCS cards, RAMS and proof of insurance, and our CSCS-carded applicators are used to working under those rules.
Also near Toddington
More services for Toddington
Toddington: questions and answers
Do you take on work at healthcare sites like Zachary Merton Hospital?
Yes, provided the work is planned with the site’s estates team. Each area is agreed with the ward or department and the estates team in advance.
Is a smaller place like Toddington outside your area?
Not at all: smaller places are covered as well as towns. London and every South East county are within our area. Send photographs and a list of what needs doing, and we’ll plan the job to need as few trips as possible.
Do you have third-party installer accreditation for fire stopping?
No. We don’t hold a third-party fire-stopping installer certificate. Our credentials are CHAS accreditation, Constructionline membership and CSCS-carded applicators, and we are fully insured. If your contract requires third-party installer certification, we’re not the right fit for that package.
Can you reseal penetrations after our M&E works?
Yes. Send the schedule or marked-up drawings and the specified product details. Work can run area by area behind the M&E trades keeping pace with the programme.
Is sealant suitable for all service openings?
No. Each fire-rated sealant is tested for particular services, gap sizes and substrates. If an opening falls outside, it needs another solution, as set out by the designer.
Is the BS 476 change in 2029 relevant to fire stopping?
From 2 September 2029, Approved Document B in England drops its references to BS 476 classes. After that, the European classification under BS EN 13501-2 is the route. Your designer will choose products with the right evidence.
How many days will you need on site?
It depends on the scope, but the work usually takes anything from one day to a planned run of visits, depending on the number of seals and the access. Larger or phased jobs take longer, and we’ll give you a timescale with the quote.
Building owners, agents and FMs in Toddington
Whether you’re a managing agent, a property factor or an owner’s representative: send details, get a fixed quote, we seal, guaranteed. Keys, access and contacts can be agreed in advance.
For main contractors, we work as the sealant subcontractor. We work to your programme, your specification and your site rules, and our applicators hold CSCS cards.
Compartments and services around Toddington
Nine care or nursing homes sit less than 2 miles from Toddington. In a care home, any new pipe or cable through a fire-resisting wall should be sealed to the specified detail. We install fire-rated sealant to the tested detail where it is specified. The area within 2 miles of Toddington holds a number of hotels. Hotels are divided into compartments, and refurbishments that add pipes and cables through bedroom and corridor walls leave gaps to close.
In a building such as All Saints, any service penetration through a fire-resisting wall should be sealed to the specified detail. Hotels such as Victoria Hotel, 1.1 miles to the south of Toddington, rely on fire-resisting walls between bedrooms and corridors, and refits that add services leave penetrations to seal where fire-rated sealant is specified.
Toddington is about 1 mile north of Littlehampton, in West Sussex. We send applicators to Toddington for service penetrations. Across West Sussex, 373 places are covered, including Toddington. Our Brighton page has more on work in that area (18 miles or so).
We cover the BN17 postcode districts for service penetrations. If your site is on Toddington Lane, Hide Close and Hollist Chase or close by, we can quote for service penetrations. We also cover Lyminster (1 mile north-west), Wick (1 mile west), Littlehampton (1 mile south), Poling (1 mile north-east) and Rustington (1 mile south-east) for service penetrations. A short drive away, we cover Worthing (6 miles east), Bognor Regis (7 miles west), Chichester (11 miles west), Selsey (13 miles south-west), Shoreham-by-Sea (12 miles east) and Lancing (9 miles east).
Local landmarks in Toddington
Recent enquiries here include premises near Littlehampton College, Mewsbrook Park and Locomotive Public House. The nearest railway station is Littlehampton station, roughly 1.1 miles south-west. Other landmarks nearby include Zachary Merton Hospital (1.8 miles south-east) and Rustington Museum (1.6 miles south-east). Green spaces nearby include WWT Arundel and Highdown Hill.
When it isn’t the sealant
Sealant solves a lot, but not everything, and we’d rather tell you before you spend money. These need a different solution:
- Designing or specifying fire stopping, which sits with the designer or fire engineer
- Gaps in walls that were never built as compartment walls
- Fire doors, dampers or other fire safety equipment
If in doubt, ring 01277 525 020 or send photos by email and we will say what we think before you book.
Joints and surfaces we work on
- Pipe penetrations
- Joints between fire-resisting walls and floors
- Small duct penetrations where the tested detail allows
- Linear gaps at wall heads
- Cable penetrations
- Service gaps in risers
What we’re called out for in Toddington
Damage plays a part too. Seals get knocked during maintenance, cut back to add a cable or pulled out when services are swapped.
If one of these sounds familiar, it’s time for a closer look:
- Fire-stopping items raised at inspection or handover
- Unsealed joints where partitions meet the slab
- Fire sealant pulled out of the opening
- Fire seals cut back for extra cables and never reinstated
For a school such as Lyminster Primary School, penetration sealing fits best at the end of the summer works.
What your quote should include
- Their plan for phasing and protecting the area
- Health and safety accreditation such as CHAS
- The named product and why it was chosen
- What the guarantee covers, and for how long