Fire stopping in Ticehurst
Fire-rated and intumescent sealing of service penetrations and linear gaps throughout Ticehurst and nearby, by CSCS-carded applicators. CHAS accredited and fully insured.
- Open linear gaps along the top of fire-resisting walls
- Snag lists that include open service penetrations
- Fire-rated sealant that has cracked or shrunk back
Fire stopping across Ticehurst
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Fire stopping for commercial buildings in Ticehurst
Every service that crosses a compartment wall or floor leaves an opening, and that opening needs sealing to hold back fire and smoke. Our job is fitting fire-rated and intumescent sealant at those service penetrations, and along linear gaps, where it is the specified product. Each seal follows the manufacturer’s tested detail rather than guesswork. Site teams most often ask us about improvised or mixed-product fire seals and expanding foam used as fire stopping, on pipe penetrations, service gaps in risers and linear gaps at wall heads. Whether you call it commercial sealant work, mastic application or joint sealing, in Ticehurst it comes down to the same thing: failed joints cut out, faces prepared and the right sealant laid to the right depth.
For a smaller site near Ticehurst, we plan to do all the penetrations in one go, so send the specification and photographs first. We install to the specification and the manufacturer’s guidance, leaving design and sign-off with the designer and building control.
We sign every job off with a 12-month guarantee. It’s a plain promise: if the work we did fails within twelve months, we return to fix it.
- Place
- Ticehurst (TN5)
- Wider area
- East Sussex
- Guarantee
- 12 months on our workmanship
- Price
- Quoted before any work starts
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Surface by surface
Linear joints
Head-of-wall gaps, slab edges and wall junctions are linear joints. BS EN 1366-4 testing sets the joint widths, depths, backing and movement a seal covers and the installation has to fit inside those limits.
Small ducts
Small ductwork can sometimes be sealed with sealant where the tested detail includes it. Bigger ducts and fire-resisting ductwork are normally handled with other products.
Our process
Our CSCS-carded applicators arrive with the sealants, primers and backing rod the job calls for. Joint faces are cleaned back to sound, dry surfaces, primer goes on where the manufacturer specifies it, and the sealant is tooled off neatly. For work around Ticehurst, we aim to finish in one visit, so we ask for photos and rough sizes first. That way the right products come on the day.
- We start with your penetration schedule, drawings or specification.
- Access, permits and the order of areas are agreed with the site team.
- Each opening is checked for wall or floor type, service, gap and depth.
- Foam, ordinary sealant and debris come out.
- The specified backing and sealant go in to depth and are finished neatly.
- We tell you about openings that need a different product.
What we need from you
- Share your working hours and any access restrictions
- Flag any permit to work we’ll need
- Point out any areas we must not close
Quotes
Let us know the site, the scope and your timescale, and we’ll put a fixed quote together. To get it moving, ring 01277 525 020 or send details through our quote form.
Related advice
Your questions answered
How does the move away from BS 476 affect penetration seals in Ticehurst?
From 2 September 2029, Approved Document B drops its BS 476 references in favour of BS EN 13501-2 classification, with transitional arrangements. The designer or fire engineer sets the specification, and we install the product to the manufacturer’s tested detail.
Would you work within a site like Ticehurst House Hospital?
Yes. Healthcare sites are among the places we work. The estates team’s permit system and infection-control rules come first, and the work is planned around them.
Are your applicators CSCS-carded?
Yes. If you need card details for site access, let us know and we’ll send them with the quote.
Do you hold CHAS accreditation?
Yes. We are CHAS accredited, we’re a Constructionline member and we use CSCS-carded applicators.
Do you need to see the site first?
Many jobs can be quoted from photographs, drawings or a joint schedule. Where they aren’t, we arrange a site visit before quoting.
Is any job too small?
Whatever the size, the process is the same: details, then a fixed price, then sealing, then a 12-month guarantee.
What hours do you work?
The office is staffed Monday to Friday, from 8am until 5pm. Tell us your site hours and access windows and the work will be fitted around them.
Towns and villages near Ticehurst
Also in Ticehurst
Why deal with it now?
Sealing behind the M&E trades area by area beats a sweep at the end. While the area is still open, every opening is easy to see and reach. Halls, stores and units around places like Ticehurst may not be checked every day, which gives a failed joint time to do damage. Resealing early avoids that.
Whether it’s a single area or a whole estate, the same things set the price: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote and we will put a fixed figure on it.
What you get with us
- One phone line for London, the South East and Scotland
- CSCS-carded applicators
- Failed material removed, not covered up
- Commercial sealant work since 2005
Take a look at our cost guide or our accreditations and insurance.
Owners, agents and contractors
Blocks and communal areas make up much of the work for housing associations and agents. We phase the work so people keep access, and each stage is agreed with your contact.
Building owners and managing agents use us on everything from one building to a spread of sites. Several sites can go on one quote, so there’s one set of paperwork to deal with.
Cost factors for service penetrations
Sealant work doesn’t have a standard rate, since sites vary so much. What we look at:
- Site requirements such as inductions and permits
- Phasing around occupants
- Any access equipment needed
- Whether old sealant has to be cut out first
A quote for service penetrations depends on how many there are, their condition and the access, and any specification that applies. Ask us for a fixed quote.
Sending details for a quote
It doesn’t need to be a full survey. A few details are enough to get going:
- Whether the building will be occupied during the work
- The site address and postcode
- The product your specification calls for
- Photos of the joints, close up and from further back
Pricing a project or setting a maintenance budget? We’ll quote against your scope and drawings that you can work with. If you have questions first, give us a call on 01277 525 020 or use the quote form.
Penetration seals near Ticehurst
Approved Document B is the English guidance that covers fire stopping around openings and penetrations. Its BS 476 references are being withdrawn from 2 September 2029, with BS EN 13501-2 classification taking over, subject to transitional arrangements. Either way, we install the specified product to its tested detail. Ticehurst is about 38 miles from central London. Tenant changes on commuter-belt business parks mean regular fit-outs, and new services through compartment walls; the gaps need the specified seal.
In a hotel such as The Bell Hotel, which lies west of Ticehurst, new pipework or cabling through bedroom and corridor walls needs sealing with the specified product. For a hospital such as Ticehurst House Hospital, 0.6 miles west of Ticehurst, penetration sealing is typically phased ward by ward, with infection-control rules agreed first. Older community buildings such as St Mary's Church that have been rewired or given new heating can have service gaps through walls worth checking against the specification.
Ticehurst is about 9 miles south-east of Royal Tunbridge Wells, in East Sussex. Anywhere in TN5, it works the same way: send details, get a fixed quote, we seal, and the work is guaranteed. Ticehurst is one of 308 places in East Sussex on our list for service penetrations. Sites around Brighton have their own page, roughly 28 miles from Ticehurst.
If you need fire stopping in TN5, the process matches everywhere else we work: details, then a fixed price, then sealing and a 12-month guarantee. Among the streets we cover are High Street, Springfields and Farthing Hill, and sites on any of them can send details for a fixed quote. Sites close to Ticehurst are covered too, including Three Leg Cross (1 mile north-west), Flimwell (2 miles east), Stonecrouch (2 miles north), Burgh Hill (3 miles south-east) and Etchingham (3 miles south-east). Further afield, our area takes in Hastings (14 miles south-east), Bexhill-on-Sea (14 miles south), Hailsham (14 miles south-west), Crowborough (11 miles west), St Leonards (15 miles south-east) and Uckfield (14 miles west).
What’s near Ticehurst
In Ticehurst, that means premises near The Chequers Public House and the streets around them. The closest station to Ticehurst is Stonegate station, roughly 2.7 miles south-west. A little further out are Finchcocks Musical Museum (4 miles north) and Ticehurst House Hospital (0.6 miles west). Green spaces nearby include Bewl Water.
General trades versus a specialist
Certain joints really need a specialist: fire-rated seals that must follow a tested detail, trafficked floor joints and external movement joints among them. A poor seal in places like these tends to cost more to put right later.
General builders and handymen seal joints, but it isn’t their main trade. A specialist prepares properly, controls joint depth and picks a product with the right movement class, which is what makes a joint last.