Throwley Forstal fire stopping
Sealant work in Throwley Forstal for main contractors, managing agents and facilities managers: fire-rated and intumescent sealing of service penetrations and linear gaps, quoted at a fixed price.
- Hidden openings found during inspections
- Fire-rated sealant that has cracked or shrunk back
- Seals disturbed by maintenance and left open
Fire stopping for Throwley Forstal sites
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Fire stopping in Throwley Forstal
A lot of fire-stopping work comes after M&E installation, a refit or a tenant fit-out. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind. We close the openings listed on your schedule, using the specified sealant and detail. Site teams most often ask us about unsealed joints where partitions meet the slab and expanding foam used as fire stopping, on cable penetrations, pipe penetrations and small duct penetrations where the tested detail allows. Sealant applicators who only do sealant are a different proposition from a general trade with a gun in the van: in Throwley Forstal, that means joint design, primers and backing rod as standard.
Barn and farm-building conversions near places like Throwley Forstal often combine new partitions with old walls. Where a pipe or cable passes through a fire-resisting wall, the seal must match the tested detail: product, substrate, gap and depth.
Every job ends the same way: guaranteed. Our workmanship is backed for 12 months, and we explain exactly what that covers when we quote.
- Place
- Throwley Forstal (ME13)
- Wider area
- Kent
- Guarantee
- 12 months on our workmanship
- Quote
- Quoted before any work starts
- Telephone
- 01277 525 020
- Last updated
- 3 November 2026
Questions about Throwley Forstal
What happens to BS 476 references for fire stopping in Throwley Forstal?
From 2 September 2029, Approved Document B drops its BS 476 references in favour of BS EN 13501-2 classification, with transitional arrangements. Our part doesn’t change: the specified product, to its tested detail.
Can you produce the fire-stopping design for a job in Throwley Forstal?
No. The designer or fire engineer sets the detail and building control accepts it. We install what’s specified, to the product’s tested detail.
How do we ask for a quote?
The quote form is the simplest route, though you can also give us a call on 01277 525 020 or use the quote form. Include photographs or drawings if you have them.
How long does a job like this take?
The duration is planned around your programme and the access we are given. We will give you an estimate of time on site when we quote.
Is Throwley Forstal in your area?
Yes. We cover Throwley Forstal and the rest of Kent, within our coverage of Greater London, South East England and Scotland. To discuss a job, phone 01277 525 020 or email the details over.
Do you take on small jobs?
Whatever the size, the process is the same: send details, get a fixed quote, we seal, guaranteed.
Is the work guaranteed?
Yes. The 12-month guarantee covers our preparation and application, but not damage, misuse or other trades’ work.
Cost factors for service penetrations
Each job is priced on its own details. The things that drive the figure:
- The site’s rules and procedures
- Access and working height
- Specialist products, such as fire-rated or hygienic sealants
- How much existing material needs removing
Cost follows what’s involved: stripping out, preparation, sealing, access and phasing. Call for a fixed quote.
What we need to price the job
For an accurate fixed quote, we need a clear picture of the site. Send us:
- The postcode of the building
- Any specification or named product
- Any dates the work must fit around
- Drawings or a marked-up plan, if available
If there’s a specification, drawings or a tender package, send it with your enquiry, and we’ll price against exactly what is specified. For smaller jobs, photos and a description will do.
Signs you need fire stopping in Throwley Forstal
Some seals fail because the wrong product went in: expanding foam or a general-purpose sealant pushed into a gap to tidy it. It may look closed, but it has no tested fire performance in that position and has to be removed.
What tends to prompt an enquiry:
- Fire stopping installed outside its tested range
- Old intumescent sealant that has split away
- Penetration schedules that need working through
- Open linear gaps along the top of fire-resisting walls
Around Throwley Forstal, we install fire-rated and intumescent sealant to the product’s tested detail wherever it is the specified product.
What to look for in a quote
- Who will actually carry out the work
- How they handle RAMS and site documents
- Their plan for phasing and protecting the area
- Is depth set with backing rod, or bond-breaker tape in shallow joints?
Compartment walls and floors in Throwley Forstal
At about 44 miles from central London, Throwley Forstal is within reach of the capital. Office refits around the commuter belt bring new cabling through fire-resisting walls. In England, Approved Document B covers fire stopping of openings and penetrations. References to the older BS 476 classes are being removed from it from 2 September 2029, after which the European classification, BS EN 13501-2, is the route, subject to transitional arrangements. What we install is set by the specification, and it goes in to the tested detail.
In a building such as Church of St Michael and All Angels, any service penetration through a fire-resisting wall should be sealed to the specified detail.
Throwley Forstal is about 4 miles south of Faversham, in Kent. If you are looking for fire stopping in Throwley Forstal, we can help, as we do across Kent. Across Kent, 931 places are covered, Throwley Forstal among them. London is covered too, around 44 miles from Throwley Forstal.
Anyone looking for fire stopping in ME13 gets the same process as the rest of our area: send details, get a quote, we seal, guaranteed. Close to Throwley Forstal, our area also takes in Throwley (1 mile north), Badlesmere (1 mile east), Sheldwich (2 miles north-east), Sheldwich Lees (2 miles north-east) and The Valley (2 miles west). Further afield, our area takes in Maidstone (14 miles west), Ashford (8 miles south), Canterbury (10 miles east), Sittingbourne (8 miles north-west), Whitstable (10 miles north-east) and Faversham (4 miles north).
Local landmarks in Throwley Forstal
For rail, the closest station is Selling station, roughly 4.1 miles east of the centre. Well-known places in the area include Newnham Castle (3 miles north-west).
Site staff or a sealant specialist?
The visible bead is only part of the job. Correct depth, the right primer and a sealant matched to the movement are where general trades tend to cut corners.
Some joints are best left to specialists: fire-rated seals that must follow a tested detail, trafficked floor joints and external movement joints among them. Getting these wrong normally costs more in the end than doing them right.
Our process
On arrival, we sign in, go through any site induction and check how permits are handled. Floors, finishes and fittings next to the joints are covered before anything is cut or cleaned, with the work itself usually taking a single visit for a short list of penetrations, or a phased programme for a whole building. Rural sites near Throwley Forstal may need directions, gate codes or a contact on site. Add it to your enquiry and we’ll build it into the plan.
- First we go through the drawings, schedule or specification for the seals.
- On site, each opening is checked against the tested detail it is meant to follow.
- Unsuitable fillers and loose debris are taken out of each opening.
- We fit the backing the detail asks for, to the stated depth.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- If an opening needs something other than sealant, we tell you instead of improvising.
Preparing the site
- Point out any areas we must not close
- Send any specification or drawings in advance
- Send your site hours and access windows
Quotes
To get a fixed quote, give us a call on 01277 525 020 or send photos by email, telling us the site location and the nature of the job. You can also send details through our quote form.
Advice
Why act early in Throwley Forstal
Open penetrations multiply: each new service adds to the list. A schedule that is dealt with regularly stays manageable, rather than turning into a full building survey and reseal. Older rural buildings around Throwley Forstal move with the seasons, and rigid or tired sealant can’t keep up. The right product, sized to the joint, copes much better.
Pricing service penetrations depends on how many there are, their condition and the access. Ask us for a fixed quote.
Why appoint us
- A fixed quote before work starts
- Commercial sealant work since 2005
- Work carried out by CSCS-carded applicators
- A Constructionline member, so easy to vet
Read our cost guide and our accreditations.
Towns and villages near Throwley Forstal
What else we do in Throwley Forstal
What we can’t put right
We check first that sealant really is the fix. It won’t put right:
- Designing or specifying fire stopping, which sits with the designer or fire engineer
- Gaps in walls that were never built as compartment walls
- Fire doors, dampers or other fire safety equipment
Not sure which it is? You can phone 01277 525 020 or use the quote form and we will tell you honestly before you book.
Surfaces we seal
- Cable penetrations
- Joints between fire-resisting walls and floors
- Linear gaps at wall heads
- Service gaps in risers
- Pipe penetrations
- Small duct penetrations where the tested detail allows