Fire-rated sealing and fire stopping in Newbigging, Fife
Fire-rated and intumescent sealing of service penetrations and linear gaps throughout Newbigging and nearby, by CSCS-carded applicators. Fully insured and CHAS accredited.
- Fire sealant pulled out of the opening
- Open linear gaps along the top of fire-resisting walls
- Snag lists that include open service penetrations
Fire stopping in Newbigging
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Owners, agents and contractors
Agents, factors and owners’ representatives all follow the same route: send the details, accept a fixed quote, and we carry out and guarantee the work. Keys, access and contacts can be agreed in advance.
For main contractors, we work as the sealant subcontractor, on new build and refurbishment alike. We work to your programme, your specification and your site rules.
Fire stopping in Newbigging
Opened ceilings and riser doors often reveal service openings nobody sealed. If a specification already covers those walls and floors, we can reseal to it, matching the product and detail it names. Where there isn’t one, the designer or fire engineer needs to set one first. Most enquiries involve open linear gaps along the top of fire-resisting walls and unsealed penetrations discovered above suspended ceilings, on service gaps in risers, pipe penetrations and joints between fire-resisting walls and floors. A specialist sealant contractor works differently from a general builder: on jobs in Newbigging, preparation and product choice get the time they need.
Refurbishments in small hotels, schools and care homes around places like Newbigging can leave gaps around new services. We fit the specified fire-rated sealant as its published detail shows and raise it if another product is needed.
The 12-month guarantee covers our workmanship: preparation, application and finish. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Location
- Newbigging (KY2)
- Wider area
- Fife
- Guarantee
- 12 months on every job
- Quote
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Do you need fire stopping in Newbigging?
Most open service penetrations are left by later work. A new cable pulled by an electrician, a pipe rerouted by a plumber or a data run drilled through a riser can leave the hole behind. Across several fit-outs, the openings add up.
Most enquiries start with something like this:
- Seals disturbed by maintenance and left open
- Service penetrations left open after M&E works
- Builders’ foam or ordinary silicone in compartment walls
- Seals that don’t match their tested detail
Residences at universities like University of Dundee - Fife Campus (to the east of Newbigging) have compartment walls that must be resealed whenever services change.
Comparing quotes
- Which product they’ll use, and why it suits the joint
- Their plan for phasing and protecting the area
- How the existing material will be dealt with
- How they handle RAMS and site documents
Service penetrations in Newbigging buildings
Scottish guidance (non-domestic Technical Handbook, clause 2.1.14) asks that penetrations match at least the fire resistance period of the element they pass through, with proprietary products, intumescent ones included, tested for their end use. We install fire-rated sealant to that tested detail where it is specified.
Wherever services are added at a hospital such as Victoria Hospital, 4 miles north-east of Newbigging, the compartment line has to be made good with the specified product. Industrial units on estates such as Lochiew Industrial Estate, 2.1 miles to the north-west of Newbigging, often separate offices from warehouse space with fire-resisting walls, and new services through them need the specified seal.
Newbigging is about 4 miles south-west of Kirkcaldy, in Fife. If you’re looking for fire stopping in Newbigging, we can help, as we do across Fife. 132 places across Fife fall within our area, Newbigging among them. Edinburgh is covered too, some 11 miles away.
We take on service penetrations across the KY2 postcode area, for business premises of every kind. We also cover Auchtertool (1 mile west), Dundonald (3 miles north), Cardenden (3 miles north), Bowhill (3 miles north) and Auchterderran (3 miles north) for service penetrations. Further afield, our area takes in Dunfermline (7 miles west), Kirkcaldy (4 miles north-east), Glenrothes (7 miles north-east), Leven (12 miles north-east), Cowdenbeath (4 miles west) and Dysart (5 miles east).
Landmarks near Newbigging
The closest station to Newbigging is Cardenden station, about 2.7 miles north. Nearby you will also find Hallyards Palace (0.7 miles north-west) and Victoria Hospital (4 miles north-east). For a walk, there’s Camilla Loch.
When to bring in a specialist
Using site staff can make sense for a small touch-up, but anything bigger is another matter: a specialist brings efficiency, a consistent finish and a 12-month guarantee.
Certain joints really need a specialist: fire-rated seals that must follow a tested detail, trafficked floor joints and external movement joints among them. A poor seal in places like these tends to cost more to put right later.
Nearby places to Newbigging
Also in Newbigging
FAQs: Newbigging
Is Newbigging off your patch?
Not at all: smaller places are covered as well as towns. We cover the whole of Scotland. We plan jobs in smaller places so return trips are kept to a minimum.
How do Scotland’s building standards affect fire-rated sealant in Newbigging?
Scotland’s non-domestic Technical Handbook covers it in clause 2.1.14: penetrations keep at least the element’s fire resistance duration, with products tested for their end use. We install what has been specified, to the manufacturer’s tested detail, while design and approval sit with the designer and the verifier.
Are you CHAS accredited?
Yes. Mastic Doctor is CHAS accredited and a Constructionline member, which helps with supplier vetting.
What if there’s asbestos in the old mastic?
Asbestos is possible in some older mastics, particularly in buildings from before 2000. Before we disturb old sealant in an older building, we ask to see the asbestos register or survey, and work stops until any suspect material has been tested. We don’t remove asbestos-containing materials.
Can you fit around our working hours?
The office is staffed Monday to Friday, from 8am until 5pm. Let us know your site hours and access windows, and the work will be planned around them.
Do you work to architects’ specifications?
Yes. Send it with your enquiry, and we will price the work to it, flagging anything that needs clarifying.
Is it fine to apply new sealant on top of old?
No. We cut the old material out and clean the joint back before sealing, because fresh silicone will not bond with aged silicone.
What sealant work can’t fix
Not every problem is a sealant problem, and we’d rather tell you before you spend money. These need a different solution:
- Walls or floors that aren’t fire-resisting to begin with
- Fire doors, dampers or other fire safety equipment
- Large openings beyond what any sealant detail covers
Not sure which it is? You can call the office on 01277 525 020 or email the details over and we’ll tell you honestly before you book.
What we seal
- Joints between fire-resisting walls and floors
- Pipe penetrations
- Service gaps in risers
- Small duct penetrations where the tested detail allows
- Linear gaps at wall heads
- Cable penetrations
Diagnose, treat, sign off
At the end of each section, we remove the tape, clean down and inspect every joint with your site contact. If an area should be left alone while the sealant cures, we say how long and put signs out. For a building near Newbigging, directions, keys and a contact on the day are worth sorting early. That goes into the plan alongside the quote.
- We start with your penetration schedule, drawings or specification.
- We plan the sequence of floors, risers and voids with you.
- We compare every service penetration with its tested detail before sealing.
- Foam, ordinary sealant and debris come out first.
- The specified backing and sealant go in to depth and are finished neatly.
- Anything outside the detail is reported to you rather than sealed.
Getting the site ready
- Flag any permit to work we’ll need
- Explain the parking and delivery arrangements
- Make sure the joints can be reached
Get a fixed quote
We quote a fixed sum against the scope you give us, so the cost is agreed before work starts. To start the process, speak to us on 01277 525 020 or email a schedule or drawings.
Related advice
Quoting for work in Newbigging
These are the things that shape the price:
- How accessible the joints are
- The total length or number of joints
- Distance, for remote addresses
- The site’s rules and procedures
What a job costs comes down to how many linear metres there are, how much old material needs removing and the access. Call for a fixed quote once you have the details.
What we need to price the job
A good diagnosis starts with the right details. Let us know:
- The product your specification calls for
- Whether the building will be occupied during the work
- How the joints are reached, and at what height
- Your programme or deadline
A handful of photographs and a postcode is the fastest way to a quote. Send them through the quote form, or speak to us on 01277 525 020 or use the quote form to discuss it first.