Meigle fire stopping
Looking for fire stopping in Meigle? Send us the details for a fixed quote, backed by a 12-month guarantee on the work.
- Unsealed openings around new pipes and cables
- Fire stopping installed outside its tested range
- Unsealed penetrations discovered above suspended ceilings
Fire stopping in Meigle
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Fire stopping in Meigle
It helps to set out our role at the start. Deciding the specification sits with the designer, the fire engineer and building control; sign-off sits with them too. We fit the specified fire-rated sealant following that specification and the maker’s installation guidance on sites in Meigle. We work on cable penetrations, service gaps in risers and small duct penetrations where the tested detail allows, and the failures we are asked to look at most are seals that don’t match their tested detail and hidden openings found during inspections. Facilities teams, main contractors and managing agents in Meigle tend to want the same three things: a clear scope, tidy work and joints that don’t fail again.
Hotels and care homes around smaller places like Meigle often have services added during refurbishment. We fit the specified fire-rated sealant as its published detail shows and raise it if another product is needed.
We stand by our work: 12 months, guaranteed. That covers our preparation and application, and if something we did falls short, we return to it.
- Where
- Meigle (PH12)
- Region
- Perth and Kinross
- Cover
- A 12-month guarantee
- Quote
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Maintenance after handover
A few simple habits keep the new joints working:
- Settle who seals which penetrations at the start of a project
- Foam or ordinary sealant is never a fire-seal repair
- Leave fire sealant to cure fully before covering it
- Look above ceilings when tiles are lifted for other jobs
New services after handover are a common way fire stopping gets breached. Building it into each contractor’s sign-off keeps the walls intact.
The simplest way to keep compartment walls intact is to plan fire stopping into every job that crosses them. That way the opening is sealed while the trade and access are still there instead of being left for someone else.
What we’re called out for in Meigle
Linear gaps fail where a fire-resisting wall meets a slab, soffit or another wall. Deflection and building movement can open these gaps, and a product not tested for that movement may crack. Linear joint details set a width range and movement capability, and the seal has to sit within them.
Typical triggers for a call:
- Improvised or mixed-product fire seals
- Fire sealant pulled out of the opening
- Openings found when ceilings come down for a refit
- Open linear gaps along the top of fire-resisting walls
In a building such as Meigle Parish Church, any service penetration through a fire-resisting wall should be sealed to the specified detail.
What your quote should include
- Will CSCS-carded applicators be on site?
- Whether old or failed sealant will be cut out, not overlaid
- How they’ll work around occupants
- Will RAMS and insurance details be available?
Where services cross fire walls in Meigle
Under the Scottish non-domestic Technical Handbook, clause 2.1.14, penetrations should be fire stopped to at least the wall or floor’s fire resistance duration, with proprietary products, intumescent ones included, tested for their end use. Where fire-rated sealant is specified, that’s what we install, to the tested detail.
Hotels like Kinloch Arms Hotel (to the north of Meigle) are refurbished in phases, and each phase can open up compartment walls.
Meigle is about 7 miles east of Blairgowrie and Rattray, in Perth and Kinross. Looking for fire stopping in Meigle? We can help. We work across 114 places in Perth and Kinross. There’s a separate page for Dundee, about 11 miles away.
We cover the PH12 postcode districts. Streets here include Strathmore Place, Ardler Road and Kirkhill Road, and sites on any of them can send details for a fixed quote. Meigle sits on or close to the B954, useful when we plan access and materials. Close to Meigle, our area also takes in Ardler (2 miles south-west), Newtyle (2 miles south), New Alyth (3 miles north-west), Alyth (4 miles north-west) and Airlie (4 miles north-east). Bigger towns within reach include Blairgowrie and Rattray (7 miles west), Scone (15 miles south-west), Rattray (6 miles west), Stanley (13 miles south-west), Errol (14 miles south) and Luncarty (15 miles south-west).
Local landmarks in Meigle
Nearby you’ll also find Belmont Castle (less than half a mile south) and Meigle Sculptured Stone Museum (under half a mile east). Open spaces near Meigle include Long Loch and Hatton Hill.
On site: what to expect
A typical day starts with protection: masking tape along the joint edges and sheeting over anything nearby. On site, the work normally takes longer where risers, ceiling voids or occupied floors have to be worked through in sequence, and we clear our waste as we work. Where we can, we combine work around Meigle with other jobs nearby. Let us know if your dates have any give.
- First we confirm the product and tested details named in the specification.
- Openings are measured and grouped by detail.
- Old or wrong materials are cut out.
- Where the detail needs backing, it goes in at the stated depth.
- We gun the sealant in to the specified depth around each service and tool it.
- We walk the completed areas with you and confirm the records agreed at quote stage.
What we need from you
- Send asbestos survey details if the building is pre-2000
- Confirm the product named in the specification
- Point out parking and an unloading spot
Get a fixed quote
We quote a fixed sum against the scope you give us, so you know the figure before anyone is on site. To ask for one, ring 01277 525 020 or send details through our quote form.
Advice
FAQs: Meigle
What do Scotland’s building standards say about service penetrations in Meigle?
The non-domestic Technical Handbook, clause 2.1.14, expects a penetration to keep at least the wall or floor’s fire resistance period, with proprietary products tested for the use they’re put to. The detail is set by the designer and goes through the warrant process; we install the specified product to its tested detail.
Is a smaller place like Meigle outside your area?
Not at all: smaller places are covered as well as towns. Every Scottish council area is within our area. Send photos and a list of what needs doing, and we will plan the job to need as few trips as possible.
When can you be on site?
Give us your site hours and any access windows in your enquiry, and we’ll plan around them. You can reach the office between 8am and 5pm, Monday to Friday.
Are you CHAS accredited and on Constructionline?
Yes. We are CHAS accredited and a Constructionline member, which helps with supplier vetting.
Will you come and look before quoting?
Photos, drawings or a schedule are often enough to quote. Where they aren’t, we arrange a site visit before quoting.
What’s the quickest route to a quote?
There are four steps: send details, get a quote, we seal, guaranteed. The first step only needs photographs and a postcode.
What if there’s asbestos in the old mastic?
Asbestos is possible in some older mastics, particularly in buildings from before 2000. We check the asbestos register before cutting out old sealant in an older building, and work stops until any suspect material has been tested. We don’t remove asbestos-containing materials.
Quoting for work in Meigle
Sealant work doesn’t have a standard rate, since sites vary so much. What we take into account:
- Distance, for remote addresses
- Whether old sealant has to be cut out first
- The site’s rules and procedures
- The product specified
Every site prices differently: the joint sizes, the specified product, access and working hours each have a bearing. A fixed quote follows once we understand the job.
What to include in your enquiry
For an accurate fixed quote, we need a clear picture of the site. Useful things to include:
- The site address and postcode
- A wide shot and a close-up of the area
- Asbestos survey details if the building is older
- When you need the work done
Specifications, drawings and tender packages are welcome with any enquiry, and we’ll price the work to it. For smaller jobs, photos and a description will do.
Leave it or put it right?
Sealing behind the M&E trades area by area beats a sweep at the end. Openings are visible, access is open and nothing has to be taken down and each detail can be checked as we go. Buildings that aren’t in daily use, such as halls and seasonal premises, may let water in unnoticed, giving water time to get in. Early resealing prevents it.
Quantities, awkward access and phased working all shape the price. Site requirements like inductions and permits play a part as well, along with the time of year for external work.
Why us?
- Constructionline member
- CSCS-carded applicators
- One number for every site we cover
- 12-month guarantee on workmanship
Commercial clients in Meigle
Hospitality, education, healthcare, office and retail clients come to us directly as well. We plan around the way the building is used, so the building keeps working while we do.
Building owners and managing agents use us on sealant work across single buildings or whole portfolios. One quote can cover more than one site, so there’s one set of paperwork to deal with.