Fire-rated sealing and fire stopping in Maybush, Southampton
Fire stopping in Maybush, backed by over 20 years in commercial sealing. Fully insured, with a 12-month guarantee.
- Penetration schedules that need working through
- Fire-rated sealant that has cracked or shrunk back
- Open linear gaps along the top of fire-resisting walls
Fire stopping near Maybush
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Fire stopping in Maybush
A fire-rated sealant is only one part of a tested system: the evidence covers a specific product, wall or floor type, service, gap, depth and backing. We match each opening to that detail before any sealant goes in, and raise it with you if it falls outside. We work on cable penetrations, joints between fire-resisting walls and floors and linear gaps at wall heads, and the failures we’re asked to look at most are hidden openings found during inspections and open linear gaps along the top of fire-resisting walls. Sealant contractors, mastic applicators, sealant specialists: whatever the job title on the order, in Maybush it comes down to the same thing: the right product in a properly prepared joint.
Around Maybush, penetration and linear seals tend to be one-building jobs. With the specification and photographs of the gaps, we can give a fixed quote and bring the right products.
What our 12-month guarantee covers is the way we did the job: the preparation, the sealing and the tooling. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Place
- Maybush (SO16, SO15)
- Region
- Southampton
- Guarantee
- 12 months on our workmanship
- Price
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Last updated
- 3 November 2026
Commercial clients in Maybush
We take on planned maintenance as well as one-off repairs: working through a building or an estate in stages that fit your budget. Maybush can form part of a wider programme across Southampton.
We work for building owners and managing agents on sealant work across single buildings or whole portfolios. One quote can cover more than one site, which keeps the paperwork simple.
Signs you need fire stopping in Maybush
When a seal departs from its tested detail, the evidence no longer covers it. An oversized gap, too shallow a bead, missing backing or two makers’ products combined are what we find most often.
What tends to prompt an enquiry:
- Service penetrations left open after M&E works
- Fire-rated sealant that has cracked or shrunk back
- Non-fire-rated filler around services
- Penetration schedules that need working through
Hotels such as Anchor Hotel, 1.2 miles south-west of Maybush, rely on fire-resisting walls between bedrooms and corridors, and refits that add services leave penetrations to seal where fire-rated sealant is specified.
Questions to ask before you book
- Which product they’ll use, and why it suits the joint
- How joint depth will be controlled
- What site paperwork they can supply
- Whether their applicators hold CSCS cards
Nearby places to Maybush
What else we do in Maybush
Your questions answered
What does the BS 476 change mean for fire-rated sealant in Maybush?
References to BS 476 classes are being removed from Approved Document B from 2 September 2029, after which BS EN 13501-2 classification is the route, subject to transitional arrangements. Whichever applies, we install the specified product to its tested detail; the specification is for the designer to set.
Could you schedule work at a campus like University of Southampton for the vacation?
Yes. We plan campus work around teaching, exams and residence turnarounds. We are CHAS accredited and a Constructionline member, and paperwork such as RAMS is confirmed with the quote.
What hours do you work?
Give us your site hours and any access windows in your enquiry, and we will plan around them. Our office runs Monday to Friday, 8am until 5pm.
What happens if old sealant might contain asbestos?
Managing asbestos is the dutyholder’s responsibility, so we’ll ask for the register before work on an older building. Work pauses if suspect material is found, until it has been tested.
Can one quote cover more than one building?
Yes. Several buildings can share a single quote, and you deal with one contact throughout.
How long does a typical visit take?
We plan the time on site around your programme and access. We’ll give you an estimate of time on site when we quote.
How long before the joints can be used?
Curing time varies by product, and we confirm it on the day.
What affects the price in Maybush
Sealant work doesn’t have a standard rate, since sites vary so much. What we look at:
- Which sealant the job calls for
- Induction, permit and paperwork requirements
- How much existing material needs removing
- Any access equipment needed
Every site prices differently: joint size, product, access and site hours all play a part. Send the details and a fixed figure follows.
What to include in your enquiry
A few photographs plus some basic facts will normally do. Please tell us:
- The site address and postcode
- The asbestos register, for older buildings
- Rough lengths or quantities, or drawings if you have them
- Photos of the joints, close up and from further back
Send us photographs, drawings or a joint schedule and a fixed quote comes back to you. Where a site visit makes more sense, we will arrange one.
Surface by surface
Plastic pipes
In a fire, plastic pipework melts away and leaves an opening. Small sizes are sometimes covered by an intumescent sealant detail. We check the pipe material and diameter against the detail before we start.
Cables and cable bundles
New data and power cables are the most common breach we see. Openings around new cables are resealed to the detail, and any bundle too large for sealant alone is flagged.
What we can’t put right
Honesty saves time and money. Fresh joints won’t solve:
- Writing the fire-stopping specification
- Large openings beyond what any sealant detail covers
- Signing off or certifying a building’s fire stopping
If you’re not sure, just phone 01277 525 020 or email a schedule or drawings and we’ll give you a straight answer.
Surfaces we seal
- Service gaps in risers
- Linear gaps at wall heads
- Pipe penetrations
- Small duct penetrations where the tested detail allows
- Joints between fire-resisting walls and floors
- Cable penetrations
Compartment walls and floors in Maybush
The 2 miles around Maybush include three care or nursing homes. Care settings depend on compartmentation, so service penetrations made during maintenance or refurbishment need sealing with the specified product. Approved Document B is the English guidance that covers fire stopping around openings and penetrations. From 2 September 2029, BS 476 references are being taken out of Approved Document B, leaving BS EN 13501-2 classification as the route, subject to the Government’s transitional arrangements. We install whatever has been specified, to the product’s tested detail.
On a hospital site such as Western Community Hospital, which lies south of Maybush, fire-rated sealant goes in where the specification calls for it, with the work planned around the estates team’s permits. Residences at universities like University of Southampton, 2.2 miles to the east of Maybush, have compartment walls that must be resealed whenever services change.
Maybush is about 3 miles east of Totton, in Southampton. If you’re looking for fire stopping in Maybush, we can help. Maybush is one of 30 places in Southampton on our list.
If you need fire stopping in SO16 and SO15, the process matches everywhere else we work: send details, get a quote, we seal, guaranteed. Buildings on Link Road, Palm Road and Vine Road are within our area. Just outside Maybush, we also work in Coxford (1 mile north-east), Hillyfields (1 mile north-west), Regents Park (1 mile south-east), Shirley (1 mile south-east) and Millbrook (1 mile south). Nearby towns on our patch include Southampton (3 miles east), Midanbury (4 miles east), Thornhill (5 miles east), Harefield (5 miles east), Itchen (4 miles south-east) and Sholing (5 miles south-east). Maybush is one of the busier places in Southampton, and its commercial and public buildings are all within our area.
Landmarks near Maybush
Recent enquiries here include premises near St James' Park, Bridge Tavern and Regents Park Community College, among other places. The closest station to Maybush is Redbridge station, roughly 1.2 miles south-west of the centre. A little further out are Eling Experience (1.8 miles south-west) and Western Community Hospital (under half a mile south). The countryside around Maybush includes Testwood Lakes.
Our process
We schedule the visit to fit the site hours and access windows you give us. On the day, the work area is kept contained and tidy, and we check in with your contact before moving on to each new area. What matters most for a job in Maybush is a clear list of what needs doing, so send photos of each area. You’ll then get a fixed price for the work.
- We read the specification, drawings or penetration schedule you send.
- Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
- Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
- We fit the backing the detail asks for, to the stated depth.
- We apply the specified sealant to the depth and around the services as the detail shows.
- If an opening needs something other than sealant, we tell you instead of improvising.
What we need from you
- Agree which areas must stay open
- Tell staff and tenants when we’ll be in
- Tell us what induction or permit system the site runs
Request a quote
Tell us about the building, the joints and when you need the work done, and we will put a fixed quote together. The easiest way is to call the office on 01277 525 020 or send photos by email.