Fire-rated sealing and fire stopping in Markethill, Perth and Kinross
Fire-rated and intumescent sealing of service penetrations and linear gaps in Markethill. CHAS accredited and fully insured, with a 12-month guarantee.
- Fire-rated sealant that has cracked or shrunk back
- Open linear gaps along the top of fire-resisting walls
- Openings left by services added after handover
Fire stopping near Markethill
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Surface by surface
Risers and ceiling voids
Risers and ceiling voids hold most of a building’s service penetrations. Access is often tight, so we agree it with you in advance.
Masonry and concrete
Many seals are made in blockwork, brickwork or concrete slabs. Dust and debris are cleared from the opening, with backing added if the detail requires it.
Fire stopping in Markethill, done properly
It helps to set out our role at the start. The designer, fire engineer or building control decides which fire stopping is required; sign-off sits with them too. We fit the specified fire-rated sealant following that specification and the maker’s installation guidance on buildings around Markethill. If you have fire-rated sealant that has cracked or shrunk back and unsealed joints where partitions meet the slab, we can put it right, whatever the surface. Sealant contractors, mastic applicators, sealant specialists: whatever the job title on the order, the work in Markethill is the same: the right product in a properly prepared joint.
Hotels and care homes around smaller places like Markethill often have services added during refurbishment. A round of checks after M&E work is good practice, and any gaps found are sealed where fire-rated sealant is specified.
Every job we finish is backed by a 12-month workmanship guarantee. If a joint we sealed fails because of how it was installed, we come back and put it right.
- Where
- Markethill (PH13)
- Region
- Perth and Kinross
- Guarantee
- A 12-month guarantee
- Quotes
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Your questions answered
Is a smaller place like Markethill outside your area?
No. Small places get the same service as large ones. Every Scottish council area is within our area. Send photos and a list of what needs doing, and we will plan the job to need as few trips as possible.
Which Scottish guidance covers penetration seals in Markethill?
The non-domestic Technical Handbook, clause 2.1.14, expects a penetration to keep at least the wall or floor’s fire resistance period, with proprietary products tested for the use they’re put to. We install what has been specified, to the manufacturer’s tested detail, while design and approval sit with the designer and the verifier.
Is it fine to apply new sealant on top of old?
No. We cut the old material out and clean the joint back before sealing, since fresh sealant will not bond reliably to aged material.
Can you fit around our working hours?
We’re in the office from 8am until 5pm, Monday to Friday. Let us know your site hours and access windows, and the work will be planned around them.
Can you work to our specification?
Yes. The specification and the manufacturer’s installation guidance are what we work to, and we raise anything unclear before work begins.
Do you take on small jobs?
Small jobs are welcome alongside larger packages. Send details for a fixed quote.
Can one quote cover more than one building?
Yes. Multi-site work and planned programmes are a core part of the service, planned site by site to suit how each building is used.
Towns and villages near Markethill
What else we do in Markethill
How a job runs
A typical day starts with protection: masking tape along the joint edges and sheeting over anything nearby. The work itself typically takes a single visit for a short list of penetrations, or a phased programme for a whole building, and our waste is bagged and taken away as we go. For a building near Markethill, directions, keys and a contact on the day are worth sorting early. That goes into the plan alongside the quote.
- First we go through the drawings, schedule or specification for the seals and raise any questions before we price.
- Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
- Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
- Mineral wool or other backing goes in wherever the detail asks.
- We apply the specified sealant to the depth and around the services as the detail shows.
- Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.
Before we start on site
- Send any specification or drawings in advance
- Tell us what induction or permit system the site runs
- Make sure the joints can be reached
Ask for a quote
Send details, get a quote, we seal, guaranteed: that’s how every job runs. To take the first step, give us a call on 01277 525 020 or email drawings and photos.
Read more
Common problems we fix in Markethill
On a busy project, programme pressure can mean fire stopping is rushed or left to whichever trade is closest. That is when untested combinations creep in, which then have to be put right.
It’s worth sending us details if you spot any of the following:
- Fire sealant pulled out of the opening
- Improvised or mixed-product fire seals
- Expanding foam used as fire stopping
- Damaged fire seals in risers and voids
Older community buildings such as Abbey Church that have been rewired or given new heating can have service gaps through walls worth checking against the specification.
Comparing quotes
- How long is the guarantee, and what does it include?
- Whether primer will be used where the manufacturer specifies it
- Health and safety accreditation such as CHAS
- Which product they’ll use, and why it suits the joint
Where services cross fire walls in Markethill
Scotland has its own building standards: the non-domestic Technical Handbook (clause 2.1.14) says service penetrations should be fire stopped to at least the fire resistance duration of the wall or floor, with proprietary products, intumescent ones included, tested for their end use. Our part is installing the specified fire-rated sealant to its tested detail.
Hotels such as Strathmore Hotel, under half a mile north-west of Markethill, rely on fire-resisting walls between bedrooms and corridors, and refits that add services leave penetrations to seal where fire-rated sealant is specified. For a hospital such as Blairgowrie Community Hospital, 4.6 miles to the north-west of Markethill, penetration sealing is normally phased ward by ward, with infection-control rules agreed first.
Markethill is about 5 miles south-east of Blairgowrie and Rattray, in Perth and Kinross. Anywhere in PH13, it works the same way: details in, fixed quote out, then sealing and a 12-month guarantee. Our Perth and Kinross coverage takes in 114 places. Our Dundee page has more on work in that area, about 12 miles away.
Anyone looking for fire stopping in PH13 gets the same process as the rest of our area: details, then a fixed price, then sealing and a 12-month guarantee. Close to Markethill, our area also takes in Coupar Angus (1 mile north-west), Woodside (2 miles south-west), Burrelton (2 miles south-west), Ardler (3 miles north-east) and Carsie (4 miles north-west). A short drive away, we cover Perth (12 miles south-west), Blairgowrie and Rattray (5 miles north-west), Letham (13 miles south-west), Scone (10 miles south-west), Tulloch (12 miles south-west) and Alyth (6 miles north).
Around Markethill
A little further out are Kinclaven Castle (4.4 miles west) and Blairgowrie Community Hospital (4.6 miles north-west). For a walk, there’s Northballo Hill and Monk Myre.
When to bring in a specialist
General builders and handymen seal joints, but it isn’t their main trade. A specialist prepares properly, controls joint depth and picks a product with the right movement class.
Redoing a failed joint normally costs more than getting it right at the outset, since all of it has to come out and the faces be cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.
What we can’t put right
A proper diagnosis includes knowing what sealant can’t do. You’ll hear from us if the cause turns out to be any of the following:
- Gaps in walls that were never built as compartment walls
- Writing the fire-stopping specification
- Fire risk assessments, a job for a competent assessor
Not sure which it is? You can ring 01277 525 020 or email us and we’ll tell you honestly.
What we seal
- Joints between fire-resisting walls and floors
- Linear gaps at wall heads
- Service gaps in risers
- Small duct penetrations where the tested detail allows
- Pipe penetrations
- Cable penetrations
Why deal with it now?
Open penetrations multiply: each new service adds to the list. Keeping on top of it after each round of works keeps the job small. For buildings near Markethill, dealing with all the failing joints at once saves return trips. Photos of each area help us quote the whole job.
The specified product makes a difference, as does the preparation each joint needs. Access, phasing and site requirements come into it too.
Why clients in Markethill choose us
- Workmanship guaranteed for 12 months
- Specification-led, product-correct work
- Fixed quotes based on photos, drawings or a visit
- Health and safety: CHAS accredited
Read our cost guide and how we’re accredited.