Graveney fire stopping
Work needed on a service penetration in Graveney? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Seals that don’t match their tested detail
- Openings left by services added after handover
- Open linear gaps along the top of fire-resisting walls
Fire stopping near Graveney
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Fire stopping for commercial buildings in Graveney
Most of our fire stopping work happens after the building is up. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind, and they are easy to forget. We close the openings listed on your schedule, using the specified sealant and detail. We work on cable penetrations, service gaps in risers and joints between fire-resisting walls and floors, and the usual reasons a site gets in touch are unsealed joints where partitions meet the slab and damaged fire seals in risers and voids. One point of contact handles commercial sealant work in Graveney from the first photos to the final walk-round, whether it’s one building or several.
For a smaller site near Graveney, we plan to do all the penetrations in one go, with the specification and photos sent in advance. We install to the specification and the manufacturer’s guidance, leaving design and sign-off with the designer and building control.
Every job we finish is backed by a 12-month workmanship guarantee. If a joint we sealed fails because of how it was installed, we come back and put it right.
- Place
- Graveney (ME13)
- Region
- Kent
- Cover
- 12 months on every job
- Quotes
- A fixed quote before we start
- Call
- 01277 525 020
- Last updated
- 3 November 2026
What we are called out for in Graveney
Some service penetrations were never sealed at all because they sat out of sight above a ceiling or inside a riser. They come to light during inspections, refits or when another trade lifts a tile.
Site and facilities staff are often the first to spot these:
- Openings found when ceilings come down for a refit
- Old intumescent sealant that has split away
- Non-fire-rated filler around services
- Unsealed openings around new pipes and cables
Schools such as Graveney Primary School often have new data and services installed during holidays, and penetrations through fire-resisting walls should be checked afterwards.
What your quote should include
- How the joint faces will be prepared and primed
- Which product they’ll use, and why it suits the joint
- Will CSCS-carded applicators be on site?
- How joint depth will be controlled
Places near Graveney
Also in Graveney
What sets the cost
A fixed quote reflects the actual work. It allows for:
- Phasing around occupants
- Induction, permit and paperwork requirements
- Whether old sealant has to be cut out first
- Any access equipment needed
Larger quantities, tricky access or phasing all shape the price. So do site requirements such as inductions and permits, along with the time of year for external work.
Sending details for a quote
It doesn’t need to be a full survey. A few details are enough to get going:
- Clear photos of the problem areas
- Access details, including height
- Rough lengths or quantities, or drawings if you have them
- What the building is and how it’s used
Send us photos, drawings or a joint schedule are often enough for a fixed quote. Where a site visit makes more sense, we’ll arrange one.
Keeping the joints sound
Keep the joints in good shape with a few simple steps:
- Check risers and ceiling voids after each round of works
- Ask the designer to confirm details early on refits
- Keep product data and details in the fire safety file
- Flag new cables with no seal around them
Don’t patch a fire-rated seal with anything outside its tested detail. Repairs need the same product and detail as the original.
Regular walk-rounds of service areas are worth the time. A cracked or disturbed seal found early is a small job.
Why act early in Graveney
It is cheaper to seal service penetrations as each services package finishes than to come back for them later. Openings are visible, access is open and nothing has to be taken down. Older rural buildings around Graveney move with the seasons, and rigid or tired sealant can’t keep up. A sealant with the right movement capability, correctly sized, lasts far better.
Whether it’s a single area or a whole estate, the same things set the price: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote, and you will have a fixed figure to work with.
Why choose Mastic Doctor in Graveney
- 12 months’ guarantee on every job
- CHAS accredited
- Joints cleaned back to sound surfaces
- One phone line for London, the South East and Scotland
Take a look at how commercial sealant jobs are priced or our accreditations and insurance.
Fire stopping around Graveney: points for this area
At about 46 miles from central London, Graveney is within reach of the capital. Business park offices in the commuter belt are refitted as tenants change, and each fit-out adds services through compartment walls. Approved Document B is the English guidance that covers fire stopping around openings and penetrations. Its BS 476 references are being withdrawn from 2 September 2029, with BS EN 13501-2 classification taking over, subject to transitional arrangements. Our part stays the same: the specified product, installed to its tested detail.
For a hospital such as Whitstable and Tankerton Hospital (5.3 miles north-east of Graveney), penetration sealing is usually phased ward by ward, with infection-control rules agreed first. For a building such as Church of All Saints, new heating or data runs are the usual reason penetrations need sealing.
Graveney is about 2 miles east of Faversham, in Kent. We cover Graveney, with the same fixed quotes and 12-month guarantee as everywhere else. 931 places across Kent fall within our area, Graveney among them. We also cover London, around 46 miles from Graveney.
Postcode districts covered here: ME13 for service penetrations. For a building on Murton Place, Sandbanks Lane and Seasalter Road or nearby, send details and we will quote for service penetrations. We also cover Culmers (1 mile south-west), Broom Street (1 mile north-west), Goodnestone (1 mile south-west), Hernhill (1 mile south-east) and Slutshole (1 mile south-east). Further afield, our area takes in Ashford (13 miles south), Canterbury (7 miles south-east), Sittingbourne (9 miles west), Whitstable (4 miles north-east), Herne Bay (9 miles east) and Minster (9 miles north-west).
Around Graveney
Around Graveney, our work takes us to commercial buildings near South Swale and Queen Elizabeth's Grammar School. Graveney’s nearest station is Faversham station, roughly 2.4 miles west of the centre. A little further out are Tankerton Castle (4.9 miles north-east) and Whitstable and Tankerton Hospital (5.3 miles north-east). The countryside around Graveney includes Blean Woods RSPB Reserve.
Building owners, agents and FMs in Graveney
We work for building owners and managing agents on everything from one building to a spread of sites. Several sites can go on one quote, which keeps the paperwork simple.
As a CHAS accredited contractor and Constructionline member, we’re straightforward to vet for your supplier list. Our insurance certificate can be sent along with the quote.
Questions we are asked in Graveney
Is a smaller place like Graveney outside your area?
Not at all. Graveney is within our area. We cover Greater London and the counties of the South East. Send photos and a list of what needs doing, and we’ll plan the job to need as few trips as possible.
Do you take on work at healthcare sites like Whitstable and Tankerton Hospital?
Yes, hospitals are one of the sectors we cover. The estates team’s permit system and infection-control rules come first, and the work is planned around them.
Do you design or specify fire stopping?
No. Deciding what is needed sits with the designer, fire engineer and building control. Our role is installing what they specify, to the product’s tested detail.
Do you take on multi-site work?
Yes. Several buildings can share a single quote, with one point of contact across South East England, Greater London and Scotland.
Do you seal on top of existing sealant?
No, never. Overlaying old sealant is a frequent cause of early failure, so it all comes out first.
Do you approve fire stopping for building control?
No. Approval sits with the designer, principal designer or building control. We’ll confirm the product and detail installed, and you can tell us what other records you need at quote stage.
Can the sealant be colour-matched?
Often, yes. Sealants are made in a wide range of standard colours, and matching to RAL references or nearby finishes is commonly requested. We confirm what’s available for the specified product when we quote.
On site: what to expect
We follow your site rules from the start: sign-in, induction and whatever permit system the building uses. With the paperwork done, the joints are worked through in the order agreed with your site contact, and each area is checked before we leave it. For work around Graveney, we aim to finish in one visit, so photographs and measurements up front really help. Then the right materials arrive with us.
- We start with your penetration schedule, drawings or specification.
- We plan the sequence of floors, risers and voids with you.
- Each opening is checked for wall or floor type, service, gap and depth.
- Foam, ordinary sealant and debris come out.
- Backing and fire-rated sealant are installed to the detail and tooled.
- Anything outside the detail is reported to you rather than sealed.
Preparing the site
- Tell staff and tenants when we will be in
- Flag any permit to work we’ll need
- Confirm the product named in the specification
Ask for a quote
Specifications, drawings and tender packages are welcome with any enquiry, and we will price the work to it. For smaller jobs, photos and a description will do.