Fishcross fire stopping
Our CSCS-carded applicators take on fire-rated and intumescent sealing of service penetrations and linear gaps in Fishcross and the surrounding area. Send photos or drawings for a fixed quote.
- Hidden openings found during inspections
- Openings left by services added after handover
- Penetration schedules that need working through
Need fire stopping in Fishcross?
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
About our fire stopping in Fishcross
A fire-rated sealant is only one part of a tested system: the evidence covers a specific product, wall or floor type, service, gap, depth and backing. We match each opening to that detail before any sealant goes in, and we say so if it doesn’t fit. We work on linear gaps at wall heads, small duct penetrations where the tested detail allows and service gaps in risers, and the failures we’re asked to look at most are penetration schedules that need working through and fire stopping installed outside its tested range. Sealant contractors, mastic applicators, sealant specialists: whatever the job title on the order, the work in Fishcross is the same: the right product in a properly prepared joint.
In smaller Scottish places like Fishcross, buildings with fire-resisting walls typically include schools, care homes, hotels and health centres. Those penetrations are closed with the product the specification names, built up as tested.
A 12-month guarantee applies to all our work in Clackmannanshire. Should something we installed fail, ring 01277 525 020 or send photos by email and we will come back to it.
- Where
- Fishcross (FK10)
- Wider area
- Clackmannanshire
- Cover
- A 12-month guarantee
- Quote
- Fixed quote, scope in writing
- Call
- 01277 525 020
- Page updated
- 3 November 2026
Keeping the joints sound
Once the work is signed off, a little attention goes a long way:
- Don’t let anyone top up a fire seal with the wrong product
- Ask the designer to confirm details early on refits
- Record which product was used where
- Have penetrations checked while they can still be seen
Never top up a fire seal with foam, ordinary silicone or filler. Repairs need the same product and detail as the original unless the designer specifies otherwise.
Ask every contractor who works in risers or voids to report openings they create. Small habits like this stop openings building up.
Towns and villages near Fishcross
Also in Fishcross
What we can’t put right
A few problems need another trade or a different fix, and we point that out rather than sealing over them:
- Signing off or certifying a building’s fire stopping
- Construction that lacks the fire resistance the seal relies on
- Plastic pipes whose detail calls for a collar or wrap
If you are not sure, just ring 01277 525 020 or use the quote form and we will give you a straight answer before you book.
Joints and surfaces we work on
- Service gaps in risers
- Pipe penetrations
- Small duct penetrations where the tested detail allows
- Joints between fire-resisting walls and floors
- Linear gaps at wall heads
- Cable penetrations
General trades versus a specialist
Some joints are best left to specialists: for example fire-rated seals that must match a tested detail, trafficked floor joints and external movement joints. A poor seal in places like these tends to cost more to put right later.
What you see is the finished bead, but most of the work is hidden. Backing rod, primer where specified and a joint designed to move with the building are where general trades tend to cut corners.
Why it’s worth doing now in Fishcross
It is cheaper to seal service penetrations as each services package finishes than to come back for them later. Openings are visible, access is open and nothing has to be taken down, and the right detail can be checked at the time. For buildings near Fishcross, dealing with all the failing joints at once saves return trips. Send photos and we will quote for everything together.
Whether it’s a single area or a whole estate, the same things set the price: scope, access, product and programme. Call for a quote, and you’ll have a fixed figure to work with.
Why clients in Fishcross choose us
- 12 months’ guarantee on every job
- Work carried out by CSCS-carded applicators
- CHAS accredited contractor
- One number for every site we cover
Take a look at our cost guide and how we’re accredited.
Where services cross fire walls in Fishcross
There are several hotels within about 2 miles of Fishcross. Hotels are divided into compartments, and refurbishments that add pipes and cables through bedroom and corridor walls leave gaps to close. Scotland has its own building standards: the non-domestic Technical Handbook (clause 2.1.14) says service penetrations should be fire stopped to at least the fire resistance duration of the wall or floor, using products tested for the way they’re used. Where fire-rated sealant is specified, that’s what we install, to the tested detail.
Schools such as Alva Academy often have new data and services installed during holidays, and penetrations through fire-resisting walls should be checked afterwards. On estates like Industrial Estate, which lies north-west of Fishcross, the wall between office and warehouse is often fire-resisting, and cables through it need the specified seal. For a building such as Sauchie Parish Church, new heating or data runs are the usual reason penetrations need sealing.
Fishcross is about 1 mile north-east of Alloa, in Clackmannanshire. Fishcross sits inside our coverage and the rest of Clackmannanshire, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. Fishcross is one of 13 places we cover in Clackmannanshire for service penetrations. There’s a separate page for Edinburgh, roughly 26 miles from Fishcross.
Anyone looking for fire stopping in FK10 gets the same process as the rest of our area: send details, get a quote, we seal, guaranteed. If your site is on Brandyhill, Lawswell and Pitfairn Road or close by, send details and we’ll quote for service penetrations. Sites close to Fishcross are covered too, including Sauchie (1 mile south-west), Coalsnaughton (1 mile east), Devonside (1 mile north-east), Alloa (1 mile south-west) and Tillicoultry (2 miles north-east).
Around Fishcross
The nearest railway station is Alloa station, roughly 1.5 miles south-west. A little further out are Alloa Museum And Gallery (1.7 miles south-west) and Old Tulliallan Castle (4.3 miles south-east). Open spaces near Fishcross include Gartmorn Dam Country Park and Nature Reserve and Craig Leith.
Our process
The first thing on site is a walk round with your contact, agreeing which joints are in scope, where to start and what must stay open. Then we strip out anything that has failed, prepare every joint and seal it. For a building near Fishcross, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- We read the specification, drawings or penetration schedule you send.
- Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
- Unsuitable fillers and loose debris are taken out of each opening.
- We fit the backing the detail asks for, to the stated depth.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.
Before we start on site
- Arrange parking or a loading space
- Flag any permit to work we will need
- Tell staff and tenants when we’ll be in
Quotes
A good quote starts with a clear picture: the joints involved, quantities, access and the product called for. Share whatever details you have and we will fill any gaps with a visit.
Advice
Questions about Fishcross
Can work in a care setting near Fishcross go ahead while residents are there?
Yes, with the manager deciding the order and timing of rooms. Any site rules, from signing in to infection control, are agreed before we start.
Is Industrial Estate, near Fishcross, within your area?
Yes, sites like Industrial Estate are within our area, along with the rest of Fishcross. To start, just phone 01277 525 020 or email a schedule or drawings with the unit, the joints involved and your access times.
Does the weather affect the work?
It can, when the joints are outside. Sealant won’t bond properly to a wet or frosty joint, so external work may be moved if conditions aren’t right. Indoors, the weather is rarely a problem.
Is your workmanship covered by a guarantee?
Yes, for 12 months. If our installation fails in that time, we return and fix it.
How long does a job like this take?
That varies with the scale of the job, but the work typically takes longer where risers, ceiling voids or occupied floors have to be worked through in sequence. For bigger or phased jobs, we’ll set out a timescale with the quote.
How long will the new sealant last?
It depends on movement, UV and weather, cleaning, traffic and the product. Sealant joints are maintenance items, so inspect them regularly.
How long before the joints can be used?
The product and site conditions decide that. Some products skin over quickly but need longer to cure fully, so we will confirm the curing time on the day.
Different surfaces, different methods
Linear joints
Joints at the top of partitions may need to move as the slab above deflects. The specified product and backing for that movement are what goes in, along the full length of the run.
Risers and ceiling voids
Risers and ceiling voids hold most of a building’s service penetrations. Access is often tight, so we agree it with you in advance.