Fire Stopping in Dalrymple
Fire-rated and intumescent sealing of service penetrations and linear gaps in Dalrymple and across East Ayrshire. CHAS accredited, Constructionline member, with a 12-month guarantee on workmanship.
- Openings found when ceilings come down for a refit
- Old intumescent sealant that has split away
- Head-of-wall gaps with no fire seal
Fire stopping across Dalrymple
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
What the job involves on each surface
Masonry and concrete
Core-drilled holes are neat; broken-out ones rarely are. Each gap is measured where it is widest so we know it sits within the tested range.
Risers and ceiling voids
Voids hide a lot of unsealed openings. We follow your schedule area by area and tell you about openings outside the list.
About our fire stopping in Dalrymple
We should be clear about what we do and don’t do. Deciding the specification sits with the designer, the fire engineer and building control. We fit the specified fire-rated sealant following that specification and the maker’s installation guidance. We work on cable penetrations, service gaps in risers and small duct penetrations where the tested detail allows, and what we are called in for most is service penetrations left open after M&E works and builders’ foam or ordinary silicone in compartment walls. Looking for mastic applicators who cover Dalrymple? We’ve been sealing commercial buildings since 2005, with CSCS-carded applicators.
Refurbishments in small hotels, schools and care homes around places like Dalrymple can leave gaps around new services. We fit the specified fire-rated sealant as its published detail shows and raise it if another product is needed.
Building owners and contractors get the same cover: a 12-month guarantee on our workmanship. It doesn’t extend to damage, faults in the building or work by others, and we are upfront about that.
- Location
- Dalrymple (KA6)
- Wider area
- East Ayrshire
- Guarantee
- 12 months on every job
- Quotes
- A fixed quote before we start
- Telephone
- 01277 525 020
- Last updated
- 3 November 2026
What affects the price in Dalrymple
Before we quote, we look at:
- Whether old sealant has to be cut out first
- Any access equipment needed
- Which sealant the job calls for
- Distance, for remote addresses
Small jobs and large programmes are priced from the same things: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote and we will put a fixed figure on it.
Sending details for a quote
Whether it’s one area or a whole building, the same details help:
- Clear photos of the problem areas
- Whether the building will be occupied during the work
- Any specification or named product
- Access details, including height
To get a fixed quote, call 01277 525 020 or email a schedule or drawings, telling us the site location and the nature of the job. Our quote form is another easy route.
Owners, agents and contractors
For main contractors, we work as the sealant subcontractor. Programme, specification and site rules come first, with CSCS-carded applicators on site.
Agents, factors and owners’ representatives all follow the same route: send the details, accept a fixed quote, and we carry out and guarantee the work. Keys, access and contacts can be agreed in advance.
Our process
On arrival, we report to your site contact and complete whatever induction the building runs. Everything around the joints gets protected before anything is cut or cleaned, with the work itself usually taking longer where risers, ceiling voids or occupied floors have to be worked through in sequence. Tell us who will meet us and how to get in at your building near Dalrymple. We will confirm the plan with the fixed quote.
- First we confirm the product and tested details named in the specification.
- We sort the openings by the detail each one needs.
- Improvised fillers and failed sealant are removed.
- Mineral wool or other backing is fitted where required.
- Fire-rated or intumescent sealant goes in around the services and is tooled off.
- Completed areas are checked with you, with the records agreed when we quoted.
Preparing the site
- Warn occupants and staff about the work
- Send any specification or drawings in advance
- For older buildings, check the asbestos register before work
Quotes
Every quote starts with the facts: the joints involved, quantities, access and the product called for. Share whatever details you have and we’ll fill any gaps with a visit.
Advice
What sealant work can’t fix
A proper diagnosis includes knowing what sealant can’t do. You will hear from us if the cause turns out to be any of the following:
- Signing off or certifying a building’s fire stopping
- Fire doors, dampers or other fire safety equipment
- Openings that need collars, wraps, batts or boards rather than sealant
If in doubt, speak to us on 01277 525 020 or email a schedule or drawings and we’ll say what we think before you book.
Joints and surfaces we work on
- Service gaps in risers
- Cable penetrations
- Joints between fire-resisting walls and floors
- Linear gaps at wall heads
- Pipe penetrations
- Small duct penetrations where the tested detail allows
Where services cross fire walls in Dalrymple
Under the Scottish non-domestic Technical Handbook, clause 2.1.14, penetrations should be fire stopped to at least the wall or floor’s fire resistance duration, with products tested for that end use. We install what’s specified, to the product’s tested detail.
In a building such as Parish Church and Churchyard, any service penetration through a fire-resisting wall should be sealed to the specified detail. Large healthcare estates like University Hospital Ayr (to the north of Dalrymple) change their services often, so penetration seals are worth checking after M&E work. Campus buildings at universities such as University of the West of Scotland - Ayr Campus, 4.3 miles north of Dalrymple, see constant changes to data and services, and fire-rated sealant goes in around new penetrations where it is specified.
Dalrymple is about 4 miles south of Ayr, in East Ayrshire. Dalrymple sits inside our coverage, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. Dalrymple is one of 56 places in East Ayrshire on our list for service penetrations. Sites around Glasgow have their own page, roughly 34 miles from Dalrymple.
If you need fire stopping in KA6, the process matches everywhere else we work: details, then a fixed price, then sealing and a 12-month guarantee. For a building on Main Street, Cedar Terrace and Burnton Court or nearby, send details and we will quote for service penetrations. Being close to the B7034, Dalrymple is straightforward for us to reach. If your building is just outside Dalrymple, we cover Hollybush (2 miles east), Minishant (2 miles west), Alloway (3 miles north-west), Kirkmichael (4 miles south) and Forehill (4 miles north). Nearby towns on our patch include Kilmarnock (15 miles north), Cumnock (13 miles east), Annanhill (15 miles north), Mauchline (11 miles north-east), Bonnyton (15 miles north) and Auchinleck (13 miles north-east).
Around Dalrymple
The nearest railway station is Ayr station, roughly 4.5 miles north of the centre. Other landmarks nearby include Robert Burns Birthplace Museum (2.8 miles north-west) and University Hospital Ayr (2.3 miles north). For a walk, there’s Lindston Loch.
Why act early in Dalrymple
Sealing behind the M&E trades area by area beats a sweep at the end. Openings are visible, access is open and nothing has to be taken down and each detail can be checked as we go. Buildings that aren’t in daily use, such as halls and seasonal premises, may let water in unnoticed, giving water time to get in. Early resealing prevents it.
Every site prices differently: the joint sizes, the specified product, access and working hours each have a bearing. A fixed quote follows once we understand the job.
What you get with us
- Sealing commercial buildings since 2005
- CSCS-carded applicators
- Public liability insurance in place
- One number for every site we cover
Take a look at our cost guide or our accreditations and insurance.
FAQs: Dalrymple
Can you work on a hospital site such as University Hospital Ayr?
Yes, provided the work is planned with the site’s estates team. We follow the site’s permits, sign-in and infection-control procedures in every area.
How do the Scottish rules apply to fire-rated sealing in Dalrymple?
Scotland’s non-domestic Technical Handbook covers it in clause 2.1.14: penetrations keep at least the element’s fire resistance duration, with products tested for their end use. Design sits with the designer and the verifier; installation to the tested detail is our part.
Do you offer coloured sealant?
In many cases, yes. Many products come in a range of standard colours, and matching to RAL references or surrounding finishes is often possible. We will confirm the colours available for the specified product.
Can you fit around our working hours?
The office is staffed Monday to Friday, from 8am until 5pm. Let us know your site hours and access windows, and the work will be planned around them.
Are you CHAS accredited and on Constructionline?
Yes. Mastic Doctor is CHAS accredited and a Constructionline member.
Who decides which product is used?
A specification, where there is one, decides it. If there isn’t one, it comes down to the joint: how much it moves, what it bonds to and whether it’s wet, trafficked or fire-rated.
Do you seal on top of existing sealant?
No. We cut the old material out and clean the joint back before sealing, because fresh silicone will not bond with aged silicone.