Chiddingfold fire stopping
We carry out fire-rated and intumescent sealing of service penetrations and linear gaps in Chiddingfold and the surrounding area. Send photographs or drawings for a fixed quote.
- Head-of-wall gaps with no fire seal
- Openings left by services added after handover
- Expanding foam used as fire stopping
Fire stopping for Chiddingfold sites
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
FAQs: Chiddingfold
How does the removal of BS 476 from Approved Document B affect fire-rated sealing in Chiddingfold?
References to BS 476 classes are being removed from Approved Document B from 2 September 2029, after which BS EN 13501-2 classification is the route, subject to transitional arrangements. The designer or fire engineer sets the specification, and we install the product to the manufacturer’s tested detail.
Do you take on work at healthcare sites like Haslemere and District Hospital?
Yes, provided the work is planned with the site’s estates team. Work is phased so departments keep running, under the site’s own rules.
How do you deal with asbestos in old sealant?
Some older mastics, especially in pre-2000 buildings, can contain asbestos. We check the asbestos register before cutting out old sealant in an older building, and if asbestos is suspected, work stops until it’s tested. We don’t remove asbestos-containing materials.
Is colour matching possible?
That depends on the product. Some ranges offer many colours, others very few, so the available colours are confirmed with the quote.
Can you handle several sites?
Yes. Multi-site work and planned programmes are a core part of the service, with each site phased to suit its occupants.
How long does a job like this take?
That varies with the scale of the job, but the work typically takes a single visit for a short list of penetrations, or a phased programme for a whole building. Larger or phased jobs take longer, and we will give you a timescale with the quote.
Do you need to see the site first?
That depends on the size and complexity of the job. Simple work can often be priced from photographs, while larger or less clear jobs get a site visit first.
Fire stopping for commercial buildings in Chiddingfold
Where pipes, cables and other services cross a compartment wall or floor, the opening around them has to be closed so fire and smoke can’t move between compartments. Our job is fitting fire-rated and intumescent sealant at those service penetrations, and along linear gaps, where it is the specified product. We work to the product’s tested detail for every seal, not a rule of thumb. We work on service gaps in risers, pipe penetrations and joints between fire-resisting walls and floors, and what we’re called in for most is old intumescent sealant that has split away and openings left by services added after handover. Whether you call it commercial sealant work, mastic application or joint sealing, in Chiddingfold it comes down to the same thing: the right product in a properly prepared joint.
A job near Chiddingfold is usually planned around one visit, so send the specification and photographs first. Design and sign-off belong to the designer or building control; we install what’s specified.
The 12-month guarantee covers our workmanship: the preparation, the sealing and the tooling. It doesn’t extend to damage, other trades’ later work or movement the joint was never designed to take.
- Place
- Chiddingfold (GU8)
- Wider area
- Surrey
- Cover
- 12 months on every job
- Quotes
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Maintenance after handover
Cleaning and maintenance staff play a part too. Pass these on to them:
- Don’t let anyone top up a fire seal with the wrong product
- Leave fire sealant to cure fully before covering it
- Agree the fire-stopping specification before services go in
- Arrange inspection before areas are covered up
Allow the manufacturer’s stated cure time before boxing in or decorating. Not every fire-rated product can be painted, so check the product data first.
Write fire stopping into the scope of any work crossing a compartment wall or floor. That way the opening is sealed while the trade and access are still there, not months later.
Towns and villages near Chiddingfold
What else we do in Chiddingfold
From enquiry to sign-off
Inspect, seal, sign off: every visit follows that pattern. First comes an inspection and agreement on scope, then the work is carried out to the specified product and detail, and the job ends with a walk round and sign-off. If others near Chiddingfold need work, visits can be combined. A fixed quote is given before anything starts.
- The specification and schedule come first, so we know which details apply.
- Access, permits and the order of areas are agreed with the site team.
- We compare every service penetration with its tested detail before sealing.
- Foam, ordinary sealant and debris come out first.
- Backing and fire-rated sealant are installed to the detail and tooled.
- We tell you about openings that need a different product.
Preparing the site
- Share your working hours and any access restrictions
- Send any specification or drawings in advance
- Make sure the joints can be reached
Getting a fixed quote
Photos, drawings or a schedule of the joints and a fixed quote comes back to you. Where a site visit makes more sense, we’ll arrange one.
Advice
Do you need fire stopping in Chiddingfold?
Head-of-wall joints and wall-to-wall junctions are frequent weak points. Deflection and building movement can open these gaps. Linear joint details set a width range and movement capability, and the seal has to sit within them.
Clients normally get in touch after noticing one or more of the following:
- Penetration schedules that need working through
- Fire sealant pulled out of the opening
- Openings found when ceilings come down for a refit
- Head-of-wall gaps with no fire seal
Hospital estates such as Haslemere and District Hospital (3.6 miles south-west of Chiddingfold) are divided into fire compartments, and any service penetration through them should be sealed to the specified, tested detail.
What your quote should include
- How the joint faces will be prepared and primed
- Will failed sealant be removed rather than covered?
- How they’ll work around occupants
- Their approach to joint depth and backing
Commercial clients in Chiddingfold
Housing associations and managing agents often need work done across blocks and communal areas. Work can be phased so residents and staff keep access throughout, and each stage is agreed with your contact.
As a CHAS accredited contractor and Constructionline member, we’re straightforward to vet for your supplier list. We are fully insured, and our insurance certificate can go with the quote.
Where services cross fire walls in Chiddingfold
Fire stopping of openings and penetrations in England falls under Approved Document B. The national BS 476 classes are due to drop out of it from 2 September 2029, leaving the European BS EN 13501-2 route, subject to transitional arrangements. What we install is set by the specification, and it goes in to the tested detail. Chiddingfold is about 35 miles from central London. Offices around the capital are refitted often, and the cabling that follows can breach fire-resisting walls; the gaps need the specified seal.
Older community buildings such as St Teresa of Avila Church that have been rewired or given new heating can have service gaps through walls worth checking against the specification. Schools such as St Mary's Church of England Primary School often have new data and services installed during holidays, and penetrations through fire-resisting walls should be checked afterwards.
Chiddingfold is about 10 miles south of Guildford, in Surrey. We cover Chiddingfold and the rest of Surrey, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. 379 places across Surrey fall within our area, including Chiddingfold. We also cover Reading, some 27 miles away.
Postcode districts covered here: GU8 for service penetrations. If your site is on Pathfield, Roseneath Drive and Woodside Road or close by, send details and we’ll quote for service penetrations. We also cover Hambledon (2 miles north), Highstreet Green (2 miles east), Wormley (2 miles north), Sandhills (2 miles north-west) and Brook (2 miles north-west). A short drive away, we cover Guildford (10 miles north), Woking (14 miles north), Farnham (10 miles north-west), Dorking (15 miles north-east), Frimley (14 miles north) and Haslemere (4 miles south-west).
Near you in Chiddingfold
Locally, jobs take us to sites close to The Swan Inn and the streets around them. Chiddingfold’s nearest station is Witley station, roughly 1.5 miles north of the centre. Other landmarks nearby include Haslemere and District Hospital (3.6 miles south-west). Green spaces nearby include Upper Lake and Hydon's Ball.
Honest limits
We seal joints; we don’t mend everything behind them. On its own, sealant can’t deal with:
- Construction that lacks the fire resistance the seal relies on
- Signing off or certifying a building’s fire stopping
- Fire risk assessments, a job for a competent assessor
If you’re not sure, just ring 01277 525 020 or send details through our quote form and we’ll give you a straight answer.
Joints and surfaces we work on
- Cable penetrations
- Joints between fire-resisting walls and floors
- Service gaps in risers
- Pipe penetrations
- Small duct penetrations where the tested detail allows
- Linear gaps at wall heads
Different surfaces, different methods
Linear joints
Head-of-wall joints often have to absorb slab deflection. The specified product and backing for that movement are what goes in, with no gaps along the run.
Risers and ceiling voids
Voids hide a lot of unsealed openings. We follow your schedule area by area, and note anything we find that isn’t on it.