Expansion and movement joint sealing in Uplees, Kent
Expansion joint sealing for Uplees, from a contractor working since 2005. Fully insured, with a 12-month guarantee.
- Water getting into the wall through a failed joint
- Hardened, cracked sealant on exposed facades
- Chipped joint edges on forklift routes
Need expansion joint sealing in Uplees?
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Expansion joint sealing in Uplees, done properly
Long runs of brick or block have movement joints built in, and they’re easy to miss until the sealant fails. Failed sealant here lets rain into the wall and can leave the joint full of debris. The old seal is cut away, backing rod goes in at depth, and a low-modulus masonry sealant is gunned and tooled. We work on blockwork control joints, car park decks and ramps and cladding panel joints, and the failures we’re asked to look at most are spalled or broken joint edges in floors and decks and joints where the bead has lost adhesion. One point of contact handles commercial sealant work in Uplees from the first photos to the final walk-round, for single jobs and planned programmes alike.
Jobs around smaller places like Uplees are planned so the whole job is done in one visit, with the right materials on hand. Tell us the joint widths if you can, and what drives or walks over them.
The 12-month guarantee is for workmanship rather than wear and tear. How long a sealant joint lasts depends on movement, exposure, cleaning and use, so we’re clear about what is covered before work starts.
- Where
- Uplees (ME13)
- Region
- Kent
- Guarantee
- 12 months on every job
- Quotes
- Fixed quote, scope in writing
- Call
- 01277 525 020
- Page updated
- 3 November 2026
When to call us in Uplees
On trafficked joints, wheels and salts do the damage. Tyres and wheels press on the edges and the sealant. The product has to be suited to the traffic.
Typical triggers for a call:
- Water getting into the wall through a failed joint
- Movement joints with split or torn sealant
- Brittle, chalky sealant on external joints
- Sealant peeling off one face of the joint
Around Uplees, each joint gets a filler or sealant matched to what crosses it and how much it moves.
Before you book anyone
- Is the sealant right for the movement and the substrate?
- Their plan for phasing and protecting the area
- Will CSCS-carded applicators be on site?
- How the existing material will be dealt with
How the job changes by surface
Brickwork and blockwork joints
Vertical movement joints in brick and block walls let the masonry grow and shrink. We use a sealant rated for the movement, usually low-modulus laid over backing rod at the correct depth.
Car park decks and ramps
Car park joints are some of the hardest-working joints in any building. We use a sealant made for wheel loads and the expected movement, phased so parts of the car park stay open.
Building owners, agents and FMs in Uplees
When you manage a building on behalf of an owner, clear figures and clear communication matter. You get a fixed quote, an agreed scope and a walk round at the end.
We work for building owners and managing agents on sealant work across single buildings or whole portfolios around Uplees. Several sites can go on one quote, which keeps the paperwork simple.
Towns and villages near Uplees
Other services in Uplees
Floors, slabs and movement joints in Uplees
Uplees lies within about 1 mile of the sea. Near the sea, external slabs, ramps and decks see salt air and driven rain as well as their usual loads, and edges left open tend to break up faster. At about 43 miles from central London, Uplees is within reach of the capital. The roads out of London are lined with trade parks and distribution sheds; their floors carry heavy traffic every shift.
In a school such as Queen Elizabeth's Grammar School, movement joints in brick, block and hall floors tend to be forgotten until they leak.
Uplees is about 2 miles north of Faversham, in Kent. Anywhere in ME13, the process is the same: send details, get a fixed quote, we seal, and the work is guaranteed. We work across 931 places in Kent, from busy centres to rural villages. Sites around London have their own page, roughly 43 miles from Uplees.
Work on movement joints is covered throughout ME13. Just outside Uplees, we also work in Oare (1 mile south-east), Four Oaks (2 miles south-west), Davington (2 miles south), The Brents (2 miles south-east) and Deerton Street (2 miles south-west). A short drive away, we cover Ashford (14 miles south), Canterbury (10 miles south-east), Sittingbourne (6 miles west), Whitstable (7 miles east), Herne Bay (12 miles east) and Minster (6 miles north-west).
Around Uplees
Recent enquiries here include premises near Three Mariners Inn and Oare Marshes, among other places. The nearest railway station is Faversham station, roughly 2.4 miles south-east of the centre. Other landmarks nearby include Newnham Castle (4.9 miles south-west).
When something else is needed
Some faults sit outside our scope, and we point that out rather than sealing over them:
- Concrete or masonry repairs along the arrises
- Proprietary pre-formed expansion joint systems
- Failed waterproofing membranes on podiums, roofs or decks (a waterproofing specialist’s job)
Not sure which it is? You can call 01277 525 020 or email drawings and photos and we’ll tell you honestly.
Joints and surfaces we work on
- Cladding panel joints
- Car park decks and ramps
- Brickwork movement joints
- Blockwork control joints
- Precast concrete panel joints
- Podiums and floor movement joints
Why act early in Uplees
Some quotes just add sealant over the old bead. A bead laid on top of the failed one neither grips nor flexes properly, so it fails quickly. Full removal and preparation is in every quote. Around Uplees, it’s better to renew all the failing joints at once. Send photos of each area and we’ll quote for the lot.
Every site prices differently: joint size, product, access and site hours all play a part. Send the details and a fixed figure follows.
Why clients in Uplees choose us
- CHAS accredited contractor
- Constructionline member
- One phone line for London, the South East and Scotland
- Specification-led, product-correct work
See our cost guide or our accreditations.
Your questions answered
Our building in Uplees is near the coast: does that change the sealant?
It can. Driven rain and salt are tougher on outside sealant than sheltered inland conditions. We check the specified product suits the exposure and pay close attention to preparation.
Is a smaller place like Uplees outside your area?
Not at all: smaller places are covered as well as towns. We work across Greater London and the South East. We plan jobs in smaller places so return trips are kept to a minimum.
What happens if old sealant might contain asbestos?
Asbestos is possible in some older mastics, particularly in buildings from before 2000. Before we disturb old sealant in an older building, we ask to see the asbestos register or survey, and work stops until any suspect material has been tested. We don’t remove asbestos-containing materials.
What sealant do you use in movement joints?
The specification comes first, then the joint’s movement and exposure. The quote states the sealant and its movement class.
What do you charge?
Each job is quoted on its own details. For yours, ring 01277 525 020 or email the details over.
How long will the new sealant last?
Nobody can honestly give a figure in years, since movement, weather, cleaning and use all affect it. Regular inspection is the best way to catch problems early.
How do you choose the sealant?
If the job is specified, we follow the specification. If not, we choose for the movement, the surfaces and the conditions, in line with the manufacturer’s guidance.
Diagnose, treat, sign off
Occupied buildings need a little choreography. The work area is signed and kept contained, with routes through the building left open and move on in phases so staff and visitors can carry on around us. Jobs in and around smaller places like Uplees are usually planned as a single visit, so photos and measurements up front really help. Then the right materials arrive with us.
- We start with photographs, approximate lengths and any drawings, visiting where needed.
- Joint widths and expected movement are checked against what the sealant can take.
- Old sealant and debris are cut out of every joint.
- Any broken arrises or friable edges are flagged before work goes further.
- A sealant suited to the movement and traffic is laid to depth and tooled.
- Each area is handed back after its cure time, under our 12-month guarantee.
Getting the site ready
- For older buildings, check the asbestos register before work
- Share your working hours and any access restrictions
- Send any specification or drawings in advance
Quotes
Pricing a project or setting a maintenance budget? We will quote against your scope and drawings you can plan around. If you have questions first, call 01277 525 020 or email the details over.