Expansion and movement joint sealing in The Brents, Kent
Expansion and movement joint sealing in walls, decks and floors across The Brents, by CSCS-carded applicators. Fully insured and CHAS accredited.
- Brittle, chalky sealant on external joints
- Damp inside where a wall movement joint has failed
- Layers of sealant in a movement joint
Expansion joint sealing near The Brents
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Commercial clients in The Brents
FMs need a contractor who is easy to get on site. Tell us what site paperwork you need, such as RAMS, an insurance certificate or CSCS details, and we’ll confirm with the quote.
Housing associations and managing agents often need work done across blocks and communal areas. We phase the work so people keep access, with each stage agreed with your site contact.
How we handle expansion joint sealing in The Brents
A movement joint only works while its seal does. When the sealant splits or lets go, the gap fills with dirt and water. Dealt with early, it stays a sealant job rather than a concrete or masonry repair. If you are dealing with water getting into the wall through a failed joint and car park joints leaking onto vehicles below, we can put it right, on podiums and floor movement joints, cladding panel joints and precast concrete panel joints alike. Searching for sealant specialists in The Brents? Mastic Doctor has worked for contractors, FMs and building owners since 2005.
Work in a smaller place like The Brents is usually one building at a time, so we gather photographs and measurements first. Getting widths, depths and traffic details up front means one visit, not two.
Whoever the client is, the cover is the same: twelve months on the work we carried out. It doesn’t extend to damage, faults in the building or work by others, and we are upfront about that.
- Location
- The Brents (ME13)
- Wider area
- Kent
- Cover
- A 12-month guarantee
- Quotes
- A fixed quote before we start
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
From enquiry to sign-off
Diagnose, treat, sign off: every visit follows that pattern. We inspect the joints and confirm what’s in scope, then the work is carried out to the specified product and detail, and we finish with a walk round so the work can be signed off. Several jobs near The Brents can be grouped on one trip. Mention the building’s opening times and we’ll work within them.
- Photos, joint lengths and drawings come to us, or we visit.
- We compare each joint’s width with the movement and the sealant’s capability.
- Old sealant and debris are cut out of every joint.
- Any broken arrises or friable edges are flagged before work goes further.
- A sealant suited to the movement and traffic is laid to depth and tooled.
- Each area is handed back after its cure time, under our 12-month guarantee.
Before we start on site
- Send any specification or drawings in advance
- Explain the parking and delivery arrangements
- Send your site hours and access windows
Quotes
Let us know the site, the scope and your timescale, and we’ll put a fixed quote together. The easiest way is to speak to us on 01277 525 020 or email drawings and photos.
Related advice
Different surfaces, different methods
Concrete and precast panel joints
Precast panels often have surface residues that sealant won’t bond to. Proper cleaning and primer where specified give a sound bond.
Podium joints
Podiums take foot traffic, planters and weather. A sealant suited to both traffic and exposure is used.
What we are called out for in The Brents
Most movement joint failures come down to the joint stretching further than the sealant can take. A joint that’s too narrow for the movement, or a product with the wrong movement class, will split through the middle. The same product in the same joint tends to fail again.
What tends to prompt an enquiry:
- Joints where the bead has lost adhesion
- Rain penetration at brick or block movement joints
- Layers of sealant in a movement joint
- Joints packed with grit and debris
For floors and slabs around The Brents, the product is chosen for the traffic and the movement at each joint.
What your quote should include
- Their approach to joint depth and backing
- Whether primer will be used where the manufacturer specifies it
- Their plan for phasing and protecting the area
- Who will actually carry out the work
Where floor joints take the most wear near The Brents
The sea is no more than about 3 miles from The Brents. External movement joints in car parks, ramps and yards near the coast take salt and wind-driven rain on top of traffic, and edges left open tend to break up faster. The Brents sits in one of the drier corners of the country, the South East. Outside joints in yards and car parks still have to be dry before sealing, and where de-icing salt is spread in winter, open joints let it in.
Schools like Davington Primary School often have long brick elevations with movement joints that age quietly.
The Brents is about 1 mile north-east of Faversham, in Kent. Anywhere in ME13, the process is the same: send details, get a fixed quote, we seal, and the work is guaranteed. We work across 931 places in Kent, from busy centres to rural villages. Sites around London have their own page, roughly 44 miles from The Brents.
We take on movement joints across the ME13 postcode area. Among the streets we cover are Ham Road, Back Lane and Quay Lane. We also cover Davington (1 mile west), Faversham (1 mile south-west), Preston (1 mile south), Oare (1 mile north-west) and Ospringe (1 mile south-west) for movement joints. Further afield, our area takes in Ashford (12 miles south), Canterbury (9 miles east), Sittingbourne (7 miles west), Whitstable (6 miles east), Herne Bay (11 miles east) and Minster (8 miles north-west).
Local landmarks in The Brents
In The Brents, that means premises near The Brents Tavern, Oare Meadow and Queen Elizabeth's Grammar School and the streets around them. The Brents’s nearest station is Faversham station, roughly 0.6 miles south of the centre. Nearby you’ll also find Newnham Castle (4.6 miles south-west).
Your questions answered
Our building in The Brents is near the coast: does that change the sealant?
It can. Coastal exposure works external joints harder than inland weather. We choose the product for the exposure, prime where the manufacturer requires it and size the joint for its movement.
Is The Brents too far out for you?
Not at all: smaller places are covered as well as towns. Our area covers London and the South East counties. We plan jobs in smaller places so return trips are kept to a minimum.
Do you have public liability insurance?
Yes. We’re fully insured, including public liability cover.
When can you be on site?
Give us your site hours and any access windows in your enquiry, and we will plan around them. Our office runs Monday to Friday, 8am until 5pm.
Will your applicators have CSCS cards?
Yes. Our applicators hold CSCS cards, which many sites require.
Are you CHAS accredited?
Yes. We’re CHAS accredited and a Constructionline member.
How long does movement joint sealing take?
It typically takes a short visit for a handful of joints, or several days or more for a car park deck or long runs of facade joints. Timings are set out in the quote, including any phasing.
Also in The Brents
Doing it in-house
Putting right a botched joint often costs more than sealing it well at the start, because the whole bead must be removed and the faces cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.
What you see is the finished bead, but most of the work is hidden. Backing rod, primer where specified and a joint designed to move with the building are easy to get wrong without experience.
Quoting for work in The Brents
To price the job, we consider:
- The total length or number of joints
- Location, for remote and island sites
- Working within restricted access windows
- Induction, permit and paperwork requirements
Access can matter as much as the joints themselves: easy-to-reach joints are quicker than those that need equipment to get to. Tell us how the joints are reached and call for a quote.
Sending details for a quote
However big the job, these details speed things up:
- The postcode of the building
- Whether the building will be occupied during the work
- A wide shot and a close-up of the area
- The product your specification calls for
Quotes are fixed against the scope you send, so you know the figure before anyone is on site. To ask for one, phone 01277 525 020 or send details through our quote form.