Expansion and movement joint sealing in Sandwick, Na h-Eileanan Siar
Expansion joint sealing in Sandwick, backed by over 20 years in commercial sealing. Fully insured and CHAS accredited.
- Debris jammed in movement joints
- Arrises breaking up along floor joints
- Rain penetration at brick or block movement joints
Expansion joint sealing near Sandwick
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Expansion joint sealing in Sandwick, done properly
For movement joints in Sandwick, photographs and approximate lengths are the best start. We will come and look where photos don’t show enough. To discuss the joints first, give us a call on 01277 525 020 or send photos by email. Most enquiries involve water getting into the wall through a failed joint and chipped joint edges on forklift routes, across cladding panel joints, podiums and floor movement joints and precast concrete panel joints. Facilities teams, main contractors and managing agents in Sandwick tend to want the same three things: a clear scope, tidy work and joints that don’t fail again.
Travel to smaller places like Sandwick is planned so the work is done in one trip where possible. Send photographs, joint widths and details of the traffic first.
Every job we finish is backed by a 12-month workmanship guarantee, wherever the site is. If a joint we sealed fails because of how it was installed, we come back and put it right.
- Location
- Sandwick (HS1, HS2)
- Wider area
- Na h-Eileanan Siar
- Cover
- 12 months on our workmanship
- Price
- Quoted before any work starts
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
Diagnose, treat, sign off
Diagnose, treat, sign off: every visit follows that pattern. First comes an inspection and agreement on scope, then we prepare and seal each joint with the specified product, and the job ends with a walk round and sign-off. Travel to smaller Scottish places like Sandwick is planned so the job is finished in one visit where possible, which is why we ask for photos and a full list first. External joints need a dry spell as well.
- The first job is to check each joint: how wide it is, how it moves and why the old seal let go.
- A fixed quote follows, naming the sealant and its movement class.
- We strip out the old seal and prepare the faces.
- Closed-cell backing rod is set to depth, or bond-breaker tape in shallow joints.
- Primer goes on where the manufacturer specifies it, followed by the sealant, which is then tooled off.
- Finished joints are checked and backed by our 12-month guarantee.
Before we start on site
- Send asbestos survey details if the building is pre-2000
- Explain the parking and delivery arrangements
- Tell us what induction or permit system the site runs
Quotes
For a fixed quote, speak to us on 01277 525 020 or use the quote form with the site address and an outline of the work. You can also send details through our quote form.
Advice
Signs you need expansion joint sealing in Sandwick
Repeated failure often traces back to the wrong product. A stiff or general-purpose sealant across a joint with large movement won’t cope. Movement capability is set out in BS EN ISO 11600.
Common reasons buildings call us in:
- Brittle, chalky sealant on external joints
- Previous reseals laid over old sealant
- Water getting into the wall through a failed joint
- Torn sealant in brick or block movement joints
Estates like Parkend Industrial Estate, 0.5 miles to the south-east of Sandwick, combine warehouse slabs, yards and loading bays, all with joints under wheels.
Before you book anyone
- Proof of insurance
- How long is the guarantee, and what does it include?
- Is depth set with backing rod, or bond-breaker tape in shallow joints?
- How the existing material will be dealt with
Questions we’re asked in Sandwick
Does your area include sites such as Parkend Industrial Estate, near Sandwick?
Yes, sites like Parkend Industrial Estate are within our area, along with the rest of Sandwick. To start, just call the office on 01277 525 020 or email drawings and photos with the unit, the joints involved and your access times.
Do you take on work at healthcare sites like Western Isles Hospital?
Yes. Healthcare sites are among the places we work. Before anything starts, the estates team agrees permits, inductions and infection-control measures with us.
Do you seal on top of existing sealant?
No, never. Overlaying old sealant is a frequent cause of early failure, so everything comes out first.
Will your applicators have CSCS cards?
Yes. Our applicators hold CSCS cards, as many construction sites ask for.
Is Sandwick in your area?
Yes. We take on work across Sandwick, with one number for every area we cover.
How soon can the area be used again?
Curing time varies by product, and we confirm it on the day.
Can the building stay open while you work?
Normally, yes. Phased work can be planned so areas stay in use.
Towns and villages near Sandwick
Also in Sandwick
Maintenance after handover
Problems stay small when the joints are checked regularly. Specifically:
- Keep racking legs and heavy point loads off floor joints
- Clear dirt from joint lines during routine cleaning
- Brief car park operatives to protect joint lines during winter clearance
- Check joints after long freezing spells
Floor joints on main traffic routes need watching more closely than the rest. Keep racking feet and heavy point loads off joint lines, and report any chipped edges early.
Unsupported floor joint edges spall under forklift and pallet-truck wheels. Broken arrises jolt trucks, loads and drivers. Sealing early protects the edges.
Cost factors for movement joints
Before we quote, we look at:
- Induction, permit and paperwork requirements
- Any access equipment needed
- Phasing around occupants
- Quantities, in metres or numbers
Cost follows what’s involved: stripping out, preparation, sealing, access and phasing. Call for a quote.
Before you send an enquiry
For an accurate fixed quote, we need a clear picture of the site. Send us:
- When you need the work done
- Drawings or a marked-up plan, if available
- Any specification or named product
- The site address and postcode
Photos, drawings or a schedule of the joints and a fixed quote comes back to you. Where a site visit makes more sense, we will arrange one.
Where floor joints take the most wear near Sandwick
Sandwick lies within about 1 mile of the sea. External movement joints in car parks, ramps and yards near the coast take salt and wind-driven rain on top of traffic, so a failed joint lets more in and the edges break up sooner. Sandwick is in the west of Scotland, the wetter side of the country. Rainwater through open yard and deck joints is a bigger issue here than in the drier east. External sealing is booked for dry spells, with some give in the dates.
Large sites such as Western Isles Hospital (1.5 miles north-west of Sandwick) have car parks, service roads and long elevations with movement joints in brick and panels. Another example is Gleann Seileach Business Park, 1.9 miles to the north-west of Sandwick, where floors and yards would be done in stages around the occupiers.
Sandwick is about 1 mile south-east of Stornoway, in Na h-Eileanan Siar. Commercial clients in Sandwick use us for work on movement joints. Sandwick is one of 87 places we cover in Na h-Eileanan Siar for movement joints.
Anyone looking for expansion joint sealing in HS1 and HS2 gets the same process as the rest of our area: send details, get a quote, we seal, guaranteed. Buildings on Stoneyfield, East Street and Olivers Brae are within our area for movement joints. Just outside Sandwick, we also work in Plasterfield (1 mile north), Sanndabhaig (1 mile east), Steinis (1 mile north), Stornoway (1 mile north-west) and Branahuie (1 mile east). For island and remote sites, we plan travel and materials carefully, so include the location in your enquiry.
Landmarks near Sandwick
A little further out are Western Isles Hospital (1.5 miles north-west) and Lewis Loom Centre (1.3 miles west). Not far away are Loch Àirigh na Lic.
When something else is needed
A few problems need another trade or a different fix, and we point that out rather than sealing over them:
- Failed waterproofing membranes on podiums, roofs or decks (a waterproofing specialist’s job)
- Joints too narrow for the movement, which need redesigning by the engineer
- Movement on a scale no sealant is meant to absorb
If in doubt, ring 01277 525 020 or email a schedule or drawings and we’ll say what we think.
What we seal
- Brickwork movement joints
- Podiums and floor movement joints
- Blockwork control joints
- Car park decks and ramps
- Precast concrete panel joints
- Cladding panel joints
Doing it in-house
Redoing a failed joint usually costs more than getting it right at the outset, since all of it has to come out and the faces be cleaned back again. That’s why many clients bring in a specialist from the beginning.
Paperwork matters too. Main contractors and clients often ask for CSCS cards, RAMS and insurance details, and we will confirm the paperwork you need with the quote.