Expansion joint sealing in Oban
Expansion and movement joint sealing in walls, decks and floors throughout Oban and nearby, by CSCS-carded applicators. Fully insured and CHAS accredited.
- Spalled or broken joint edges in floors and decks
- Weathered movement joint sealant that no longer flexes
- Joints packed with grit and debris
Expansion joint sealing for Oban sites
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Expansion joint sealing in Oban, done properly
Few joints take as much punishment as those in a car park. Tyres load the edges, and de-icing salts and water work into any gap, so failed seals soon lead to leaks onto the level below and broken edges. We reseal deck and ramp joints with a trafficable sealant chosen for the movement. We work on blockwork control joints, podiums and floor movement joints and cladding panel joints, and the failures we are asked to look at most are new sealant over old, now failing and movement joints with split or torn sealant. Looking for mastic applicators who cover Oban? We’ve been sealing commercial buildings since 2005, CHAS accredited and a Constructionline member.
Travel to smaller places like Oban is planned so the work is done in one trip where possible. Photos, approximate widths and what uses the floor help us bring the right materials.
We stand by our work: 12 months, guaranteed. It covers how we prepared and applied the sealant.
- Place
- Oban (PA34)
- Region
- Argyll and Bute
- Guarantee
- 12 months on our workmanship
- Quote
- A fixed quote before we start
- Telephone
- 01277 525 020
- Updated
- 3 November 2026
How the job changes by surface
Cladding panel joints
Access to cladding joints is agreed before the price is fixed. Close-up photographs help us judge the joints or a site visit fills the gaps.
Internal floor movement joints
Warehouse and retail floors have saw-cut induced joints and construction joints. Trafficked floor joints often get a semi-rigid filler.
Traffic, movement and joints around Oban
The sea is no more than about 1 mile from Oban. Open joints in coastal car parks and yards let in salt-laden water as well as grit, so a failed joint lets more in and the edges break up sooner. Oban is on Scotland’s wetter western side. External slab joints left open take plenty of rain. We wait for dry, workable days to seal them.
In a school such as Oban High School, movement joints in brick, block and hall floors tend to be forgotten until they leak.
Oban is in Argyll and Bute. Our applicators travel to Oban for work on movement joints, handled exactly as we handle every other area. Our Argyll and Bute coverage takes in 124 places, from busy centres to rural villages. Our Glasgow page has more on work in that area.
Anyone looking for expansion joint sealing in PA34 gets the same process as the rest of our area: send details, get a quote, we seal, guaranteed. If your site is on Market Street, High Street and Argyll Square or close by, we can quote for movement joints. Oban sits on or close to the A85 and A816, which helps when planning parking and deliveries for the job. If your building is just outside Oban, we cover Dunollie (1 mile north), Ganavan (2 miles north), Dunbeg (3 miles north), Kilmore (3 miles south-east) and Connel (4 miles north-east). As one of the bigger centres in Argyll and Bute, Oban has a broad mix of commercial, public and industrial buildings, and we cover them all. Island and remote sites need extra planning, with travel, ferry crossings where needed and weather to allow for, so mention the location when you speak to us on 01277 525 020 or email drawings and photos.
Landmarks near Oban
Recent enquiries here include premises near Caledonian Hotel. There’s a railway station in Oban itself: Oban station. Well-known places in the area include Oban Museum (0.6 miles north) and Dunollie Castle (1.2 miles north-west). Green spaces nearby include Lochan Dubh.
Our process
Our CSCS-carded applicators arrive with the sealants, primers and backing rod the job calls for. Joint faces are cleaned back to sound, dry surfaces, the manufacturer’s primer is applied where it’s called for, and each bead is tooled to a neat concave finish. Travel to smaller Scottish places like Oban is planned so the job is finished in one visit where possible, so photographs, sizes and a full list matter. Outside work also needs a suitable weather window.
- First, the joints are inspected for width, movement and the type of failure.
- You get a fixed quote with the product and its movement capability stated.
- The failed seal is removed and both faces are cleaned until sound and dry, and we tell you if any edges need repairing first.
- Backing rod goes in at the right depth, or bond-breaker tape where the joint is shallow.
- Primer goes on where the manufacturer specifies it, followed by the sealant, which is then tooled off.
- Finished joints are checked and backed by our 12-month guarantee.
Before we start on site
- Send your site hours and access windows
- Make sure the joints can be reached
- Point out any areas we must not close
Get a fixed quote
Specifications, drawings and tender packages are welcome with any enquiry, and we’ll price the work to it. Smaller jobs need nothing more than photographs and a few notes.
Read more
When to call us in Oban
When a bead pulls away from one face, it has lost adhesion. Dusty, damp or contaminated faces, a missing primer and three-sided adhesion are the usual causes and it often shows on rushed work.
Common reasons buildings call us in:
- Water getting into the wall through a failed joint
- Layers of sealant in a movement joint
- Expansion joints filled with dirt and stones
- Water dripping through deck or ramp joints
For an estate such as Lorn and Islands Hospital, which lies south of Oban, the joints in ramps, decks and long building elevations all need attention over time.
Before you book anyone
- What site paperwork they can supply
- Is the sealant right for the movement and the substrate?
- How long is the guarantee, and what does it include?
- Do they follow the manufacturer’s priming guidance?
What else we do in Oban
Building owners, agents and FMs in Oban
For main contractors, we work as the sealant subcontractor, on new build and refurbishment alike. Programme, specification and site rules come first.
If you look after buildings for someone else, you need clear quotes and clear reporting. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative.
Why act early in Oban
A like-for-like reseal of a joint that keeps splitting rarely lasts. A higher movement class, or a design change by the engineer, may be needed. Around smaller places like Oban, halls, stores and seasonal buildings may not be checked often, so a failed joint has time to cause damage. Resealing early avoids that.
Every site prices differently: joint size, product, access and site hours all play a part. Send the details and a fixed figure follows.
Why appoint us
- Public liability insurance in place
- Colour agreed before work starts
- Sealing commercial buildings since 2005
- 12 months’ guarantee on every job
Take a look at what affects the cost and our accreditations and insurance.
FAQs: Oban
Does the sea air around Oban change the choice of sealant?
It can, yes: buildings near the sea take more wind-driven rain, and salt in the air nearer the shore. We check the specified product suits the exposure and pay close attention to preparation.
Can you take on a job at a hospital such as Lorn and Islands Hospital?
Yes, healthcare and care buildings are part of our work. We follow the site’s permits, sign-in and infection-control procedures in every area.
Can you fit around our working hours?
We are in the office from 8am until 5pm, Monday to Friday. Tell us your site hours and access windows and the work will be fitted around them.
What sealant do you use in movement joints?
Whatever suits the joint and the specification. The quote states the sealant and its movement class so there are no surprises.
Can you work while the building is occupied?
Usually, yes. We phase the work so most of the building stays in use.
Can you send site paperwork?
Requirements differ from site to site, so list what you need, whether RAMS, insurance or CSCS details, and we will confirm with the quote.
Do you need to see the site first?
That depends on the size and complexity of the job. Straightforward work can often be priced from photos and measurements, and bigger or more complex jobs typically get a visit.
What sealant work can’t fix
Before quoting, we check that sealant is the right answer. It isn’t the answer for:
- Cracking or settlement that calls for an engineer’s assessment
- Changing the joint layout or spacing of a structure
- Proprietary pre-formed expansion joint systems
If in doubt, ring 01277 525 020 or use the quote form and we will say what we think.
What we seal
- Podiums and floor movement joints
- Blockwork control joints
- Precast concrete panel joints
- Cladding panel joints
- Car park decks and ramps
- Brickwork movement joints