Expansion joint sealing in Curteis' Corner
Expansion joint sealing for Curteis' Corner, from a contractor working since 2005. Fully insured and CHAS accredited.
- Damp inside where a wall movement joint has failed
- Expansion joints split through the centre of the bead
- Sealant pulling off the joint face
Expansion joint sealing across Curteis' Corner
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
About our expansion joint sealing in Curteis' Corner
We cover the full range of movement joints: vertical joints in brick and block facades, joints between precast or cladding panels, concrete slab and deck joints, ramps, podiums and internal floors. The product depends on the movement, the weather and anything that runs over it, and we’ll confirm the choice in the quote. The enquiries we see most involve hardened, cracked sealant on exposed facades and water getting into the wall through a failed joint, across brickwork movement joints, blockwork control joints and cladding panel joints. Whether you call it commercial sealant work, mastic application or joint sealing, in Curteis' Corner it comes down to the same thing: failed joints cut out, faces prepared and the right sealant laid to the right depth.
Smaller community and commercial buildings around Curteis' Corner have their own movement joints in walls and floors. They tend to be overlooked until something leaks or cracks.
Every job is signed off with a 12-month guarantee. It’s a plain promise: if our work fails within that year, we put it right.
- Place
- Curteis' Corner (TN27)
- Region
- Kent
- Guarantee
- 12 months on our workmanship
- Quote
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Do you need expansion joint sealing in Curteis' Corner?
Sealant peeling cleanly off one side is an adhesion failure. Poor preparation, a skipped primer, or sealant bonded to the back of the joint are typical reasons and it often shows on rushed work.
Common reasons buildings call us in:
- Expansion joints filled with dirt and stones
- Arrises breaking up along floor joints
- Rain penetration at brick or block movement joints
- Torn sealant in brick or block movement joints
Large sites such as Benenden Hospital, 3 miles south-west of Curteis' Corner, have car parks, service roads and long elevations with movement joints in brick and panels.
What to look for in a quote
- What level of public liability insurance do they hold?
- The named product and why it was chosen
- Their approach to joint depth and backing
- How long is the guarantee, and what does it include?
On site: what to expect
A typical day starts with protection: tape along each joint edge and covers over finishes, stock and equipment close by. The work itself normally takes a short visit for a handful of joints, or several days or more for a car park deck or long runs of facade joints, and we clear our waste as we work. Smaller jobs around Curteis' Corner can be grouped with others nearby, which keeps travel down. A fixed quote is given before anything starts.
- First the joints are inspected, widths measured and the type of failure noted.
- A fixed quote names the sealant we propose and its movement class.
- Where areas have to stay open, we agree a phased sequence before starting.
- We strip the old sealant or filler and prepare each face until it’s sound and dry.
- Depth is controlled with backing, the faces are primed where the maker calls for it, then the bead is laid and tooled.
- Finished joints are inspected, the cure time confirmed and the 12-month guarantee applies.
Getting the site ready
- Clear stock, furniture or equipment away from the joints
- Tell us which areas need to stay in use
- Send any specification or drawings in advance
Quotes
Every quote starts with the facts: the joints involved, quantities, access and the product called for. Send what you have, and we will arrange a site visit if anything is unclear.
Read more
Places near Curteis' Corner
More services for Curteis' Corner
Looking after the joints
Once the work is signed off, these steps help:
- Inspect exposed joints once the cold weather has passed
- Reopen bays and walkways only after the stated cure time
- Record the sealant used and the date in the O&M file
- Report split or peeling joint sealant early
Grit is the slow enemy of a joint seal. Stones pressed into the bead by wheels or feet can puncture it, especially on car park decks and warehouse floors. A routine sweep is the simplest protection.
Unsupported floor joint edges spall under forklift and pallet-truck wheels. Damaged edges make the floor rough and wear wheels faster. Keeping the filler or sealant sound protects the floor.
What sealant work can’t fix
Sealant solves a lot, but not everything, and we’d rather tell you before you spend money. These need a different solution:
- Changing the joint layout or spacing of a structure
- Broken or spalled joint edges, which need repairing before any sealant goes in
- Failed waterproofing membranes on podiums, roofs or decks (a waterproofing specialist’s job)
Not sure which it is? You can phone 01277 525 020 or email us and we will tell you honestly.
Joints and surfaces we work on
- Cladding panel joints
- Precast concrete panel joints
- Brickwork movement joints
- Car park decks and ramps
- Podiums and floor movement joints
- Blockwork control joints
Owners, agents and contractors
Facilities managers want contractors who arrive with the paperwork sorted. Let us know the documents you need (RAMS, insurance certificate, CSCS details) and we will confirm them with the quote.
Main contractors use us as their sealant subcontractor on new-build and refurbishment projects. We work to your programme, your specification and your site rules, and our applicators hold CSCS cards.
Expansion joint sealing in Curteis' Corner: the local picture
Curteis' Corner sits in one of the drier corners of the country, the South East. Outside joints in yards and car parks still have to be dry before sealing, and gritting in cold spells finds its way into open joints. Curteis' Corner is about 41 miles from central London. The South East has large numbers of industrial estates and warehouses along the motorway corridors, and their floor joints take forklift and pallet-truck traffic all day.
Schools such as John Mayne Church of England Primary School have movement joints in their walls and floors that are easy to overlook.
Curteis' Corner is about 10 miles west of Ashford, in Kent. We cover Curteis' Corner, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. 931 places across Kent fall within our area, Curteis' Corner among them. Our Brighton page has more on work in that area.
We cover the TN27 postcode districts. If your site is on Headcorn Road, Smarden Road and Cot Lane or close by, we can quote for movement joints. Nearby places we also cover include Standen (1 mile north-east), Biddenden (1 mile south-west), Lashenden (1 mile north), Stede Quarter (1 mile south-east) and Hareplain (1 mile west). A short drive away, we cover Maidstone (11 miles north-west), Ashford (10 miles east), Kings Hill (15 miles north-west), Foley Park (12 miles north-west), Paddock Wood (12 miles west) and Tenterden (4 miles south-east).
Landmarks near Curteis' Corner
We work on buildings around The Red Lion Inn and the streets around them. For rail, the closest station is Headcorn station, roughly 2.9 miles north of the centre. A little further out are Sissinghurst Castle (3 miles west) and Benenden Hospital (3 miles south-west).
Questions we are asked in Curteis' Corner
Is Curteis' Corner off your patch?
Not at all. Curteis' Corner is within our area. We work across Greater London and the South East. Where we can, we group nearby jobs to make the most of each trip.
Do we have to stop operations in Curteis' Corner while the joints are sealed?
In most cases the site keeps working. Joints are done in phases, a bay, aisle or deck at a time. The phasing plan comes with the quote.
What happens if old sealant might contain asbestos?
Asbestos is possible in some older mastics, particularly in buildings from before 2000. Before we disturb old sealant in an older building, we ask to see the asbestos register or survey, and work stops until any suspect material has been tested. We don’t remove asbestos-containing materials.
Do you take on small jobs?
Small jobs are welcome alongside larger packages. Send details for a fixed quote.
How do we ask for a quote?
There are four steps: send details, receive a fixed quote, we carry out the work, and it’s guaranteed. The first step only needs photos and a postcode.
How much does the work cost?
It depends on the job: quantities, access, the product and any phasing. Call for a quote and we’ll price it properly.
Do you seal on top of existing sealant?
No. We cut the old material out and clean the joint back before sealing, since fresh sealant will not bond reliably to aged material.
When to bring in a specialist
Some joints are best left to specialists: for example fire-rated seals that must match a tested detail, trafficked floor joints and external movement joints. Getting these wrong usually costs more in the end than doing them right.
Site maintenance staff can often handle a short internal joint. The usual problems come from preparation: new sealant over old, damp or dusty faces, or the wrong product for the movement.