Expansion Joint Sealing in Bekesbourne Hill
Expansion and movement joint sealing in walls, decks and floors throughout Bekesbourne Hill and nearby, carried out by CSCS-carded applicators. Fully insured and CHAS accredited.
- Leaks through car park deck joints onto the level below
- Chipped joint edges on forklift routes
- Water getting into the wall through a failed joint
Expansion joint sealing for businesses in Bekesbourne Hill
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Expansion joint sealing for commercial buildings in Bekesbourne Hill
We cover the full range of movement joints: brickwork and blockwork joints, precast and cladding panel joints, concrete joints, car park decks and ramps, podiums and floor movement joints. The product depends on the movement, the weather and anything that runs over it, and we will confirm the choice in the quote. If you’re dealing with water getting into the wall through a failed joint and movement joints with split or torn sealant, we can put it right, whatever the surface. A single leaking joint is often how a building in Bekesbourne Hill first comes to us: we look at the rest while we are there and tell you what we find.
Jobs around smaller places like Bekesbourne Hill are planned so the whole job is done in one visit, with the right materials on hand. Note joint widths and the traffic that uses them, and we’ll take it from there.
The 12-month guarantee covers our workmanship: the preparation, the sealing and the tooling. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Where
- Bekesbourne Hill (CT4)
- Wider area
- Kent
- Cover
- A 12-month guarantee
- Quotes
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
What sealant work can’t fix
Honesty saves time and money. Fresh joints won’t solve:
- Concrete or masonry repairs along the arrises
- Structural movement beyond what the joints were designed for (that needs a structural engineer)
- Waterproofing layers buried beneath the sealant
Not sure which it is? You can ring 01277 525 020 or email a schedule or drawings and we will tell you honestly before you book.
Joints and surfaces we work on
- Precast concrete panel joints
- Brickwork movement joints
- Car park decks and ramps
- Cladding panel joints
- Blockwork control joints
- Podiums and floor movement joints
For managing agents and facilities managers
Housing associations and managing agents often need work done across blocks and communal areas. Work can be phased so residents and staff keep access throughout, and each stage is agreed with your contact.
If you look after buildings for someone else, you need clear quotes and clear reporting. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative, plus a 12-month guarantee.
On site: what to expect
Working in a building that stays open takes some planning. We sign and contain the area we’re in, keep walkways clear and move on in phases so staff and visitors can carry on around us. For a building around Bekesbourne Hill, tell us how to find it and who will meet us. Send that with the details and we will confirm the plan with the quote.
- First the joints are inspected, widths measured and the type of failure noted.
- You receive a fixed quote stating the product and the movement it is rated for.
- Where areas have to stay open, we agree a phased sequence before starting.
- We strip the old sealant or filler and prepare each face until it’s sound and dry.
- Depth is controlled with backing, the faces are primed where the maker calls for it, then the bead is laid and tooled.
- Finished joints are inspected, the cure time confirmed and the 12-month guarantee applies.
Preparing the site
- Arrange parking or a loading space
- Share the asbestos register for older buildings
- Tell staff and tenants when we will be in
Quotes
The quickest route to a quote is a few photos and the site postcode. Upload them with the quote form, or speak to us on 01277 525 020 or email drawings and photos if you’d rather talk the job through.
Advice
Signs you need expansion joint sealing in Bekesbourne Hill
When the movement exceeds the sealant’s capability, the bead tears. A joint that’s too narrow for the movement, or a product with the wrong movement class, will split through the middle. The same product in the same joint tends to fail again unless width and product are reviewed.
Most enquiries start with one or more of the following:
- Movement joints with split or torn sealant
- Arrises breaking up along floor joints
- Layers of sealant in a movement joint
- Sealant peeling off one face of the joint
For an estate such as Saint Martin's Hospital, 1.6 miles north-west of Bekesbourne Hill, the joints in ramps, decks and long building elevations all need attention over time.
Questions to ask before you book
- Is the sealant right for the movement and the substrate?
- How they handle RAMS and site documents
- What level of public liability insurance do they hold?
- How long is the guarantee, and what does it include?
Questions we’re asked in Bekesbourne Hill
Can you take on a job at a hospital such as Saint Martin's Hospital?
Yes. Healthcare sites are among the places we work. Before anything starts, the estates team agrees permits, inductions and infection-control measures with us.
Is a smaller place like Bekesbourne Hill outside your area?
Not at all: smaller places are covered as well as towns. Our area covers London and the South East counties. Send photos and a list of what needs doing, and we will plan the job to need as few trips as possible.
What happens if old sealant might contain asbestos?
Managing asbestos is the dutyholder’s responsibility, so for older buildings we ask for the asbestos register first. If anything suspect turns up, we stop until it’s tested.
Is movement joint sealing guaranteed?
It’s backed by our 12-month guarantee. Tell us right away if a joint we sealed gives trouble in that time.
Do you seal on top of existing sealant?
No, never. Overlaying old sealant is a frequent cause of early failure, so it all comes out first.
Do you work to architects’ specifications?
Yes. Include it with the drawings when you ask for a quote, and the quote will be based on it.
How long do sealant joints last?
It depends on movement, UV and weather, cleaning, traffic and the product. Sealant joints are maintenance items, so inspect them regularly.
Leave it or put it right?
Patching the worst lengths of a joint can make sense short term. The remaining sealant is often close to failing too and repeated access costs add up. Where it helps, we quote both options. For buildings around smaller places like Bekesbourne Hill, water damage can go unnoticed for longer, especially where a building isn’t used daily, so a failed joint can leak for a while before anyone sees it. Resealing early avoids that.
Whether it’s a single area or a whole estate, the same things set the price: scope, access, product and programme. Call for a quote, and you will have a fixed figure to work with.
Why appoint us
- Colours confirmed for the specified product
- Fixed quotes based on photos, drawings or a visit
- Our applicators hold CSCS cards
- Sealing commercial buildings since 2005
Read how commercial sealant jobs are priced and our accreditations.
How the job changes by surface
Brickwork and blockwork joints
Masonry faces are often porous, dusty or crumbly. Faces are prepared and primed wherever the sealant maker calls for it before the bead goes in.
Joints between different materials
Some mixed-material joints suit a hybrid sealant. We pick the product for the materials and the movement.
Warehouse floors and decks around Bekesbourne Hill
The South East is one of the drier parts of the UK. Even so, yard and car park joints are only sealed when they’re dry and clean, and where de-icing salt is spread in winter, open joints let it in. Bekesbourne Hill is about 56 miles from central London. The roads out of London are lined with trade parks and distribution sheds.
Schools like Bridge and Patrixbourne Church of England Primary School often have long brick elevations with movement joints that age quietly. On a site such as Canterbury Business Park, 1.6 miles south of Bekesbourne Hill, the movement joints are in car park slabs, paving and building elevations.
Bekesbourne Hill is about 3 miles south-east of Canterbury, in Kent. We cover Bekesbourne Hill and the rest of Kent, with the same fixed quotes and 12-month guarantee as everywhere else. Across Kent, 931 places are covered, Bekesbourne Hill among them. For work in that direction, see our London page (56 miles or so).
Work on movement joints is covered throughout CT4, whatever the building. We cover commercial and managed buildings on Bekesbourne Hill and Oakleigh Lane. Nearby places we also cover include Patrixbourne (1 mile south), Bekesbourne (1 mile south-east), Bridge (1 mile south-west), Littlebourne (2 miles north-east) and Bishopsbourne (2 miles south) for movement joints. Further afield, our area takes in Ashford (14 miles south-west), Canterbury (3 miles north-west), Margate (13 miles north-east), Dover (11 miles south-east), Folkestone (12 miles south) and Ramsgate (13 miles north-east).
Landmarks near Bekesbourne Hill
Around Bekesbourne Hill, our work takes us to commercial buildings near Chequer's Wood and Old Park and St. Anselm's Catholic School, among other places. There’s a railway station in Bekesbourne Hill itself: Bekesbourne station. A little further out are Canterbury Roman Museum (2.6 miles north-west) and St Martins Hospital (1.6 miles north-west). Green spaces nearby include Blean Woods RSPB Reserve.