Washroom Sealing contractors in Broadsea
Our CSCS-carded applicators take on sealing in commercial washrooms, showers, kitchens and wet areas in Broadsea. Send details for a fixed quote.
- Sealant laid over old silicone and now peeling
- Failed sealant in a tea point or staff kitchen
- Open joints along basins and vanity units
Washroom sealing near Broadsea
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
After the work
To get the most from the new sealant:
- Squeegee showers and trays after busy periods
- Tell us about infection-control or permit rules before we quote
- Include joints in routine washroom inspections
- Respect the cure time before reopening each room
Ask your cleaning team to use gentle products and soft cloths on sealant. Aggressive descalers, solvents and scouring pads shorten its life and give mould a start.
Leaks through tray and wet-floor joints can go unseen until a ceiling marks below. At that stage, boards or ceilings may need repair, so reseal when you first spot a split.
About our washroom sealing in Broadsea
From one staff toilet in Broadsea to washrooms across a whole estate, the route is the same: send details, get a fixed quote, we seal, guaranteed. A few photographs and a count of fittings are enough for a quick quote, or we can arrange a visit. We work on IPS panels and cubicles, accessible toilets and changing rooms and vanity units and basins, and the failures we’re asked to look at most are sealant lifting along a tray edge and mould spotting along silicone joints. One point of contact handles commercial sealant work in Broadsea from the first photographs to the final walk-round, whether it’s one building or several.
In smaller Scottish places like Broadsea, commercial washrooms are typically in hotels, pubs, schools, care homes and community halls. Mould grows into sealant in any wet room that doesn’t dry out, and the answer is removal and a fresh bead of anti-mould silicone.
Work we carry out comes with a 12-month guarantee. Should something we installed fail, speak to us on 01277 525 020 or send details through our quote form and we will come back to it.
- Location
- Broadsea (AB43)
- Wider area
- Aberdeenshire
- Cover
- 12 months on every job
- Quotes
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Updated
- 3 November 2026
Nearby places to Broadsea
Also in Broadsea
Site staff or a sealant specialist?
Site maintenance staff can often handle a short internal joint. Where it goes wrong is preparation: sealing over old material, sealing onto damp or dusty surfaces, or a product that can’t take the movement.
The visible bead is only part of the job. Backing rod, primer where specified and a joint designed to move with the building are easy to get wrong without experience.
When something else is needed
We seal joints; we don’t mend everything behind them. On its own, sealant can’t deal with:
- Leaking pipes, traps, wastes or cisterns, which need a plumber
- Water escaping beneath the floor rather than through a joint
- Hollow tiles or loose panels behind the joint
Not sure which it is? You can call the office on 01277 525 020 or email a schedule or drawings and we will tell you honestly.
What we seal
- Kitchens and tea points
- Accessible toilets and changing rooms
- IPS panels and cubicles
- Urinals and WCs
- Showers, trays and wet room floors
- Vanity units and basins
Why deal with it now?
Running fresh silicone along a failed bead hides the problem briefly. Silicone won’t grip silicone, so it lifts and holds moisture underneath. Full removal and proper cleaning is what makes the new joint last. In Scotland, wind-driven rain finds a failed joint quickly, and for a smaller place like Broadsea, a repair visit takes planning, so it’s better to act early.
Every site prices differently: the joint sizes, the specified product, access and working hours each have a bearing. Send the details and a fixed figure follows.
Why clients in Broadsea choose us
- Constructionline member for supplier checks
- Fully insured, including public liability cover
- Joints cleaned back to sound surfaces
- A fixed quote before work starts
Take a look at our cost guide and our accreditations and insurance.
Sanitary sealant for Broadsea buildings
The sea is no more than about 1 mile from Broadsea, and places by the sea often rely on visitors, so their hotels and holiday lets see heavy seasonal use. Showers and en suites in constant use are where silicone moulds and splits first, and the quieter months are the natural time to reseal. Broadsea has two care or nursing homes no more than 2 miles away. Care home wet rooms and en suites are used every day and cleaned hard, which tells on the silicone. We plan the work with the manager so residents are disturbed as little as possible.
Pupil toilets at schools like Fraserburgh Academy take heavy daily use, and the holidays give the window to reseal. Where you are responsible for a hall attached to a building such as St Peter's Episcopal Church, its kitchen and toilets need sealant that stays cleanable.
Broadsea is about 1 mile north of Fraserburgh, in Aberdeenshire. Our applicators travel to Broadsea for work on washrooms and wet areas, handled exactly as we handle every other area. Our Aberdeenshire coverage takes in 179 places. There’s a separate page for Aberdeen, roughly 38 miles from Broadsea.
We cover the AB43 postcode districts. Among the streets we cover are Albert Lane, Main Street and Marconi Road. You will find Broadsea on or near the A98, so getting applicators and materials to site is simple. Close to Broadsea, our area also takes in Fraserburgh (1 mile south), Sandhaven (2 miles west), Pittulie (2 miles west), Memsie (3 miles south) and Inverallochy (3 miles south-east). Bigger towns within reach include Peterhead (15 miles south-east), Mintlaw (12 miles south), Longside (13 miles south), Strichen (8 miles south), Buchanhaven (15 miles south-east) and Gardenstown (12 miles west).
Around Broadsea
Locally, jobs take us to sites close to The Saltoun Inn and the streets around them. A little further out are Kinnaird Head Castle (0.7 miles east) and Fraserburgh Hospital (0.5 miles south).
Questions about Broadsea
Could you schedule work at a campus like North East Scotland College - Fraserburgh Campus for the vacation?
Yes. Tell us the term dates, vacation periods and access windows, and we will plan the work around them. We’re CHAS accredited and a Constructionline member, and paperwork such as RAMS is confirmed with the quote.
Do you take on work at healthcare sites like Fraserburgh Hospital?
Yes, healthcare and care buildings are part of our work. Each area is agreed with the ward or department and the estates team in advance.
What do you charge?
It depends on the job: quantities, access, the product and any phasing. Call for a fixed quote and we’ll price it properly.
Can you send site paperwork?
Let us know which documents the site needs, such as RAMS, an insurance certificate or CSCS details, and we’ll confirm them with the quote.
Does the weather affect the work?
Outside, yes. The joint has to be dry and within the product’s temperature range, so damp, frosty or very cold days can stop external work. Inside work is seldom held up.
Can you clean the mould off instead of resealing?
Cleaning may lighten it, but the mould returns. We replace the sealant with an anti-mould sanitary grade and check the ventilation isn’t the cause.
What guarantee comes with washroom resealing?
There is a 12-month guarantee on our workmanship, and we carry public liability insurance.
When to call us in Broadsea
Washrooms are warm, damp and full of organic residue, and sealant joints trap all three. Even anti-mould grades can be colonised over time where extraction is poor.
These are often picked up first by site or facilities staff:
- Gaps where vanity tops meet the wall
- Panel joints letting water behind
- Washrooms that look worn because of the sealant
- Split or peeling sealant at shower trays
For a college such as North East Scotland College - Fraserburgh Campus, 0.7 miles south of Broadsea, half-term and summer give the windows for washroom work.
What to look for in a quote
- Health and safety accreditation such as CHAS
- Their plan for phasing and protecting the area
- Proof of insurance
- Who will actually carry out the work
Our process
A typical day starts with protection: tape along each joint edge and covers over finishes, stock and equipment close by. The work itself typically takes half a day to a day per washroom, depending on the number of fittings, and we clear our waste as we work. For work around Broadsea, we aim for one trip, so photos, sizes and a full list matter. Outside work also needs a suitable weather window.
- First, the phasing is agreed so facilities stay open.
- Anything behind the joints that needs another trade is flagged.
- Failed sealant and residue are stripped out.
- We reseal with the grade suited to each area.
- We give you a reopening time for every room.
What we need from you
- Let us know about inductions and permits
- Point out parking and an unloading spot
- Clear stock, furniture or equipment away from the joints
Ask for a quote
Pricing a project or setting a maintenance budget? Send the scope and any drawings, and we’ll return a fixed quote you can plan around. If you have questions first, ring 01277 525 020 or email drawings and photos.