The Mastic Doctor team standing beside their branded vans outside an office building
Hampshire · England

Stroud floor joint sealing

Looking for floor joint sealing in Stroud? Send us the details for a fixed quote, backed by a 12-month guarantee on the work.

  • Scruffy, dirty joint lines on a shop or showroom floor
  • Filler that has parted from one face
  • Saw-cut joints left open and packed with grit
1
Send details
Drawings, photos, a joint schedule or a site visit.
2
Get a quote
Scope agreed and priced before anything starts.
3
We seal
The right sealant, to the right depth, neatly finished.
4
Guaranteed
Signed off, with 12 months’ guarantee.
Covering the South East & Scotland
CHAS & Constructionline
£5m PL insurance

Floor joint sealing in Stroud

Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.

Floor joint sealing for commercial buildings in Stroud

Sometimes the concrete either side of a joint has already spalled. Filling against a crumbled arris won’t hold for long, so we’ll tell you if the joint edges need repairing first and leave that decision with you. If you have unfilled floor joints collecting dirt and grit and broken arrises where pallet trucks cross, we can put it right, whatever the surface. Sealant contractors, mastic applicators, sealant specialists: whatever the job title on the order, the work in Stroud is the same: the right product in a properly prepared joint.

Around smaller places such as Stroud, floor joints are often in barns and farm buildings turned into workshops, stores and offices. Whether it’s a farm store turned workshop or a storage unit, the joints need a product that suits the traffic.

Guaranteed is the last step of every job. Our workmanship is backed for 12 months, and the quote explains what it covers.

Where
Stroud (GU32)
Wider area
Hampshire
Cover
12 months on our workmanship
Quotes
Fixed quote, scope in writing
Call
01277 525 020
Updated
3 November 2026
The Mastic Doctor team standing beside their branded vans outside an office building

How a job runs

Before we leave any area, we remove the tape, clean down and inspect every joint, ready for your sign-off. Where the sealant needs time to cure before use, we tell you and sign the area. Rural sites near Stroud may need directions, gate codes or a contact on site. Add it to your enquiry and we’ll build it into the plan.

  1. First comes a walk of the floor to record joint sizes, broken edges and traffic routes.
  2. A fixed quote follows, listing the treatment for each area and the order of work.
  3. We remove failed material and packed debris until sound concrete is exposed on both faces.
  4. Dust is sucked out of the joint and a primer used if the product data sheet asks for one.
  5. We fill each joint to depth and finish it flush so wheels roll straight across.
  6. We tell you when each zone can carry trucks again and move on to the next.

Preparing the site

  • Tell us your opening times and when work is allowed
  • For older buildings, check the asbestos register before work
  • Warn occupants and staff about the work

Getting a fixed quote

We quote a fixed sum against the scope you give us, so the cost is agreed before work starts. To ask for one, ring 01277 525 020 or send photos by email.

Get a price

Advice

Questions we are asked in Stroud

Is Stroud too far out for you?

Not at all: smaller places are covered as well as towns. We work across Greater London and the South East. We plan jobs in smaller places so return trips are kept to a minimum.

Is hospital work, at somewhere like Petersfield Hospital, something you do?

Yes, provided the work is planned with the site’s estates team. Each area is agreed with the ward or department and the estates team in advance.

What happens if the joint edges are damaged?

Edge condition is recorded when we look at the floor. Where they have broken away, we’ll tell you before quoting the filling so the filling isn’t wasted.

How long before trucks can use the joints?

Cure times vary with the product and how cold the slab is. We’ll give you a time for each zone before we start.

How do you choose the sealant?

The specification comes first, if there is one. If there isn’t one, it comes down to the joint: its movement, its surfaces and what it has to cope with.

Can you work to our specification?

Yes. The specification and the manufacturer’s installation guidance are what we work to, and any queries are raised before we start.

Are you insured?

Yes. Our insurance certificate can be sent alongside the quote.

When it isn’t the sealant

Before quoting, we check that sealant is the right answer. It won’t put right:

  • Unstable slabs moving under traffic
  • A floor that is out of level for the racking or trucks
  • Worn screed or surface finishes

If you are not sure, just give us a call on 01277 525 020 or email the details over and we’ll give you a straight answer before you book.

Joints and surfaces we work on

  • Loading bays
  • Retail and showroom floors
  • Saw-cut induced joints
  • Joints along racking aisles
  • Forklift and pallet-truck routes
  • Construction joints

Aftercare for building managers

Problems stay small when the joints are checked regularly. Specifically:

  • Check joint lines on busy aisles regularly
  • Treat loading bay joints first if they’re failing
  • Photograph any joint that starts to chip
  • Clear packed debris from open joints regularly

Ask drivers not to drag forks or pallets along the floor. Steel tines will mark a good joint over time.

Joint damage starts slowly and then speeds up. Each chip makes the drop deeper and the next impact harder, so it pays to act at the first signs.

What we’re called out for in Stroud

Loading bay joints are exposed to wind, wet tyres and bigger temperature swings, as well as the tightest turning loads. That is normally where joint failure starts.

These are often picked up first by site or facilities staff:

  • Joint fill separating from the concrete
  • Joint edges breaking up under truck wheels
  • Open saw cuts full of debris
  • Old filler gone hard, cracked or loose

Hospital campuses such as Petersfield Hospital (to the east of Stroud) grow in stages, leaving movement joints wherever new blocks meet old.

What to look for in a quote

  • Is depth set with backing rod, or bond-breaker tape in shallow joints?
  • How the existing material will be dealt with
  • Whether primer will be used where the manufacturer specifies it
  • Will RAMS and insurance details be available?

How to choose a sealant contractor

Leave it or put it right?

A floor coating laid over open joints soon cracks along the joint lines. The joints have to be filled or sealed as joints before or alongside any coating work. One visit to deal with every failing joint makes more sense than several trips to a place like Stroud. Photos of every joint help us quote for the whole job.

Whether it’s a single area or a whole estate, the same things set the price: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote, and you will have a fixed figure to work with.

Why choose Mastic Doctor in Stroud

  • Old sealant cut out, never sealed over
  • One number for every site we cover
  • Specification-led, product-correct work
  • Constructionline member for supplier checks

See our cost guide or our accreditations and insurance.

Traffic, movement and joints around Stroud

Stroud sits in one of the drier corners of the country, the South East. External joints still wait for dry conditions, and gritting in cold spells finds its way into open joints. At about 51 miles from central London, Stroud is within reach of the capital. Distribution warehouses and industrial estates are common around the motorway corridors that serve the capital, and their floor joints take forklift and pallet-truck traffic all day.

Schools such as Langrish Primary School have movement joints in their walls and floors that are easy to overlook.

Stroud is about 2 miles west of Petersfield, in Hampshire. Across the GU32 postcode area, the process is the same: send details, get a fixed quote, we seal, and the work is guaranteed. Our Hampshire coverage takes in 723 places. For work in that direction, see our Portsmouth page (15 miles or so).

Anyone looking for floor joint sealing in GU32 gets the same process as the rest of our area: details, then a fixed price, then sealing and a 12-month guarantee. For a building on Winchester Road, Stroudfields and Ramsdean Road or nearby, send details and we’ll quote for floor joints. Just outside Stroud, we also work in Langrish (1 mile west), Petersfield (2 miles east), Froxfield Green (2 miles north-west), Steep (2 miles north-east) and High Cross (2 miles north). Further afield, our area takes in Winchester (15 miles west), Havant (10 miles south), Fareham (15 miles south-west), Horndean (7 miles south), Alton (10 miles north) and Waterlooville (9 miles south).

Around Stroud

Recent enquiries here include premises near The Petersfield School, Morton House School and Seven Stars pub. The nearest railway station is Petersfield station, about 1.3 miles east of the centre. Nearby you’ll also find Petersfield Community Hospital (1.3 miles east) and Clanfield Earthwork (4.2 miles south). Open spaces near Stroud include Liss Riverside Railway Walk South and Pidham Hill.

Map of Stroud © OpenStreetMap contributors

For managing agents and facilities managers

We work for building owners and managing agents on sealant work across single buildings or whole portfolios. Several sites can go on one quote, which keeps the paperwork simple.

As a CHAS accredited contractor and Constructionline member, we make supplier vetting simple. We are fully insured, and our insurance certificate can go with the quote.

Accreditations

Trusted. Accredited. Insured.