Fire-rated sealing and fire stopping in Tackley, Oxfordshire
Commercial sealant work in Tackley for contractors, FMs and building owners: fire-rated and intumescent sealing of service penetrations and linear gaps, with a fixed quote first.
- Builders’ foam or ordinary silicone in compartment walls
- Fire stopping installed outside its tested range
- Fire-stopping items raised at inspection or handover
Fire stopping for businesses in Tackley
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
After the work
Sealant joints are maintenance items, and how long they last depends on how they’re treated. We suggest:
- Foam or ordinary sealant is never a fire-seal repair
- Report damaged or disturbed seals as soon as they’re spotted
- Ask the designer to confirm details early on refits
- Brief every trade that openings they make must be sealed
Give the sealant its full cure time before ceilings, boxing or decoration go over it. Not every fire-rated product can be painted.
Ask every contractor who works in risers or voids to report openings they create. Small habits like this stop openings building up.
How we handle fire stopping in Tackley
The test standards are BS EN 1366-3 for penetration seals and BS EN 1366-4 for linear joints and the results are classified to BS EN 13501-2. A rating such as EI 60 only holds when the product is installed as it was tested. So our job is to reproduce that arrangement faithfully. If you are dealing with openings found when ceilings come down for a refit and old intumescent sealant that has split away, we can help. Most enquiries from Tackley start with one failed joint and grow into a wider look at the building: we check the joints around it and give you an honest view of what needs doing now and what can wait.
Smaller places such as Tackley still have buildings with fire-resisting walls and floors: schools, halls, care homes and commercial conversions. Any service penetration through those walls should be closed with the specified product, set out as its test evidence shows.
Every job is signed off with a 12-month guarantee. The promise is simple: if our work fails within that year, we put it right.
- Where
- Tackley (OX5)
- Wider area
- Oxfordshire
- Cover
- A 12-month guarantee
- Price
- Quoted before any work starts
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
How the job changes by surface
Masonry and concrete
Openings through concrete vary from tidy cores to rough break-outs. Each gap is measured where it is widest so we know it sits within the tested range.
Cables and cable bundles
Data cabling added after handover is a regular cause of open service penetrations. We reseal around them to the specified detail.
More services for Tackley
Owners, agents and contractors
Agents, factors and owners’ representatives all follow the same route: send details, get a fixed quote, we seal, guaranteed. We can agree access arrangements and keyholder contacts beforehand.
Building owners and managing agents use us on everything from one building to a spread of sites. Several sites can go on one quote, which keeps the paperwork simple.
Fire-rated sealing for Tackley buildings
At about 58 miles from central London, Tackley is within reach of the capital. Office refits around the commuter belt bring new cabling through fire-resisting walls. Fire stopping of openings and penetrations in England falls under Approved Document B. From 2 September 2029, BS 476 references are being taken out of Approved Document B, leaving BS EN 13501-2 classification as the route, subject to the Government’s transitional arrangements. Our part stays the same: the specified product, installed to its tested detail.
In a building such as Church of St Nicholas, any service penetration through a fire-resisting wall should be sealed to the specified detail. For a school such as Tackley Church of England Primary School, penetration sealing fits best at the end of the summer works.
Tackley is about 6 miles west of Bicester, in Oxfordshire. Businesses, contractors and managing agents in Tackley can call on us for service penetrations. 423 places across Oxfordshire fall within our area, Tackley among them. Sites around Oxford have their own page, roughly 10 miles from Tackley.
Work on service penetrations is covered throughout OX5, for business premises of every kind. Streets here include Nethercote Road, St Nicholas Road and St Johns Road. Sites close to Tackley are covered too, including Bunkers Hill (2 miles south), Shipton-on-Cherwell (2 miles south), Wootton (3 miles west), Thrupp (3 miles south) and Woodstock (3 miles south-west). Nearby towns on our patch include Oxford (10 miles south), Banbury (13 miles north), Bicester (6 miles east), Abingdon-on-Thames (14 miles south), Witney (10 miles south-west) and Carterton (15 miles south-west).
Landmarks near Tackley
We work on buildings around The Gardiner Arms and the streets around them. There’s a railway station in Tackley itself: Tackley station. A little further out are Soldiers of Oxfordshire Museum (3.4 miles south-west). The countryside around Tackley includes Woodsides Meadow.
How a job runs
Before any cutting starts, the area is protected: masking tape along the joint edges and sheeting over anything nearby. On site, the work normally takes anything from one day to a planned run of visits, depending on the number of seals and the access, and our waste is bagged and taken away as we go. Smaller jobs around Tackley can be grouped with others nearby, which keeps travel down. A fixed quote is given before anything starts.
- The specification and schedule come first, so we know which details apply.
- Access, permits and the order of areas are agreed with the site team.
- We compare every service penetration with its tested detail before sealing.
- Unsuitable material is removed and the opening cleaned.
- Backing and fire-rated sealant are installed to the detail and tooled.
- Anything outside the detail is reported to you rather than sealed.
Getting the site ready
- Let building users know which areas are affected
- Share the asbestos register for older buildings
- Agree which areas must stay open
Ask for a quote
The quickest route to a quote is a few photos and the site postcode. Send them through the quote form, or speak to us on 01277 525 020 or use the quote form if you’d rather talk the job through.
Related advice
Leave it or put it right?
Open service penetrations matter on ordinary days, not just in a fire: smoke, noise and draughts pass through them every day. Sealing them to the specified detail deals with the fire risk first, and the other benefits follow. Halls, stores and units around places like Tackley may not be checked every day, so a failed joint can leak for a while before anyone sees it. Resealing early avoids that.
Pricing service penetrations depends on how many there are, their condition and the access, plus any specification you are working to. Ask us for a fixed quote.
What you get with us
- Joints cleaned back to sound surfaces
- Products installed to the manufacturer’s instructions
- Fully insured
- Our applicators hold CSCS cards
See what affects the cost and our accreditations.
Questions about Tackley
What happens to BS 476 references for fire stopping in Tackley?
References to BS 476 classes are being removed from Approved Document B from 2 September 2029, after which BS EN 13501-2 classification is the route, subject to transitional arrangements. Whichever applies, we install the specified product to its tested detail; the specification is for the designer to set.
Do you decide the fire-stopping details for buildings in Tackley?
No. Fire-stopping design and sign-off belong to the designer, principal designer, fire engineer or building control. We install what’s specified, to the product’s tested detail.
When can you be on site?
Mention the site’s hours and access windows in your enquiry, and we’ll plan around them. Our office runs Monday to Friday, 8am until 5pm.
Who decides which product is used?
Where there’s a specification, we use the product it names. If not, we choose for the movement, the surfaces and the conditions, in line with the manufacturer’s guidance.
Can you quote from photographs?
Many jobs can be quoted from photos, drawings or a joint schedule. If the job needs a look first, we will arrange a visit before quoting.
How do you deal with asbestos in old sealant?
Some older mastics, especially in pre-2000 buildings, can contain asbestos. We check the asbestos register before cutting out old sealant in an older building, and if asbestos is suspected, work stops until it’s tested. We don’t remove asbestos-containing materials.
Do you work in Tackley?
Yes. Tackley falls within our area, and the simplest way to start is to phone 01277 525 020 or email the details over.
Cost factors for service penetrations
Each job is priced on its own details. The main factors are:
- The total length or number of joints
- Specialist products, such as fire-rated or hygienic sealants
- Access and working height
- Joint width, depth and condition
Whether it’s a single area or a whole estate, the same things set the price: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote and we’ll put a fixed figure on it.
Details that help us quote
We can often quote from photos and a few details. It helps to include:
- Access details, including height
- Rough lengths or quantities, or drawings if you have them
- Your programme or deadline
- The postcode of the building
A good quote starts with a clear picture: the joints involved, quantities, access and the product called for. Send what you have, and we will arrange a site visit if anything is unclear.