Fire Stopping in South Stour
Fire stopping in South Stour, backed by over 20 years in commercial sealing. Fully insured, with a 12-month guarantee.
- Unsealed openings around new pipes and cables
- Openings found when ceilings come down for a refit
- Snag lists that include open service penetrations
Need fire stopping in South Stour?
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
What the job involves on each surface
Cables and cable bundles
Single cables and small bundles are often within a fire-rated sealant’s tested detail. Bundle size, cable type and the space between cables all matter.
Plastic pipes
Plastic waste pipes through slabs come up often. The detail decides whether sealant alone is enough, and we’ll never swap a specified collar for sealant.
Fire stopping in South Stour
Every service that crosses a compartment wall or floor leaves an opening, and that opening needs sealing to hold back fire and smoke. Our job is fitting fire-rated and intumescent sealant at those service penetrations, and along linear gaps, where it is the specified product. Each seal follows the manufacturer’s tested detail, not a rule of thumb. If you have open linear gaps along the top of fire-resisting walls and seals disturbed by maintenance and left open, we can put it right, whatever the surface. Most enquiries from South Stour start with one failed joint and grow into a wider look at the building: we check the joints around it and give you an honest view of what needs doing now and what can wait.
Rural conversions around South Stour can put new fire-resisting partitions inside older structures. Where a pipe or cable passes through a fire-resisting wall, the seal must match the tested detail: product, substrate, gap and depth.
A 12-month guarantee applies to all our work. Should something we installed fail, phone 01277 525 020 or email us and we will come back to it.
- Where
- South Stour (TN25)
- Wider area
- Kent
- Cover
- A 12-month guarantee
- Quote
- Quoted before any work starts
- Phone
- 01277 525 020
- Updated
- 3 November 2026
FAQs: South Stour
What does the BS 476 change mean for fire-rated sealant in South Stour?
Approved Document B loses its BS 476 references from 2 September 2029, and BS EN 13501-2 becomes the route, subject to transitional arrangements. Our part doesn’t change: the specified product, to its tested detail.
Is hospital work, at somewhere like William Harvey Hospital (Ashford), something you do?
Yes, hospitals are one of the sectors we cover. Work is phased so departments keep running, under the site’s own rules.
Will you come and look before quoting?
It depends on the job. Straightforward work can often be priced from photographs and measurements, while larger or less clear jobs get a site visit first.
Is colour matching possible?
It depends on the product specified. Some ranges are wide, others limited, so we’ll confirm the colours available for the specified product with the quote.
Will your applicators have CSCS cards?
Yes. Our applicators hold CSCS cards, which many sites require.
Is the work guaranteed?
Yes, for 12 months. If a joint fails because of how we installed it, we come back and put it right.
How do you choose the sealant?
The specification comes first, if there is one. Without one, the joint decides: how much it moves, what it bonds to and whether it’s wet, trafficked or fire-rated.
What sets the cost
The price varies from site to site. Expect it to depend on:
- The site’s rules and procedures
- How accessible the joints are
- How much existing material needs removing
- Specialist products, such as fire-rated or hygienic sealants
What a job costs comes down to how many linear metres there are, what has to come out first and how the joints are reached. Call for a fixed quote when you are ready.
Sending details for a quote
There’s no need for a formal survey. A few details are enough to get going:
- Access details, including height
- The postcode of the building
- Asbestos survey details if the building is older
- Clear photographs of the problem areas
We quote a fixed sum against the scope you give us, so you know the figure before anyone is on site. To ask for one, phone 01277 525 020 or send photos by email.
Site staff or a sealant specialist?
General builders and handymen seal joints, but it isn’t their main trade. A specialist prepares properly, controls joint depth and picks a product with the right movement class, which is what makes a joint last.
Putting right a botched joint often costs more than sealing it well at the start, since all of it has to come out and the faces be cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.
When it isn’t the sealant
Being straight saves everyone time. New sealant won’t cure:
- Openings that need collars, wraps, batts or boards rather than sealant
- Issuing fire ratings or certificates for seals
- Construction that lacks the fire resistance the seal relies on
If in doubt, phone 01277 525 020 or email us and we’ll say what we think.
Surfaces we seal
- Joints between fire-resisting walls and floors
- Cable penetrations
- Pipe penetrations
- Service gaps in risers
- Linear gaps at wall heads
- Small duct penetrations where the tested detail allows
Fire stopping around South Stour: points for this area
At about 51 miles from central London, South Stour is within reach of the capital. Offices around the capital are refitted often, and the cabling that follows can breach fire-resisting walls. In England, Approved Document B covers fire stopping of openings and penetrations. The national BS 476 classes are due to drop out of it from 2 September 2029, leaving the European BS EN 13501-2 route, subject to transitional arrangements. Either way, we install the specified product to its tested detail.
For a school such as Finberry Primary School, penetration sealing fits best at the end of the summer works. Office fit-outs on sites such as Bliby Business Centre, 0.6 miles south-west of South Stour, add cabling and pipework through fire-resisting walls, and fire-rated sealant goes in where the specification calls for it. For a site team at a college like Ashford College, which lies north-west of South Stour, fire-rated sealing is best scheduled after the summer works.
South Stour is about 3 miles south-east of Ashford, in Kent. Across the TN25 postcode area, it works the same way: send details, get a fixed quote, we seal, and the work is guaranteed. South Stour is one of 931 places we cover in Kent. Our Brighton page has more on work in that area (49 miles or so).
We take on service penetrations across the TN25 postcode area, whatever the building. Sites close to South Stour are covered too, including Mersham (1 mile north-east), Sevington (2 miles north), Hinxhill Park (2 miles north), Ridgeway (3 miles north-east) and Hinxhill (3 miles north-east). Nearby towns on our patch include Ashford (3 miles north-west), Canterbury (14 miles north-east), Folkestone (11 miles east), Faversham (14 miles north), Hythe (8 miles east) and Davington (15 miles north).
Landmarks near South Stour
Locally, jobs take us to sites close to Poulton Wood, among other places. South Stour’s nearest station is Ashford International station, roughly 2.8 miles north-west of the centre. Other landmarks nearby include William Harvey Hospital (2.4 miles north) and Ashford Designer Outlet (2.3 miles north-west). For a walk, there’s Hatch Park.
Work for main contractors and building owners
We work for building owners and managing agents on sealant work across single buildings or whole portfolios. Several sites can go on one quote, which keeps the paperwork simple.
When you manage a building on behalf of an owner, you need clear quotes and clear reporting. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative.
More services for South Stour
From enquiry to sign-off
On arrival, we report to your site contact and complete whatever induction the building runs. Everything around the joints gets protected before any cutting starts, and the work usually takes a single visit for a short list of penetrations, or a phased programme for a whole building. For a building around South Stour, tell us how to find it and who will meet us. Send that with the details and we will confirm the plan with the quote.
- First we confirm the product and tested details named in the specification.
- We sort the openings by the detail each one needs.
- Old or wrong materials are cut out.
- Mineral wool or other backing is fitted where required.
- We gun the sealant in to the specified depth around each service and tool it.
- We walk the completed areas with you and confirm the records agreed at quote stage.
Getting the site ready
- Explain the parking and delivery arrangements
- Have the specification and drawings to hand
- Tell staff and tenants when we’ll be in
Get a fixed quote
Every quote starts with the facts: the joints involved, quantities, access and the product called for. Share whatever details you have and we will fill any gaps with a visit.