Old Romney fire stopping
Work needed on a service penetration in Old Romney? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Fire sealant pulled out of the opening
- Non-fire-rated filler around services
- Improvised or mixed-product fire seals
Fire stopping for businesses in Old Romney
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Fire stopping for commercial buildings in Old Romney
On a fit-out or refurbishment, we follow the services contractors floor by floor. We work from your penetration schedule or marked-up drawings and the specified product data. Tell us what records you need and we’ll confirm with the quote. If you have fire seals cut back for extra cables and never reinstated and openings found when ceilings come down for a refit, we can help, on small duct penetrations where the tested detail allows, joints between fire-resisting walls and floors and cable penetrations alike. Most enquiries from Old Romney start with one failed joint and grow into a wider look at the building: we check the joints around it and give you an honest view of what needs doing now and what can wait.
A job near Old Romney is typically planned around one visit, with the specification and photographs sent in advance. Design and sign-off belong to the designer or building control; we install what’s specified.
The 12-month guarantee is for workmanship rather than wear and tear. Sealant wears with time, and movement, weather, cleaning and use decide how fast, so we are clear about what is covered before work starts.
- Place
- Old Romney (TN29)
- Region
- Kent
- Guarantee
- 12 months on our workmanship
- Quote
- Quoted before any work starts
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
How a job runs
Site rules come first: signing in, inductions and any permit to work. Once we’re cleared to begin, the joints are worked through in the order agreed with your site contact. For work around Old Romney, we aim to finish in one visit, so photographs and measurements up front really help. Then the right materials arrive with us.
- We start with your penetration schedule, drawings or specification.
- Access, permits and the order of areas are agreed with the site team.
- We compare every service penetration with its tested detail before sealing.
- Unsuitable material is removed and the opening cleaned.
- The specified backing and sealant go in to depth and are finished neatly.
- We tell you about openings that need a different product.
Getting the site ready
- Agree which areas must stay open
- Let us know about inductions and permits
- For older buildings, check the asbestos register before work
Request a quote
We quote a fixed sum against the scope you give us, so you know the figure before anyone is on site. To ask for one, call the office on 01277 525 020 or use the quote form.
Advice
Commercial clients in Old Romney
FMs need a contractor who is easy to get on site. Let us know the documents you need (RAMS, insurance certificate, CSCS details) and we’ll confirm them with the quote.
We work for building owners and managing agents on sealant work across single buildings or whole portfolios. Several sites can go on one quote, so there’s one set of paperwork to deal with.
Why it’s worth doing now in Old Romney
An improvised seal can look finished while offering no tested performance. The fix is to remove it and reinstall to the detail. Older rural buildings around Old Romney move with the seasons, and rigid or tired sealant can’t keep up. The right product, sized to the joint, copes much better.
No two sites price the same: joint size, product, access and site hours all play a part. A fixed quote follows once we understand the job.
Why choose Mastic Doctor in Old Romney
- One phone line for London, the South East and Scotland
- Failed material removed, not covered up
- Fully insured
- A Constructionline member, so easy to vet
See how commercial sealant jobs are priced or our accreditations.
Also near Old Romney
Other services in Old Romney
Aftercare for building managers
After handover, these steps help:
- Check risers and ceiling voids after each round of works
- Flag new cables with no seal around them
- Put resealing into every M&E and fit-out package
- Keep general-purpose fillers away from compartment walls
During planned inspections, look at seals in risers, cupboards and voids. Watch for cracked sealant, new services with no seal and openings that have grown and get them dealt with.
Specify fire stopping early on refits, not as an afterthought. The designer can then choose details that suit the services planned.
Quoting for work in Old Romney
There’s no standard rate for sealant work, since sites vary so much. What we look at:
- Backing rod, priming and other preparation
- Whether old sealant has to be cut out first
- Specialist products, such as fire-rated or hygienic sealants
- Site requirements such as inductions and permits
The product called for affects the cost, and so does the preparation. Access, phasing and site requirements come into it too.
What we need to price the job
Diagnosis starts before we arrive. Tell us:
- A wide shot and a close-up of the area
- The site address and postcode
- Specification clauses that apply
- Your programme or deadline
Photos, drawings or a schedule of the joints are often enough for a fixed quote. Where a site visit makes more sense, we will arrange one.
Your questions answered
What happens to BS 476 references for fire stopping in Old Romney?
References to BS 476 classes are being removed from Approved Document B from 2 September 2029, after which BS EN 13501-2 classification is the route, subject to transitional arrangements. Whichever applies, we install the specified product to its tested detail; the specification is for the designer to set.
Is Peak Industrial Park, near Old Romney, within your area?
Yes. Estates, retail parks and business parks around Old Romney, Peak Industrial Park among them, are all within reach. A few photographs and the unit address let us price the work.
What do you charge?
We don’t publish prices, as every site differs. With photos or drawings, we can give you a fixed quote.
Can you work while the building is occupied?
Yes, as long as we plan it. Tell us your site hours and access windows and we will plan around them.
Do you take on multi-site work?
Yes. Multi-site work and planned programmes are a core part of the service, with each site phased to suit its occupants.
Do you hold CHAS accreditation?
Yes. We’re CHAS accredited, we are a Constructionline member and we use CSCS-carded applicators.
Can you quote from photos?
Photos, drawings or a schedule are often enough to quote. Where they aren’t, we arrange a site visit.
Fire-rated sealing for Old Romney buildings
In England, Approved Document B covers fire stopping of openings and penetrations. From 2 September 2029, BS 476 references are being taken out of Approved Document B, leaving BS EN 13501-2 classification as the route, subject to the Government’s transitional arrangements. Either way, we install the specified product to its tested detail. Old Romney is about 55 miles from central London. Office refits around the commuter belt bring new cabling through fire-resisting walls.
Schools such as The Marsh Academy often have new data and services installed during holidays, and penetrations through fire-resisting walls should be checked afterwards. In a building such as Church of St Clement, any service penetration through a fire-resisting wall should be sealed to the specified detail. On estates like Peak Industrial Park (2.4 miles south-east of Old Romney), the wall between office and warehouse is often fire-resisting, and cables through it need the specified seal.
Old Romney is about 10 miles south-west of Hythe, in Kent. Our applicators travel to Old Romney for work on service penetrations, handled exactly as we handle every other area. Old Romney is one of 931 places we cover in Kent for service penetrations. Sites around Brighton have their own page, roughly 46 miles from Old Romney.
Business premises anywhere in TN29 are within our area. We also cover Ivychurch (2 miles north), New Romney (2 miles east), Brenzett (2 miles north-west), Lydd (3 miles south) and Brookland (3 miles west). A short drive away, we cover Ashford (10 miles north), Folkestone (14 miles north-east), Hythe (10 miles north-east), Hawkinge (14 miles north-east), Tenterden (10 miles north-west) and Cheriton (13 miles north-east).
Local landmarks in Old Romney
The nearest railway station is Appledore (Kent) station, roughly 4.5 miles north-west of the centre. Well-known places in the area include Brenzett Aeronautical Museum (1.9 miles north-west) and Romney 'castle' (under half a mile north-east). Open spaces near Old Romney include Burnthouse Pen and Dungeness National.
What the job involves on each surface
Cables and cable bundles
Single cables and small bundles are often within a fire-rated sealant’s tested detail. Bundle size, cable type and the space between cables all matter and we work within those limits.
Linear joints
Joints at the top of partitions may need to move as the slab above deflects. The specified product and backing for that movement are what goes in, with no gaps along the run.