Fire Stopping in Matching Tye
Fire-rated and intumescent sealing of service penetrations and linear gaps in Matching Tye and across Essex. CHAS accredited and fully insured, with a 12-month guarantee.
- Unsealed penetrations discovered above suspended ceilings
- Seals that don’t match their tested detail
- Old intumescent sealant that has split away
Fire stopping near Matching Tye
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Do you need fire stopping in Matching Tye?
Most open service penetrations are left by later work. A new cable pulled by an electrician, a pipe rerouted by a plumber or a data run drilled through a riser leaves an opening that nobody returns to. Over a few years of fit-outs, a wall can collect a lot of these.
Most enquiries start with something like this:
- Fire sealant pulled out of the opening
- Improvised or mixed-product fire seals
- Unsealed openings around new pipes and cables
- Damaged fire seals in risers and voids
In a building such as Parish Church of St Mary, any service penetration through a fire-resisting wall should be sealed to the specified detail.
What your quote should include
- How the joint faces will be prepared and primed
- Will CSCS-carded applicators be on site?
- How they handle RAMS and site documents
- Health and safety accreditation such as CHAS
How we handle fire stopping in Matching Tye
We are commercial sealant applicators, CHAS accredited and a Constructionline member, with CSCS-carded applicators on site. We hold no third-party fire-stopping installer certificate, and we won’t pretend otherwise. We install the specified fire-rated sealant to its tested detail, and our workmanship carries a 12-month guarantee. We work on small duct penetrations where the tested detail allows, linear gaps at wall heads and joints between fire-resisting walls and floors, and the usual reasons a site gets in touch are improvised or mixed-product fire seals and unsealed penetrations discovered above suspended ceilings. Looking for mastic applicators who cover Matching Tye? We’ve been sealing commercial buildings since 2005, with CSCS-carded applicators.
For a smaller site near Matching Tye, we plan to do all the penetrations in one go, so send the specification and photographs first. We install to the specification and the manufacturer’s guidance, leaving design and sign-off with the designer and building control.
Guaranteed is the last step of every job. Our workmanship is backed for 12 months, and we explain exactly what that covers when we quote.
- Place
- Matching Tye (CM17)
- Wider area
- Essex
- Guarantee
- 12 months on our workmanship
- Quote
- Quoted before any work starts
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
How the job changes by surface
Metal pipes
Metal pipes conduct heat, so their details often call for extra measures along the pipe, and some details add wrapping or a set length of insulation. We follow whatever the detail requires and flag anything we can’t match.
Cables and cable bundles
Single cables and small bundles are often within a fire-rated sealant’s tested detail. Bundle size, cable type and the space between cables all matter, so we check before sealing.
How a job runs
In a busy building, the work is phased so only one area is out of use at a time. Each area is protected, prepared and sealed, then reopened once the sealant allows before the next one starts. For work around Matching Tye, we aim to finish in one visit, so we ask for photos and rough sizes first. That way the right products come on the day.
- We read the specification, drawings or penetration schedule you send and ask about anything unclear.
- Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
- Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
- We fit the backing the detail asks for, to the stated depth.
- We apply the specified sealant to the depth and around the services as the detail shows.
- If an opening needs something other than sealant, we tell you instead of improvising.
Before we start on site
- Clear stock, furniture or equipment away from the joints
- Flag any permit to work we will need
- Tell staff and tenants when we’ll be in
Ask for a quote
The quickest route to a quote is a few photographs and the site postcode. Upload them with the quote form, or speak to us on 01277 525 020 or send details through our quote form to discuss it first.
Advice
When to bring in a specialist
Using site staff can make sense for a small touch-up, but anything bigger is another matter: a specialist brings efficiency, a consistent finish and a 12-month guarantee.
Certain joints really need a specialist: for example fire-rated seals that must match a tested detail, trafficked floor joints and external movement joints. A poor seal in places like these tends to cost more to put right later.
Where services cross fire walls in Matching Tye
Central London is about 23 miles from Matching Tye. Office refits around the commuter belt bring new cabling through fire-resisting walls. Matching Tye has several hotels close by, all within 2 miles. In hotels, bedroom and corridor walls are normally fire-resisting, so services added in a refit need sealing with the specified product.
For a building at a site such as Hastingwood Business Centre, which lies south-west of Matching Tye, a check of penetration seals after each fit-out is good practice. At a healthcare site like Princess Alexandra Hospital (4.6 miles west of Matching Tye), new services through compartment walls are a constant, and each needs the specified seal.
Matching Tye is about 3 miles east of Harlow, in Essex. Our applicators travel to Matching Tye for work on service penetrations. 644 places across Essex fall within our area, Matching Tye among them. London is covered too, around 23 miles from Matching Tye.
Work on service penetrations is covered throughout CM17. For a building on Rainbow Road and Harlow Road or nearby, send details and we will quote for service penetrations. Sites close to Matching Tye are covered too, including Matching (1 mile north-east), Housham Tye (1 mile west), Loyter's Green (1 mile south), Newman's End (1 mile north) and Magdalen Laver (2 miles south). A short drive away, we cover Chelmsford (13 miles east), Harlow (3 miles west), Brentwood (12 miles south-east), Billericay (14 miles south-east), Loughton (11 miles south-west) and Waltham Abbey (10 miles south-west).
Around Matching Tye
Recent enquiries here include premises near Gibberd Garden. The nearest railway station is Harlow Mill station, about 2.7 miles west of the centre. A little further out are Harlow Mill (2.9 miles west) and Mark Hall Cycle Museum (2.9 miles west). Not far away are Sawbridgeworth Marsh.
Also near Matching Tye
More services for Matching Tye
When something else is needed
We check first that sealant really is the fix. It won’t put right:
- Approving the work on behalf of building control
- Designing or specifying fire stopping, which sits with the designer or fire engineer
- Fire risk assessments, a job for a competent assessor
If you are not sure, just speak to us on 01277 525 020 or email a schedule or drawings and we’ll give you a straight answer before you book.
What we seal
- Cable penetrations
- Linear gaps at wall heads
- Pipe penetrations
- Small duct penetrations where the tested detail allows
- Service gaps in risers
- Joints between fire-resisting walls and floors
Matching Tye: questions and answers
Is Matching Tye too small for you to travel to?
Not at all. Matching Tye is within our area. Our area covers London and the South East counties. Send photos and a list of what needs doing, and we will plan the job to need as few trips as possible.
Do you work on fire-rated sealing in hotels in Matching Tye?
Yes. We install fire-rated and intumescent sealant where it is specified. Work is done room by room so the hotel keeps trading; design and sign-off stay with the designer and building control.
Can the building stay open while you work?
Typically, yes. Phased work can be planned so areas stay in use, with each area protected and signed.
Is any job too small?
Whatever the size, the process is the same: details, then a fixed price, then sealing, then a 12-month guarantee.
Can you handle several sites?
Yes. A group of buildings can go on one quote, and you deal with one contact throughout across South East England, Greater London and Scotland.
Do you work to architects’ specifications?
Yes. Send it with your enquiry, and the quote will be based on it, flagging anything that needs clarifying.
Does weather matter for sealant work?
Outside, yes. The joint has to be dry and within the product’s temperature range, so damp, frosty or very cold days can stop external work. Inside work is seldom held up.
Keeping the joints sound
Every sealant joint needs some looking after, and their life depends on movement, exposure, cleaning and use. We suggest:
- Agree the fire-stopping specification before services go in
- Arrange inspection before areas are covered up
- Keep general-purpose fillers away from compartment walls
- Brief every trade that openings they make must be sealed
Don’t patch a fire-rated seal with anything outside its tested detail. Repairs need the same product and detail as the original.
Regular walk-rounds of service areas are worth the time. A cracked or disturbed seal found early is a small job compared with dozens found at once.