Fire Stopping in Lendalfoot
We carry out fire-rated and intumescent sealing of service penetrations and linear gaps in Lendalfoot and the surrounding area. Send photographs or drawings for a fixed quote.
- Damaged fire seals in risers and voids
- Fire-stopping items raised at inspection or handover
- Fire stopping installed outside its tested range
Fire stopping for Lendalfoot sites
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Fire stopping for commercial buildings in Lendalfoot
Our applicators are CSCS-carded, and we are CHAS accredited and a Constructionline member. We don’t hold a third-party fire-stopping installer certificate and we’d rather say that up front. We install the specified fire-rated sealant to its tested detail, and our workmanship carries a 12-month guarantee. If you have fire-stopping items raised at inspection or handover and non-fire-rated filler around services, we can put it right, on cable penetrations, service gaps in risers and joints between fire-resisting walls and floors alike. Sealant applicators who only do sealant are a different proposition from a general trade with a gun in the van: in Lendalfoot, that means joint design, primers and backing rod as standard.
In smaller Scottish places like Lendalfoot, buildings with fire-resisting walls typically include schools, care homes, hotels and health centres. Those penetrations are closed with the product the specification names, built up as tested.
We stand by our work with a 12-month guarantee. It covers how we prepared and applied the sealant.
- Place
- Lendalfoot (KA26)
- Wider area
- South Ayrshire
- Cover
- 12 months on every job
- Quote
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Updated
- 3 November 2026
What sets the cost
We price every job individually. The main factors are:
- Site requirements such as inductions and permits
- Whether the work must be split into stages
- How much existing material needs removing
- Any access equipment needed
There’s no price list, since every building and every scope is different. For a fixed figure, call for a quote and we’ll price your job on its own details.
What we need to price the job
There’s no need for a formal survey. A few details are enough to get going:
- A wide shot and a close-up of the area
- Whether the building will be occupied during the work
- Approximate linear metres or a joint schedule
- When you need the work done
Every quote starts with the facts: the joints involved, quantities, access and the product called for. Share whatever details you have and we’ll fill any gaps with a visit.
Compartment walls and floors in Lendalfoot
Scotland has its own building standards: the non-domestic Technical Handbook (clause 2.1.14) says service penetrations should be fire stopped to at least the fire resistance duration of the wall or floor, with products tested for that end use. We install fire-rated sealant to that tested detail where it is specified.
For any site around Lendalfoot, we work to the specification and the manufacturer’s installation guidance, leaving design and sign-off with the designer. For buildings in and around Lendalfoot, fire-rated sealant is installed where it is specified, to the manufacturer’s tested detail.
Lendalfoot is about 18 miles north of Stranraer, in South Ayrshire. Across the KA26 postcode area, the process is the same: details in, fixed quote out, then sealing and a 12-month guarantee. Our South Ayrshire coverage takes in 48 places, from busy centres to rural villages. Sites around Glasgow have their own page, about 54 miles away.
Commercial sites across KA26 are covered. Sites close to Lendalfoot are covered too, including Colmonell (3 miles south-east), Pinwherry (4 miles east), Ballantrae (5 miles south-west), Smyrton (6 miles south) and Girvan (6 miles north-east).
Near you in Lendalfoot
Nearby you’ll also find Knockdolian Castle (2.7 miles south). Open spaces near Lendalfoot include Knockdolian.
What happens if it’s left?
Open service penetrations matter on ordinary days, not just in a fire: they also carry noise, draughts and smells between rooms. Sealing them to the specified detail deals with the fire risk first. Buildings that aren’t in daily use, such as halls and seasonal premises, may let water in unnoticed, giving water time to get in. Resealing early avoids that.
No two sites price the same: the joint sizes, the specified product, access and working hours each have a bearing. A fixed quote follows once we understand the job.
Why us?
- Health and safety: CHAS accredited
- Constructionline member for supplier checks
- 12-month guarantee on workmanship
- Public liability insurance in place
Take a look at our cost guide or how we’re accredited.
Looking after the joints
Sealant joints are maintenance items, and their life depends on movement, exposure, cleaning and use. Our advice:
- Foam or ordinary sealant is never a fire-seal repair
- Keep product data and details in the fire safety file
- Treat an open penetration as a priority repair
- Put resealing into every M&E and fit-out package
Store the specified product details somewhere the next contractor can find them. It makes later repairs much easier to match.
Ask every contractor who works in risers or voids to report openings they create. Small habits like this stop openings building up.
What sealant work can’t fix
We seal joints; we don’t mend everything behind them. Sealant alone won’t deal with:
- Designing or specifying fire stopping, which sits with the designer or fire engineer
- Plastic pipes whose detail calls for a collar or wrap
- Gaps in walls that were never built as compartment walls
If you’re not sure, just call 01277 525 020 or email the details over and we’ll give you a straight answer.
What we seal
- Linear gaps at wall heads
- Service gaps in risers
- Small duct penetrations where the tested detail allows
- Cable penetrations
- Joints between fire-resisting walls and floors
- Pipe penetrations
On site: what to expect
In a busy building, we agree a sequence with your contact so the disruption stays in one area at once. Each area is protected, prepared and sealed, then handed back before the next one starts. For a building near Lendalfoot, directions, keys and a contact on the day are worth sorting early. We will confirm the plan with the fixed quote.
- First we go through the drawings, schedule or specification for the seals and raise any questions before we price.
- On site, each opening is checked against the tested detail it is meant to follow.
- Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
- Mineral wool or other backing goes in wherever the detail asks.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.
Getting the site ready
- Share your working hours and any access restrictions
- Share the asbestos register for older buildings
- Confirm the product named in the specification
Request a quote
A handful of photos and a postcode is the fastest way to a quote. Send them through the quote form, or call the office on 01277 525 020 or email the details over if you’d rather talk the job through.
Related advice
For managing agents and facilities managers
For main contractors, we work as the sealant subcontractor. We work to your programme, your specification and your site rules, with CSCS-carded applicators on site.
We take on planned maintenance as well as one-off repairs: working through a building or an estate in stages that fit your budget. Lendalfoot can form part of a wider programme across South Ayrshire.
More services for Lendalfoot
FAQs: Lendalfoot
Will you design a fire-stopping scheme for our building in Lendalfoot?
No, that sits with the designer, fire engineer or building control. Our part is installing the specified product to its tested detail, and telling you if the detail calls for something other than sealant.
How do Scotland’s building standards affect fire-rated sealant in Lendalfoot?
The non-domestic Technical Handbook, clause 2.1.14, expects a penetration to keep at least the wall or floor’s fire resistance period, with proprietary products tested for the use they’re put to. Design sits with the designer and the verifier; installation to the tested detail is our part.
Is it fine to apply new sealant on top of old?
No. Sealing over old material is one of the classic causes of early joint failure, so it all comes out first.
Can you follow the specification on our project?
Yes. We follow the specification, along with the manufacturer’s installation guidance, and we raise anything unclear before work begins.
Will you quote for a small job?
Single areas, one-off repairs and whole buildings are all quoted the same way: send details, get a fixed quote, we seal, guaranteed.
Can weather delay the job?
It can, for external work. Sealant won’t bond properly to a wet or frosty joint, so external work may be moved if conditions aren’t right. Indoors, the weather is rarely a problem.
Do you cover Lendalfoot?
Yes. Lendalfoot is in our area and the rest of South Ayrshire. For a quote, ring 01277 525 020 or use the quote form.