Fire-rated sealing and fire stopping in Fyfield, Hampshire
Our CSCS-carded applicators take on fire-rated and intumescent sealing of service penetrations and linear gaps in Fyfield and the surrounding area. Send details for a fixed quote.
- Non-fire-rated filler around services
- Fire sealant pulled out of the opening
- Fire stopping installed outside its tested range
Fire stopping in Fyfield
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Fire stopping for commercial buildings in Fyfield
Where pipes, cables and other services cross a compartment wall or floor, the opening around them has to be closed so fire and smoke can’t move between compartments. Our part is installing fire-rated and intumescent sealant at those openings and along linear gaps, where the specification calls for it. We work to the product’s tested detail for every seal. We work on joints between fire-resisting walls and floors, cable penetrations and service gaps in risers, and the failures we’re asked to look at most are builders’ foam or ordinary silicone in compartment walls and open linear gaps along the top of fire-resisting walls. For commercial sealant work in Fyfield, you deal with one contact from quote to sign-off, whether it’s one building or several.
Around smaller places like Fyfield, penetration seals come up in schools, halls, pubs with rooms, care homes and farm buildings used as offices. Any service penetration through those walls should be closed with the specified product, set out as its test evidence shows.
The 12-month guarantee covers our workmanship: the preparation, the sealing and the tooling. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Where
- Fyfield (SP11)
- Wider area
- Hampshire
- Guarantee
- 12 months on every job
- Price
- Quoted before any work starts
- Call
- 01277 525 020
- Page updated
- 3 November 2026
Surface by surface
Cables and cable bundles
New data and power cables are the most common breach we see. Openings around new cables are resealed to the detail.
Risers and ceiling voids
Risers and ceiling voids hold most of a building’s service penetrations. Access to these areas is planned with you in advance.
What sets the cost
These are the things that shape the price:
- The size and state of each joint
- Any access equipment needed
- Location, for remote and island sites
- Induction, permit and paperwork requirements
We don’t publish prices, since every building and every scope is different. Call for a quote and we will price your job on its own details.
Details that help us quote
To price the job accurately, we need to understand the site. Send us:
- Asbestos survey details if the building is older
- Specification clauses that apply
- What the building is and how it’s used
- Any dates the work must fit around
The quickest route to a quote is a few photos and the site postcode. Send them through the quote form, or ring 01277 525 020 or email a schedule or drawings to discuss it first.
After the work
For the best life from the joints:
- Brief every trade that openings they make must be sealed
- Arrange inspection before areas are covered up
- Settle who seals which penetrations at the start of a project
- Leave fire sealant to cure fully before covering it
After the work, brief anyone else working in the area that the openings are now sealed. If a seal has to be opened for a new service, it should be reinstated to the same detail, by someone who knows the system.
A simple record of seal locations and products helps. It tells the next contractor exactly what to reinstate, and it helps at inspections.
Towns and villages near Fyfield
Other services in Fyfield
Your questions answered
Do you cover business parks and estates near Fyfield, such as Weyhill Business Park?
Yes. Our area takes in Fyfield and its surroundings, with estates and business parks such as Weyhill Business Park included. Send details of the unit and the work through our quote form for a quick quote.
Can you take on a job at a hospital such as Andover War Memorial Hospital?
Yes. We work in healthcare settings as well as offices and schools. The estates team’s permit system and infection-control rules come first, and the work is planned around them.
Do the same rules apply to fire stopping in Scotland?
Our work covers Greater London, the South East and every Scottish council area. Scotland’s non-domestic Technical Handbook, clause 2.1.14, expects service penetrations to be fire stopped to at least the wall or floor’s fire resistance, using products tested for their end use.
Do you hold third-party fire-stopping installer certification?
No. We don’t hold a third-party fire-stopping installer certificate. Our credentials are CHAS accreditation, Constructionline membership and CSCS-carded applicators, and we are fully insured. If your contract requires third-party installer certification, we are not the right fit for that package.
Is sealant suitable for all service openings?
No. Each fire-rated sealant is tested for particular services, gap sizes and substrates. If an opening falls outside, it needs another solution, as set out by the designer.
Will you just go over the old sealant?
No. Failed sealant is removed and the faces cleaned back to sound, dry material first, since fresh sealant will not bond reliably to aged material.
Can one quote cover more than one building?
Yes. Several buildings can share a single quote, with one point of contact across South East England, Greater London and Scotland.
Penetration seals near Fyfield
Central London is about 67 miles from Fyfield. Business park offices in the commuter belt are refitted as tenants change, and each fit-out adds services through compartment walls; the gaps need the specified seal. In England, Approved Document B covers fire stopping of openings and penetrations. From 2 September 2029, BS 476 references are being taken out of Approved Document B, leaving BS EN 13501-2 classification as the route, subject to the Government’s transitional arrangements. Our part stays the same: the specified product, installed to its tested detail.
Wherever services are added at a hospital such as Andover War Memorial Hospital, 3.7 miles east of Fyfield, the compartment line has to be made good with the specified product. Offices at parks like Weyhill Business Park (to the east of Fyfield) are re-cabled with each new tenant, and compartment walls need sealing afterwards to the tested detail. Halls and meeting rooms at places like Church of St Nicholas sometimes gain new services, and any compartment wall crossed needs the specified seal.
Fyfield is about 4 miles west of Andover, in Hampshire. Anywhere in SP11, the process is the same: details in, fixed quote out, then sealing and a 12-month guarantee. Our Hampshire coverage takes in 723 places, from busy centres to rural villages. There’s a separate page for Southampton, about 22 miles away.
If you need fire stopping in SP11, the process matches everywhere else we work: send details, get a quote, we seal, guaranteed. Among the streets we cover are Fyfield Road, Grange Close and Duncan's Close, and sites on any of them can send details for a fixed quote. Nearby places we also cover include Mullenspond (1 mile south-east), Thruxton (1 mile south), East Cholderton (1 mile south), Weyhill (1 mile east) and Appleshaw (2 miles north-east) for service penetrations. Bigger towns within reach include Andover (4 miles east), Hyde (15 miles south-east), Tidworth (4 miles north-west), Weeke (15 miles south-east), Ludgershall (3 miles north-west) and Whitchurch (11 miles east).
Near you in Fyfield
In Fyfield, that means premises near The George Inn and the streets around them. For rail, the closest station is Grateley station, about 3.7 miles south-west. A little further out are Ludgershall Castle (3.4 miles north-west) and Andover War Memorial Hospital (3.7 miles east). Not far away are Quarley Hill and Anton Lakes.
From enquiry to sign-off
Occupied buildings need a little choreography. The work area is signed and kept contained, keep walkways clear and work section by section so the rest of the building stays in use. Jobs in and around smaller places like Fyfield are usually planned as a single visit, so we ask for photos and rough sizes first. That way the right products come on the day.
- We ask for the product and detail your designer has specified.
- Openings are measured and grouped by detail.
- Old or wrong materials are cut out.
- Where the detail needs backing, it goes in at the stated depth.
- We gun the sealant in to the specified depth around each service and tool it.
- We walk the completed areas with you and confirm the records agreed at quote stage.
What we need from you
- Flag any permit to work we’ll need
- Warn occupants and staff about the work
- For older buildings, check the asbestos register before work
Quotes
Need a figure for a tender or a budget? Send the scope and any drawings, and we will return a fixed quote you can plan around. For a chat about it beforehand, give us a call on 01277 525 020 or send details through our quote form.
Read more
Doing it in-house
Using site staff can make sense for a small touch-up, but larger jobs are different: a specialist brings efficiency, a consistent finish and a 12-month guarantee.
Redoing a failed joint usually costs more than getting it right at the outset, because the whole bead must be removed and the faces cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.
What sealant work can’t fix
Being straight saves everyone time. Fresh joints won’t solve:
- Fire risk assessments, a job for a competent assessor
- Gaps in walls that were never built as compartment walls
- Writing the fire-stopping specification
If in doubt, speak to us on 01277 525 020 or email the details over and we’ll say what we think.
Surfaces we seal
- Pipe penetrations
- Linear gaps at wall heads
- Small duct penetrations where the tested detail allows
- Service gaps in risers
- Joints between fire-resisting walls and floors
- Cable penetrations