Fire stopping in Fewcott
Looking for fire stopping in Fewcott? Send us the details for a fixed quote, backed by a 12-month guarantee on the work.
- Unsealed openings around new pipes and cables
- Old intumescent sealant that has split away
- Head-of-wall gaps with no fire seal
Fire stopping for Fewcott sites
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Questions we’re asked in Fewcott
Is Fewcott too small for you to travel to?
No. Places such as Fewcott are covered as much as the big towns. Our area covers London and the South East counties. Send photos and a list of what needs doing, and we will plan the job to need as few trips as possible.
How does the removal of BS 476 from Approved Document B affect fire-rated sealing in Fewcott?
Approved Document B loses its BS 476 references from 2 September 2029, and BS EN 13501-2 becomes the route, subject to transitional arrangements. Whichever applies, we install the specified product to its tested detail; the specification is for the designer to set.
Do you take on small jobs?
Whatever the size, the process is the same: send details, get a fixed quote, we seal, guaranteed.
Do you need to see the site first?
That depends on the size and complexity of the job. Straightforward work can often be priced from photographs and measurements, while larger or less clear jobs get a site visit first.
Do you have public liability insurance?
Yes. Our insurance certificate can be sent alongside the quote.
Can weather delay the job?
Outside, yes. The joint has to be dry and within the product’s temperature range, so frost, rain or cold mornings can delay outside work. Internal work is rarely affected.
How long does a typical visit take?
It depends on the scope, but the work normally takes longer where risers, ceiling voids or occupied floors have to be worked through in sequence. Larger or phased jobs take longer, and we will give you a timescale with the quote.
Fire stopping for commercial buildings in Fewcott
A lot of fire-stopping work comes after M&E installation, a refit or a tenant fit-out. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind, often unnoticed. We close the openings listed on your schedule, using the specified sealant and detail. We work on cable penetrations, joints between fire-resisting walls and floors and small duct penetrations where the tested detail allows, and the failures we’re asked to look at most are fire seals cut back for extra cables and never reinstated and unsealed openings around new pipes and cables. For commercial sealant work in Fewcott, you deal with one contact from quote to sign-off, for single jobs and planned programmes alike.
Rural conversions around Fewcott can put new fire-resisting partitions inside older structures. A penetration seal only performs as tested if product, substrate, service, gap and depth all match the detail.
We sign every job off with a 12-month guarantee. It’s a plain promise: if our work fails within that year, we put it right.
- Where
- Fewcott (OX27)
- Region
- Oxfordshire
- Cover
- A 12-month guarantee
- Price
- Quoted before any work starts
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Signs you need fire stopping in Fewcott
On a busy project, programme pressure can mean fire stopping is rushed or left to whichever trade is closest. That is how unsuitable products and improvised details end up in compartment walls and later need putting right.
If one of these sounds familiar, it’s time for a closer look:
- Damaged fire seals in risers and voids
- Service penetrations left open after M&E works
- Builders’ foam or ordinary silicone in compartment walls
- Openings found when ceilings come down for a refit
Where a unit on an estate such as Baynards Green Trading Estate, which lies north-east of Fewcott, has fire-resisting walls between offices and warehouse, any new service through them should be sealed to the tested detail.
What your quote should include
- How they handle RAMS and site documents
- The terms of the workmanship guarantee
- Their pre-qualification and accreditations
- How they’ll work around occupants
On site: what to expect
In a busy building, we agree a sequence with your contact so the disruption stays in one area at once. Each section is protected, cleaned back and sealed before we move to the next. Smaller jobs around Fewcott can be grouped with others nearby, which keeps travel down. A fixed quote is given before anything starts.
- We ask for the product and detail your designer has specified.
- Openings are measured and grouped by detail.
- Improvised fillers and failed sealant are removed.
- Where the detail needs backing, it goes in at the stated depth.
- We gun the sealant in to the specified depth around each service and tool it.
- We walk the completed areas with you and confirm the records agreed at quote stage.
Preparing the site
- Send any specification or drawings in advance
- Clear stock, furniture or equipment away from the joints
- Tell us your opening times and when work is allowed
Request a quote
Quotes are fixed against the scope you send, so you know the figure before anyone is on site. To start the process, give us a call on 01277 525 020 or use the quote form.
Read more
Site staff or a sealant specialist?
Putting right a botched joint often costs more than sealing it well at the start, because the whole bead must be removed and the faces cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.
Site maintenance staff can often handle a short internal joint. Where it goes wrong is preparation: sealing over old material, sealing onto damp or dusty surfaces, or a product that can’t take the movement.
What the job involves on each surface
Masonry and concrete
Core-drilled holes are neat; broken-out ones rarely are. The gap is measured at the widest point so we know it sits within the tested range.
Small ducts
Ducts are only sealed with sealant where the detail allows it. Dampers and ductwork systems themselves are outside our work.
Keeping the joints sound
After handover, a little attention goes a long way:
- Agree the fire-stopping specification before services go in
- Make fire stopping part of every scope that crosses a fire-resisting wall
- Flag new cables with no seal around them
- Ask which product is in place before decorating
Never top up a fire seal with foam, ordinary silicone or filler. A repair should use the original product, installed the same way, or a new specification from the designer.
Specify fire stopping early on refits, not as an afterthought. Details can then be picked to suit the actual pipes, cables and ducts.
Nearby places to Fewcott
More services for Fewcott
What sets the cost
A fixed quote reflects the actual work. It allows for:
- How much there is to seal
- The product specified
- Whether the work must be split into stages
- Access and working height
The product called for affects the cost, as does the preparation each joint needs, such as cutting out, priming or new backing rod. Access, phasing and site requirements come into it too.
What to include in your enquiry
We can often quote from photos and a few details. It helps to include:
- Photos of the joints, close up and from further back
- How the joints are reached, and at what height
- What the building is and how it’s used
- Specification clauses that apply
Photos, drawings or a schedule of the joints and a fixed quote comes back to you. If the job needs a look first, we’ll arrange a site visit.
Service penetrations in Fewcott buildings
Fewcott lies roughly 57 miles out from central London. Business park offices in the commuter belt are refitted as tenants change, and each fit-out adds services through compartment walls, and the gaps need sealing with the specified product. For England, the fire stopping of penetrations is dealt with in Approved Document B. Its BS 476 references are being withdrawn from 2 September 2029, with BS EN 13501-2 classification taking over, subject to transitional arrangements. We install whatever has been specified, to the product’s tested detail.
Halls and meeting rooms at places like Church of St Mary sometimes gain new services, and any compartment wall crossed needs the specified seal. On a hospital site such as Bicester Community Hospital (4.2 miles south-east of Fewcott), fire-rated sealant goes in where the specification calls for it, with the work planned around the estates team’s permits.
Fewcott is about 4 miles north-west of Bicester, in Oxfordshire. We cover commercial sites throughout Fewcott. Our Oxfordshire coverage takes in 423 places, from busy centres to rural villages. We also cover Oxford, some 13 miles away.
If you need fire stopping in OX27, the process matches everywhere else we work: send details, get a quote, we seal, guaranteed. Buildings on Water Lane, Somerton Road and Ardley Road are within our area for service penetrations. Sites close to Fewcott are covered too, including Ardley (1 mile south-east), Fritwell (1 mile north-west), Upper Heyford (2 miles south-west), Souldern (3 miles north-west) and Middleton Stoney (3 miles south). Nearby towns on our patch include Oxford (13 miles south), Banbury (10 miles north-west), Bicester (4 miles south-east), Kidlington (9 miles south), Headington Quarry (13 miles south) and Bure Park (3 miles south-east).
Around Fewcott
In Fewcott, that means premises near White Lion pub, among other places. For rail, the closest station is Bicester North station, roughly 4 miles south-east. Nearby you’ll also find Bicester Community Hospital (4.2 miles south-east) and Ardley Castle (less than half a mile south).