Fire stopping in Erriottwood
Fire stopping for Erriottwood, from a contractor working since 2005. Fully insured, with a 12-month guarantee.
- Non-fire-rated filler around services
- Damaged fire seals in risers and voids
- Improvised or mixed-product fire seals
Fire stopping near Erriottwood
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
From enquiry to sign-off
On arrival, we sign in, go through any site induction and check how permits are handled. Floors, finishes and fittings next to the joints are covered before any cutting starts, and the work typically takes anything from one day to a planned run of visits, depending on the number of seals and the access. If others near Erriottwood need work, visits can be combined, which keeps travel down. You’ll have a fixed quote before work starts.
- The specification and schedule come first, so we know which details apply.
- Access, permits and the order of areas are agreed with the site team.
- We compare every service penetration with its tested detail before sealing.
- Unsuitable material is removed and the opening cleaned.
- The specified backing and sealant go in to depth and are finished neatly.
- We tell you about openings that need a different product.
Before we start on site
- Confirm the product named in the specification
- Make sure the joints can be reached
- Tell us your opening times and when work is allowed
Ask for a quote
To get a fixed quote, phone 01277 525 020 or send photos by email. You can also send details through our quote form.
Advice
Fire stopping in Erriottwood
Most of our fire stopping work happens after the building is up. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind. Those on your schedule are closed with the specified product. We work on small duct penetrations where the tested detail allows, linear gaps at wall heads and cable penetrations, and the failures we are asked to look at most are unsealed joints where partitions meet the slab and fire stopping installed outside its tested range. For commercial sealant work in Erriottwood, you deal with one contact from quote to sign-off, for single jobs and planned programmes alike.
For a smaller site near Erriottwood, we plan to do all the penetrations in one go, with the specification and photos sent in advance. Design and sign-off belong to the designer or building control; we install what’s specified.
We stand by our work with a 12-month guarantee. That covers our preparation and application, and if something we did falls short, we return to it.
- Where
- Erriottwood (ME9)
- Wider area
- Kent
- Cover
- 12 months on every job
- Quote
- A fixed quote before we start
- Telephone
- 01277 525 020
- Updated
- 3 November 2026
Common problems we fix in Erriottwood
Plenty of openings were simply never closed. Inspections, refurbishments and ceiling access normally bring them to light.
It’s worth sending us details if you spot any of the following:
- Non-fire-rated filler around services
- Head-of-wall gaps with no fire seal
- Seals disturbed by maintenance and left open
- Old intumescent sealant that has split away
Schools such as Lynsted and Norton Primary School often have new data and services installed during holidays, and penetrations through fire-resisting walls should be checked afterwards.
What your quote should include
- The named product and why it was chosen
- Can the work be phased to keep areas open?
- How the joint faces will be prepared and primed
- What the guarantee covers, and for how long
Why act early in Erriottwood
Fire stopping is a regular point raised at inspections and handover. Finding unsealed or improvised openings late can hold up a programme which is why earlier is better. Converted and older buildings near places like Erriottwood tend to move, and aged sealant cracks. The right product, sized to the joint, copes much better.
Pricing service penetrations depends on quantities, condition and access. Call for a quote.
Why clients in Erriottwood choose us
- A fixed quote before work starts
- One contact handling all your sites
- Joints cleaned back to sound surfaces
- Work to your specification and the manufacturer’s guidance
Read how commercial sealant jobs are priced and our accreditations.
Surface by surface
Metal pipes
Copper and steel pipes are a common service penetration for fire-rated sealant. The tested detail sets the pipe size range, gap, depth and whether insulation can stay on.
Plastic pipes
Plastic waste pipes through slabs come up often. The detail decides whether sealant alone is enough, and we’ll never swap a specified collar for sealant.
Commercial clients in Erriottwood
Building owners and managing agents use us on everything from one building to a spread of sites. Several sites can go on one quote, so there’s one set of paperwork to deal with.
If you look after buildings for someone else, clear figures and clear communication matter. You get a fixed quote, an agreed scope and a walk round at the end, plus a 12-month guarantee.
Where services cross fire walls in Erriottwood
Central London is about 40 miles from Erriottwood. Office refits around the commuter belt bring new cabling through fire-resisting walls. Fire stopping of openings and penetrations in England falls under Approved Document B. The national BS 476 classes are due to drop out of it from 2 September 2029, leaving the European BS EN 13501-2 route, subject to transitional arrangements. We install whatever has been specified, to the product’s tested detail.
In a building such as Church of St Peter and St Paul, any service penetration through a fire-resisting wall should be sealed to the specified detail. On a site such as Kent Science Park, 2.7 miles west of Erriottwood, every fit-out that runs new services through a compartment wall leaves penetrations to seal with the specified product.
Erriottwood is about 4 miles south-east of Sittingbourne, in Kent. Looking for fire stopping in Erriottwood? We can help, as we do across Kent. Across Kent, 931 places are covered, Erriottwood among them. Sites around London have their own page, roughly 40 miles from Erriottwood.
Postcode districts covered here: ME9 for service penetrations. For a building on Christophers Row and Kingsdown Road or nearby, send details and we will quote for service penetrations. We also cover Kingsdown (1 mile west), Lynsted (1 mile north), Newbury (1 mile north-west), Bapchild (1 mile north-west) and Bogle (1 mile north) for service penetrations. Bigger towns within reach include Maidstone (11 miles west), Ashford (12 miles south), Canterbury (13 miles east), Sittingbourne (4 miles north-west), Whitstable (11 miles east) and Faversham (5 miles east).
Local landmarks in Erriottwood
We work on buildings around Black Lion Public House and Doddington Place Gardens. The nearest railway station is Teynham station, roughly 2.5 miles north-east. Other landmarks nearby include Newnham Castle (1.3 miles south-east) and Sittingbourne Heritage Museum (3.2 miles north-west).
Also in Erriottwood
Cost factors for service penetrations
The price varies from site to site. It mainly depends on:
- Removal of failed or old sealant
- Location, for remote and island sites
- Site requirements such as inductions and permits
- Backing rod, priming and other preparation
The work involved drives the cost: stripping out, preparation, sealing, access and phasing. Call for a quote and we’ll explain how it’s made up.
What to include in your enquiry
We can often quote from photos and a few details. It helps to include:
- The product your specification calls for
- A wide shot and a close-up of the area
- Drawings or a marked-up plan, if available
- Any dates the work must fit around
Specifications, drawings and tender packages are welcome with any enquiry, and we will price the work to it. Smaller jobs need nothing more than photos and a few notes.
Erriottwood: questions and answers
Is Erriottwood too small for you to travel to?
Not at all: smaller places are covered as well as towns. We work across Greater London and the South East. Where we can, we group nearby jobs to make the most of each trip.
Can you work at a site such as Kent Science Park, by Erriottwood?
Yes. We cover Erriottwood and the area around it, including industrial estates, business parks and retail parks such as Kent Science Park. To start, just give us a call on 01277 525 020 or email us with the unit, the joints involved and your access times.
What changes on 2 September 2029?
It mainly affects England, where Approved Document B is dropping its BS 476 references from 2 September 2029. Classification to BS EN 13501-2 becomes the expected evidence, subject to transitional arrangements. Scotland follows its own Technical Handbook, including clause 2.1.14 on service penetrations.
How do you deal with asbestos in old sealant?
The duty to manage asbestos sits with the building’s dutyholder, so for older buildings we ask for the asbestos register first. If anything suspect turns up, we stop until it’s tested.
How do we ask for a quote?
The quote form is the simplest route, though you can also ring 01277 525 020 or send details through our quote form. Include photographs or drawings if you have them.
Can you follow the specification on our project?
Yes. Send it with your enquiry, and the quote will be based on it, flagging anything that needs clarifying.
Can you send site paperwork?
Requirements differ from site to site, so tell us what you need and we’ll confirm it when we quote.