Expansion and movement joint sealing in Ware, Kent
Need expansion joint sealing in Ware? It’s simple: send details, get a quote, we seal, guaranteed.
- Expansion joints split through the centre of the bead
- Water dripping through deck or ramp joints
- Sealant pulling off the joint face
Expansion joint sealing in Ware
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Expansion joint sealing for commercial buildings in Ware
Long runs of brick or block have movement joints built in that most people only notice when the sealant has gone. Failed sealant here lets rain into the wall and can leave the joint full of debris. The old seal comes out, backing goes in and a sealant with the right movement class is applied with primer where the maker calls for it. Most enquiries involve expansion joints filled with dirt and stones and leaks through car park deck joints onto the level below, across blockwork control joints, brickwork movement joints and precast concrete panel joints. Sealant applicators who only do sealant are a different proposition from a general trade with a gun in the van: in Ware, that means joint design, primers and backing rod as standard.
Jobs around smaller places like Ware are planned so the whole job is done in one visit, with the right materials on hand. Tell us the joint widths if you can, and what drives or walks over them.
Building owners and contractors get the same cover: a 12-month guarantee on our workmanship. It doesn’t extend to damage, faults in the building or work by others, and we are upfront about that.
- Location
- Ware (CT3)
- Wider area
- Kent
- Cover
- 12 months on our workmanship
- Quotes
- A fixed quote before we start
- Phone
- 01277 525 020
- Updated
- 3 November 2026
Site staff or a sealant specialist?
For a quick touch-up, site staff may be fine, but larger jobs are different: a specialist brings efficiency, a consistent finish and a 12-month guarantee.
A short, simple internal joint is often within reach of a maintenance team. The usual problems come from preparation: sealing over old material, sealing onto damp or dusty surfaces, or a product that can’t take the movement.
From enquiry to sign-off
Before we leave any area, the masking comes off, the area is cleaned and every joint is checked with your site contact. If an area should be left alone while the sealant cures, we say how long and put signs out. Rural sites near Ware may need directions, gate codes or a contact on site. Send that with the details and we will confirm the plan with the quote.
- We look at the joints, their width and how they’ve failed.
- Next, we fix a price and confirm the sealant we propose for the movement.
- We strip out the old seal and prepare the faces, flagging any broken edges that need repair before sealing.
- Closed-cell backing rod is set to depth, or bond-breaker tape in shallow joints.
- Where the maker calls for primer, it’s applied first, then the bead goes in and is tooled to a concave finish.
- Finished joints are checked and backed by our 12-month guarantee.
Before we start on site
- Send your site hours and access windows
- Let building users know which areas are affected
- Send asbestos survey details if the building is pre-2000
Get a fixed quote
A handful of photos and a postcode is the fastest way to a quote. Send them through the quote form, or call the office on 01277 525 020 or send photos by email to discuss it first.
Read more
Common questions from Ware clients
Will you take on work at estates like Monkton Business Centre, close to Ware?
Yes. We cover Ware and the area around it, including industrial estates, business parks and retail parks such as Monkton Business Centre. A few photos and the unit address let us price the work.
Do we have to stop operations in Ware while the joints are sealed?
In the majority of cases the site keeps working. Joints are done in phases, a bay, aisle or deck at a time. We agree the sequence and timings with you before we start.
Are expansion joints and movement joints the same thing?
Movement joint is the broad term for any joint built in to let a structure move. In everyday use the two names are often swapped.
Is any job too small?
We quote for single jobs as well as large packages and programmes. Photos and a description are enough to start.
Is colour matching possible?
Often, yes. Many products come in a range of standard colours, and matching to RAL references or surrounding finishes is often possible. We confirm what’s available for the specified product when we quote.
Is Ware in your area?
Yes. Ware is in our area. For a quote, phone 01277 525 020 or send photos by email.
Do you use silicone or polyurethane in movement joints?
It depends on the movement, exposure and traffic. Low-modulus neutral-cure silicone suits many facade joints, while polyurethane is common in trafficked floor and deck joints.
Different surfaces, different methods
Podium joints
Podium joints often sit within a waterproofing system. Where the specification calls for sealant, we reseal and flag it if the membrane looks like the source.
Car park decks and ramps
Failed deck joints often show as leaks on the level below. We strip the old seal, prepare the edges and seal again.
After the work
Cleaning and maintenance staff play a part too. Share these points with them:
- Sweep decks, ramps and floors so grit doesn’t collect in the joints
- Act on the first tear or lifting edge rather than waiting
- Plan racking layouts so feet don’t land on a joint
- Put movement joints on the planned maintenance inspection round
Debris does more harm to joint sealant than most people realise. Stones pressed into the bead by wheels or feet can puncture it. A routine sweep is the simplest protection.
Joints sealed at the same time generally fail around the same time. Inspecting the whole run is worth the effort. We can suggest an order, worst joints first.
Traffic, movement and joints around Ware
Ware is about 60 miles from central London. The South East has large numbers of industrial estates and warehouses along the motorway corridors. The South East is one of the drier parts of the UK. Even so, yard and car park joints are only sealed when they’re dry and clean, and gritting in cold spells finds its way into open joints.
Across sites such as Birnham Farm Business Centre, 2.9 miles to the south of Ware, floor and movement joints can be sealed in phases so units keep working. Parks like Monkton Business Centre (to the north of Ware) combine paved areas, car parks and building elevations, each with joints that move.
Ware is about 6 miles south-west of St Lawrence, in Kent. We send applicators to Ware for movement joints. Across Kent, 931 places are covered, Ware among them. For work in that direction, see our London page, about 60 miles away.
Business premises anywhere in CT3 are within our area. Close to Ware, our area also takes in Westmarsh (1 mile north), East Stourmouth (2 miles north-west), Preston (2 miles west), West Stourmouth (2 miles north-west) and Hoo (3 miles north-east). Further afield, our area takes in Canterbury (8 miles west), Margate (7 miles north-east), Dover (11 miles south), Ramsgate (7 miles north-east), Broadstairs (8 miles north-east) and Whitstable (11 miles west).
Near you in Ware
In Ware, that means premises near The Way Out Inn and the streets around them. The nearest railway station is Minster station, about 2.9 miles north-east. Nearby you’ll also find White Mill (2.9 miles south-east). Not far away are Monk's Wall nature reserve.
Commercial clients in Ware
When you manage a building on behalf of an owner, clear figures and clear communication matter. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative, plus a 12-month guarantee.
Blocks and communal areas make up much of the work for housing associations and agents. We phase the work so people keep access, and each stage is agreed with your contact.
Why deal with it now?
A like-for-like reseal of a joint that keeps splitting rarely lasts. If the joint is too narrow or the product wrong for the movement, it needs a different approach. For buildings around smaller places like Ware, water damage can go unnoticed for longer, especially where a building isn’t used daily, so a failed joint can leak for a while before anyone sees it. Renewing joints in good time avoids the problem.
There’s no price list, since every building and every scope is different. Call for a quote.
Why choose Mastic Doctor in Ware
- Over 20 years of commercial sealing
- Work carried out by CSCS-carded applicators
- Clear, fixed quotes
- Workmanship guaranteed for 12 months
Take a look at what affects the cost and our accreditations.