Expansion and movement joint sealing in Shipton Green, West Sussex
Commercial sealant work in Shipton Green for contractors, FMs and building owners: expansion and movement joint sealing in walls, decks and floors, with a fixed quote first.
- Damp inside where a wall movement joint has failed
- Expansion joints filled with dirt and stones
- Layers of sealant in a movement joint
Expansion joint sealing across Shipton Green
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
General trades versus a specialist
Redoing a failed joint usually costs more than getting it right at the outset, because the whole bead must be removed and the faces cleaned back again. That’s why many clients bring in a specialist from the beginning.
Some joints are best left to specialists: for instance fire-rated seals that must match a tested detail, trafficked floor joints and external movement joints. A poor seal in places like these tends to cost more to put right later.
About our expansion joint sealing in Shipton Green
The seal is what lets a movement joint do its job. When the sealant splits or lets go, the gap fills with dirt and water, the joint can’t close properly and its edges begin to crumble. Resealing at the first signs of failure is far cheaper than repairing the material either side. We work on car park decks and ramps, podiums and floor movement joints and precast concrete panel joints, and the failures we are asked to look at most are weathered movement joint sealant that no longer flexes and expansion joints split through the centre of the bead. One point of contact handles commercial sealant work in Shipton Green from the first photos to the final walk-round, for single jobs and planned programmes alike.
Smaller community and commercial buildings around Shipton Green have their own movement joints in walls and floors. They tend to be overlooked until something leaks or cracks.
We sign every job off with a 12-month guarantee. It’s a plain promise: if the work we did fails within twelve months, we return to fix it.
- Location
- Shipton Green (PO20)
- Region
- West Sussex
- Cover
- 12 months on every job
- Quote
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Last updated
- 3 November 2026
How a job runs
When we get to site, we report to your site contact and complete whatever induction the building runs. Floors, finishes and fittings next to the joints are covered before any cutting starts, with the work itself usually taking a day or so for a modest run of joints, and longer where decks, ramps or floors are done in phases. Jobs in and around smaller places like Shipton Green are usually planned as a single visit, so we ask for photos and rough sizes first. Then the right materials arrive with us.
- We assess the joints on site or from photographs, noting widths and how each has failed.
- You receive a fixed quote stating the product and the movement it is rated for.
- Phasing is agreed so decks, floors or entrances can stay in use where needed.
- The failed seal is cut out and both joint faces cleaned back to sound material.
- Backing rod or bond-breaker sets the depth, primer goes on where specified, and the sealant is applied and tooled.
- Finished joints are inspected, the cure time confirmed and the 12-month guarantee applies.
Preparing the site
- Flag any permit to work we will need
- Share the asbestos register for older buildings
- Send any specification or drawings in advance
Get a fixed quote
Photos, drawings or a schedule of the joints and a fixed quote comes back to you. If the job needs a look first, we’ll arrange a site visit.
Advice
How the job changes by surface
Brickwork and blockwork joints
Masonry faces are often porous, dusty or crumbly. We clean them back to sound material and prime where the manufacturer specifies before the bead goes in.
Internal floor movement joints
Warehouse and retail floors have saw-cut induced joints and construction joints. A semi-rigid filler is common in trafficked industrial floors, with a flexible sealant where movement is larger.
Questions we are asked in Shipton Green
Is Shipton Green too far out for you?
No. Small places get the same service as large ones. We work across Greater London and the South East. Send photographs and a list of what needs doing, and we will plan the job to need as few trips as possible.
Do you take on work at healthcare sites like St Richard's Hospital?
Yes, hospitals are one of the sectors we cover. We follow the site’s permits, sign-in and infection-control procedures in every area.
Do you need to see the site first?
It depends on the job. Simple work can often be priced from photographs, while larger or less clear jobs get a site visit first.
How long will the joint resealing take?
It typically takes a short visit for a handful of joints, or several days or more for a car park deck or long runs of facade joints. Timings are set out in the quote, including any phasing.
Do your applicators hold CSCS cards?
Yes. We use CSCS-carded applicators.
Does weather matter for sealant work?
It can, for external work. Sealant won’t bond properly to a wet or frosty joint, so we watch the forecast and rearrange outside work if we have to. Internal work is far less affected.
Do you take on multi-site work?
Yes. Several buildings can share a single quote, with one point of contact.
Traffic, movement and joints around Shipton Green
Shipton Green lies within about 1 mile of the sea. Coastal yards and decks give their joints salt and wet weather to deal with, not just wheels, so it pays to keep them sealed. Rainfall across the South East, Shipton Green included, is lower than in many parts of the UK. External joints still wait for dry conditions, and gritting in cold spells finds its way into open joints.
Sites like St Richard's Hospital (5.2 miles north-east of Shipton Green) carry ambulances, deliveries and visitors’ cars over their road and deck joints.
Shipton Green is about 5 miles south-west of Chichester, in West Sussex. We send applicators to Shipton Green for movement joints, handled exactly as we handle every other area. Across West Sussex, 373 places are covered, Shipton Green among them. We also cover Portsmouth, some 10 miles away.
If you need expansion joint sealing in PO20, the process matches everywhere else we work: send details, get a quote, we seal, guaranteed. If your site is on Shipton Green Lane and Itchenor Road or close by, send details and we will quote for movement joints. Just outside Shipton Green, we also work in Somerley (1 mile south-east), Birdham (1 mile east), Almodington (2 miles south-east), Earnley (2 miles south) and East Wittering (2 miles south). Further afield, our area takes in Bognor Regis (7 miles east), Chichester (5 miles north-east), Selsey (5 miles south-east), Littlehampton (14 miles east), Rustington (15 miles east) and Portfield (5 miles north-east).
Landmarks near Shipton Green
For rail, the closest station is Bosham station, roughly 3.6 miles north. A little further out are Chichester Castle (4.9 miles north-east) and St Richard's Hospital (5.2 miles north-east). For a walk, there’s Pilsey Island.
Nearby places to Shipton Green
Other services in Shipton Green
Work for main contractors and building owners
For main contractors, we work as the sealant subcontractor on new-build and refurbishment projects. We work to your programme, your specification and your site rules, and our applicators hold CSCS cards.
When you manage a building on behalf of an owner, clear figures and clear communication matter. You get a fixed quote, an agreed scope and a walk round at the end.
Quoting for work in Shipton Green
We price every job individually. The main factors are:
- Site requirements such as inductions and permits
- Phasing around occupants
- Removal of failed or old sealant
- Which sealant the job calls for
The price depends on the quantity of joints, how much old material needs removing and how the joints are reached. Call for a quote once you have the details.
Sending details for a quote
For an accurate fixed quote, we need a clear picture of the site. Send us:
- The product your specification calls for
- Any dates the work must fit around
- Anything awkward about access or site hours
- Rough lengths or quantities, or drawings if you have them
To get a fixed quote, ring 01277 525 020 or send photos by email. Our quote form is another easy route.
Common problems we fix in Shipton Green
Repeated failure often traces back to the wrong product. A stiff or general-purpose sealant across a joint with large movement won’t cope. Movement capability is set out in BS EN ISO 11600.
These are often picked up first by site or facilities staff:
- Water getting into the wall through a failed joint
- Car park joints leaking onto vehicles below
- Weathered movement joint sealant that no longer flexes
- Joints packed with grit and debris
Schools such as Birdham CE Primary School have movement joints in their walls and floors that are easy to overlook.
Questions to ask before you book
- How joint depth will be controlled
- How they’ll work around occupants
- What site paperwork they can supply
- Will CSCS-carded applicators be on site?