Expansion and movement joint sealing in Hinxhill, Kent
Work needed on a movement joint in Hinxhill? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Brittle, chalky sealant on external joints
- Leaks through car park deck joints onto the level below
- New sealant over old, now failing
Expansion joint sealing for Hinxhill sites
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
About our expansion joint sealing in Hinxhill
Brickwork and blockwork walls have vertical movement joints at intervals. Once the seal fails, rain reaches the cavity and the joint can no longer close. The old seal is cut away, backing rod goes in at depth, and a low-modulus masonry sealant is gunned and tooled. If you have expansion joints split through the centre of the bead and sealant pulling off the joint face, we can put it right. A single leaking joint is often how a building in Hinxhill first comes to us: we check the joints around it and give you an honest view of what needs doing now and what can wait.
Smaller community and commercial buildings around Hinxhill have their own movement joints in walls and floors. They’re easily forgotten until water gets in or an edge breaks.
Every job ends the same way: guaranteed. You get a 12-month guarantee on our workmanship, and the quote explains what it covers.
- Place
- Hinxhill (TN25, TN24)
- Region
- Kent
- Guarantee
- 12 months on every job
- Quote
- A fixed quote before we start
- Telephone
- 01277 525 020
- Updated
- 3 November 2026
Keeping the joints sound
To get the most from the new sealant:
- Keep traffic off new joints until the cure time is up
- Raise snow-clearing blades over deck joints where possible
- Sweep decks, ramps and floors so grit doesn’t collect in the joints
- Report split or peeling joint sealant early
On car parks, winter clearance can damage deck joint sealant. Raising blades over joints where possible protects the seal.
An open joint fills with grit, and a joint full of grit can’t close. The edges then take the pressure and start to spall and the reseal becomes an edge repair as well. A sound seal keeps the joint working.
Towns and villages near Hinxhill
Other services in Hinxhill
General trades versus a specialist
The visible bead is only part of the job. Backing rod, primer where specified and a joint designed to move with the building are where general trades tend to cut corners.
Some joints are best left to specialists: fire-rated seals that must follow a tested detail, trafficked floor joints and external movement joints among them. Getting these wrong normally costs more in the end than doing them right.
Our process
Where the site stays busy, we agree a sequence with your contact so the disruption stays in one area at once. Each section is protected, cleaned back and sealed, then reopened once the sealant allows before the next one starts. Smaller jobs around Hinxhill can be grouped with others nearby. You will have a fixed quote before work starts.
- First, the joints are inspected for width, movement and the type of failure.
- Next, we fix a price and confirm the sealant we propose for the movement.
- The failed seal is removed and both faces are cleaned until sound and dry, flagging any broken edges that need repair before sealing.
- Closed-cell backing rod is set to depth, or bond-breaker tape in shallow joints.
- Primer goes on where the manufacturer specifies it, followed by the sealant, which is then tooled off.
- We check every joint before sign-off, and the work carries our 12-month guarantee.
Before we start on site
- Tell staff and tenants when we’ll be in
- Share your working hours and any access restrictions
- Flag any permit to work we’ll need
Request a quote
A handful of photos and a postcode is the fastest way to a quote. Send them through the quote form, or speak to us on 01277 525 020 or send details through our quote form to discuss it first.
Related advice
Different surfaces, different methods
Cladding panel joints
Cladding panels move more than masonry as they heat and cool. A sealant with the right movement class is chosen, and we will confirm the colours available for the specified product.
Car park decks and ramps
Water coming through deck joints is the usual first sign. The old seal comes out, the edges are prepared and the joint resealed.
Questions about Hinxhill
Will you take on work at estates like Ashford Retail Park, close to Hinxhill?
Yes. We cover Hinxhill and the area around it, including industrial estates, business parks and retail parks such as Ashford Retail Park. To start, just ring 01277 525 020 or send photos by email with the unit, the joints involved and your access times.
Is Hinxhill too small for you to travel to?
Not at all: smaller places are covered as well as towns. We cover Greater London and the counties of the South East. Send photos and a list of what needs doing, and we will plan the job to need as few trips as possible.
Can a joint be sealed if the edges are broken?
Sound edges are essential. If they’re damaged, we will say so before any sealing so you are not paying for a bead that won’t hold.
Will you quote for a small job?
Whatever the size, the process is the same: send details, get a fixed quote, we seal, guaranteed.
Can you work to our specification?
Yes. Send it with your enquiry, and we will price the work to it.
When can you be on site?
Give us your site hours and any access windows in your enquiry, and we will plan around them. You can reach the office between 8am and 5pm, Monday to Friday.
How long does movement joint sealing take?
That depends on joint lengths, widths, access and how much old sealant or filler needs removing. As a guide, it normally takes a short visit for a handful of joints, or several days or more for a car park deck or long runs of facade joints.
Leave it or put it right?
A failed joint seal doesn’t mean the slab, panel or wall needs replacing. Where the edges are sound, cutting out and resealing is enough. We will flag where edges need repair before sealing. Older rural buildings around Hinxhill move with the seasons, and rigid or tired sealant can’t keep up. A sealant with the right movement capability, correctly sized, lasts far better.
The specified product makes a difference, as does the preparation each joint needs, such as cutting out, priming or new backing rod. Access, phasing and site requirements come into it too.
Why appoint us
- CHAS accredited contractor
- A fixed quote before work starts
- Public liability insurance in place
- Constructionline member
Take a look at how commercial sealant jobs are priced or our accreditations and insurance.
Joints that move: notes for Hinxhill
Central London is about 51 miles from Hinxhill. The roads out of London are lined with trade parks and distribution sheds, and their floor joints take forklift and pallet-truck traffic all day. Hinxhill is in the South East, one of the UK’s drier regions. External slab and deck joints still need a dry, clean joint to seal, and where de-icing salt is spread in winter, open joints let it in.
Sites like WIlliam Harvey Hospital (to the west of Hinxhill) carry ambulances, deliveries and visitors’ cars over their road and deck joints. Another example is Mersham-le-Hatch Business Village (1.5 miles south-east of Hinxhill), where floors and yards would be done in stages around the occupiers. Retail sites such as Ashford Retail Park (to the south-west of Hinxhill) have car park, service yard and shop floor joints under constant traffic.
Hinxhill is about 3 miles east of Ashford, in Kent. We cover commercial sites throughout Hinxhill. We work across 931 places in Kent. Our London page has more on work in that area.
Commercial sites across TN25 and TN24 are covered for movement joints. Streets here include Hinxhill Road and Goodcheap Lane. Nearby places we also cover include Hinxhill Park (1 mile south-west), Sevington (1 mile south-west), Brook (2 miles north-east), Mersham (2 miles south) and Ridgeway (2 miles south-east) for movement joints. A short drive away, we cover Ashford (3 miles west), Canterbury (11 miles north-east), Folkestone (11 miles east), Whitstable (15 miles north), Faversham (12 miles north) and Hythe (8 miles south-east).
Around Hinxhill
Around Hinxhill, our work takes us to commercial buildings near The Blacksmith's Arms Public House, Conningbrook Lakes Country Park and The Norton Knatchbull School. The closest station to Hinxhill is Ashford International station, roughly 2.4 miles west. A little further out are William Harvey Hospital (0.7 miles west) and Ashford Designer Outlet (2.4 miles west). The countryside around Hinxhill includes Hatch Park.
Cost factors for movement joints
Sealant work doesn’t have a standard rate, because every site is different. What we look at:
- How accessible the joints are
- Which sealant the job calls for
- Phasing around occupants
- How much existing material needs removing
The work involved drives the cost: removing old material, preparing the joints, the product, the access and how the work is phased. Call for a quote and we will explain how it’s made up.
What to include in your enquiry
A good diagnosis starts with the right details. Tell us:
- Anything awkward about access or site hours
- Where the site is, with the postcode
- The type of building and who uses it
- Any dates the work must fit around
If there’s a specification, drawings or a tender package, send it with your enquiry, and we will price the work to it. For smaller jobs, photographs and a description will do.