Expansion and movement joint sealing in Eythorne, Kent
Looking for expansion joint sealing in Eythorne? Send us the details for a fixed quote, backed by a 12-month guarantee on the work.
- New sealant over old, now failing
- Leaks through car park deck joints onto the level below
- Movement joints with split or torn sealant
Need expansion joint sealing in Eythorne?
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Expansion joint sealing in Eythorne
Joints in car park decks and ramps are among the hardest-working in any building. Wheel loads, grit and de-icing salts attack the seal and the concrete either side. A sealant suited to traffic and the expected movement goes in, phasing bays so the car park can stay in use. We work on precast concrete panel joints, cladding panel joints and blockwork control joints, and the failures we’re asked to look at most are torn sealant in brick or block movement joints and rain penetration at brick or block movement joints. Whoever orders the work in Eythorne, the brief is usually the same: a clear scope, tidy work and joints that don’t fail again.
Jobs around smaller places like Eythorne are planned so the whole job is done in one visit, with the right materials on hand. Note joint widths and the traffic that uses them, and we will take it from there.
Every job ends the same way: guaranteed. Our workmanship is backed for 12 months, and the quote explains what it covers.
- Where
- Eythorne (CT15)
- Wider area
- Kent
- Guarantee
- 12 months on every job
- Quotes
- A fixed quote before we start
- Phone
- 01277 525 020
- Updated
- 3 November 2026
How the quote is worked out
Each job is priced on its own details. The main factors are:
- The product specified
- Joint width, depth and condition
- Induction, permit and paperwork requirements
- Whether the work must be split into stages
The work involved drives the cost: removing old material, preparing the joints, the product, the access and how the work is phased. Call for a fixed quote and we will explain how it’s made up.
Details that help us quote
A few photos plus some basic facts will normally do. It helps to include:
- Approximate linear metres or a joint schedule
- Where the site is, with the postcode
- The product your specification calls for
- The asbestos register, for older buildings
Send us photos, drawings or a joint schedule and a fixed quote comes back to you. If the job needs a look first, we’ll arrange a site visit.
Questions we’re asked in Eythorne
Is Eythorne too small for you to travel to?
Not at all: smaller places are covered as well as towns. Our area covers London and the South East counties. Good photos up front let us bring everything on the first visit.
Does your area include sites such as Pike Road Industrial Estate, near Eythorne?
Yes. Estates, retail parks and business parks around Eythorne, Pike Road Industrial Estate among them, are all within reach. Photos and a short description are enough for a first look.
Does the weather affect the work?
Outside, yes. Sealant needs a dry joint and a temperature within the product’s range, so frost, rain or cold mornings can delay outside work. Internal work is rarely affected.
What hours do you work?
Give us your site hours and any access windows in your enquiry, and we will schedule the work to suit. You can reach the office between 8am and 5pm, Monday to Friday.
How do you deal with asbestos in old sealant?
Asbestos is possible in some older mastics, particularly in buildings from before 2000. We check the asbestos register before cutting out old sealant in an older building, and if asbestos is suspected, work stops until it’s tested. Removing asbestos is a job for asbestos specialists, not us.
Do you offer coloured sealant?
It depends on the product. Some ranges are wide, others limited, so the available colours are confirmed with the quote.
Can the building stay open while you work?
Yes, with some planning. Tell us your site hours and access windows and we will plan around them.
Traffic, movement and joints around Eythorne
Eythorne lies roughly 62 miles out from central London. Warehousing clusters around the motorways that ring and radiate from London; their floors carry heavy traffic every shift. The South East is one of the drier parts of the UK. Outside joints in yards and car parks still have to be dry before sealing, and winter de-icing salt on car parks and ramps works into any open joint.
Schools such as Eythorne Elvington Community Primary School have movement joints in their walls and floors that are easy to overlook. If you manage units on an estate such as Pike Road Industrial Estate, 0.6 miles to the north of Eythorne, the floor joints under forklifts and pallet trucks and the slab joints in the yard are the ones to watch. Large sites such as Buckland Hospital (to the south of Eythorne) have car parks, service roads and long elevations with movement joints in brick and panels.
Eythorne is about 4 miles north of Dover, in Kent. If you’re looking for expansion joint sealing in Eythorne, we can help, as we do across Kent. Eythorne is one of 931 places in Kent on our list for movement joints. There’s a separate page for London, about 62 miles away.
We cover the CT15 postcode districts for movement joints. For a building on The Street, Sandwich Road and New Road or nearby, we can quote for movement joints. If your building is just outside Eythorne, we cover Waldershare (1 mile south-west), Sibertswold (2 miles south-west), Coldred (2 miles south-west), Halfway Street (2 miles south-west) and Lydden (3 miles south-west). A short drive away, we cover Canterbury (10 miles north-west), Margate (14 miles north), Dover (4 miles south), Folkestone (9 miles south-west), Ramsgate (11 miles north-east) and Broadstairs (13 miles north-east).
Local landmarks in Eythorne
Locally, jobs take us to sites close to The White Horse pub and the streets around them. For rail, the closest station is Shepherds Well station, about 1.8 miles west. Nearby you’ll also find Dover Transport Museum (3.5 miles south) and Buckland Hospital (4.7 miles south).
Keeping the joints sound
For the best life from the joints:
- Clear dirt from joint lines during routine cleaning
- Keep product details with the building records for the next reseal
- Inspect exposed joints once the cold weather has passed
- Reopen bays and walkways only after the stated cure time
Debris does more harm to joint sealant than most people realise. Grit trodden or driven into the joint works at the surface until it tears and decks and floors suffer most. Regular sweeping keeps joint lines clear.
Unsupported floor joint edges spall under forklift and pallet-truck wheels. Broken arrises jolt trucks, loads and drivers and the broken length grows with every pass. Sealing early protects the edges.
Why deal with it now?
A torn seal left alone usually gets worse. Water and debris get in, the joint jams and the edges spall. Acting at the first split keeps the cost down. Halls, stores and units around places like Eythorne may not be checked every day, so a failed joint can leak for a while before anyone sees it. Renewing joints in good time avoids the problem.
Access often affects the price as much as the sealing: easy-to-reach joints are quicker than those that need equipment to get to. Mention the access as part of your enquiry.
What you get with us
- Colours chosen to suit frames, cladding or finishes where possible
- Standard and matched colours in many product ranges
- Commercial sealant work since 2005
- Fully insured
From enquiry to sign-off
When we get to site, we report to your site contact and complete whatever induction the building runs. Everything around the joints gets protected before any cutting starts, with the work itself usually taking anything from part of a day to a couple of weeks, depending on joint lengths, widths and access. If others near Eythorne need work, visits can be combined. A fixed quote is given before anything starts.
- Photos, joint lengths and drawings come to us, or we visit.
- We compare each joint’s width with the movement and the sealant’s capability, and flag anything that needs an engineer.
- Old sealant and debris are cut out of every joint.
- Any broken arrises or friable edges are flagged before work goes further.
- The right sealant goes in at the right depth, bonded to the two sides only.
- Each area is handed back after its cure time, under our 12-month guarantee.
What we need from you
- Tell us what induction or permit system the site runs
- Agree which areas must stay open
- Explain the parking and delivery arrangements
Getting a fixed quote
Specifications, drawings and tender packages are welcome with any enquiry, and we will price the work to it. For smaller jobs, photographs and a description will do.
Advice
Also near Eythorne
Other services in Eythorne
How the job changes by surface
Concrete and precast panel joints
Joints between precast panels open and close with temperature and loading. The sealant needs the right movement capability and a controlled depth.
Joints between different materials
Some mixed-material joints suit a hybrid sealant. We pick the product for the materials and the movement, and confirm it in the quote.
What we can’t put right
A few problems need another trade or a different fix, and we say so rather than covering them up:
- A joint that has to be widened or re-detailed before it can work
- Concrete or masonry repairs along the arrises
- Failed waterproofing membranes on podiums, roofs or decks (a waterproofing specialist’s job)
Not sure which it is? You can ring 01277 525 020 or email drawings and photos and we will tell you honestly before you book.
What we seal
- Precast concrete panel joints
- Car park decks and ramps
- Cladding panel joints
- Podiums and floor movement joints
- Brickwork movement joints
- Blockwork control joints