Expansion and movement joint sealing in Elson, Hampshire
Our CSCS-carded applicators take on expansion and movement joint sealing in walls, decks and floors in Elson. Send details for a fixed quote.
- Car park joints leaking onto vehicles below
- Expansion joints filled with dirt and stones
- Spalled or broken joint edges in floors and decks
Expansion joint sealing for businesses in Elson
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Expansion joint sealing in Elson, done properly
Every structure moves a little, all the time: they expand in the heat, shrink as they dry, and shift under load. Movement joints are where that movement is absorbed and the seal across each one keeps out water and grit. We seal and reseal movement joints in walls, panels, decks and floors. The enquiries we see most involve car park joints leaking onto vehicles below and layers of sealant in a movement joint, across precast concrete panel joints, brickwork movement joints and podiums and floor movement joints. One point of contact handles commercial sealant work in Elson from the first photos to the final walk-round, for single jobs and planned programmes alike.
Small units near places like Elson are often converted farm buildings with new concrete floors. Joints in those slabs need a product suited to whatever runs over them, from pallet trucks to foot traffic.
We sign every job off with a 12-month guarantee. It’s a plain promise: if our work fails within that year, we put it right.
- Location
- Elson (PO12, PO13)
- Wider area
- Hampshire
- Guarantee
- A 12-month guarantee
- Quote
- Quoted before any work starts
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
What we can’t put right
Part of a good diagnosis is knowing where sealant stops. You will hear from us if the cause turns out to be one of these:
- Concrete or masonry repairs along the arrises
- Movement on a scale no sealant is meant to absorb
- Proprietary pre-formed expansion joint systems
If in doubt, call 01277 525 020 or send details through our quote form and we will say what we think before you book.
What we seal
- Podiums and floor movement joints
- Precast concrete panel joints
- Cladding panel joints
- Car park decks and ramps
- Blockwork control joints
- Brickwork movement joints
Surface by surface
Brickwork and blockwork joints
Vertical movement joints in brick and block walls let the masonry grow and shrink. They take a low-modulus sealant with a movement class to suit.
Car park decks and ramps
Deck and ramp joints take tyre loads, grit and de-icing salts. We use a sealant made for wheel loads and the expected movement with bays done in phases so the car park keeps running.
For managing agents and facilities managers
FMs need a contractor who is easy to get on site. Tell us what site paperwork you need, such as RAMS, an insurance certificate or CSCS details, and we’ll confirm with the quote.
We take on planned maintenance as well as one-off repairs: resealing failed joints building by building, on a schedule that suits your budget. Elson can form part of a wider programme.
Common questions from Elson clients
Is a smaller place like Elson outside your area?
Not at all: smaller places are covered as well as towns. We cover Greater London and the counties of the South East. We plan jobs in smaller places so return trips are kept to a minimum.
Do you cover business parks and estates near Elson, such as Brockhurst Gate Retail Park?
Yes. Estates, retail parks and business parks around Elson, Brockhurst Gate Retail Park among them, are all within reach. A few photos and the unit address let us price the work.
Which product is best for expansion joints?
It depends on the movement, exposure and traffic. Low-modulus neutral-cure silicone suits many facade joints, while polyurethane is common in trafficked floor and deck joints unless the specification names something else.
Do you guarantee expansion joint work?
Our workmanship on movement joints carries a 12-month guarantee. Damage from later works or traffic loads outside the joint’s design isn’t a workmanship fault.
Are your applicators CSCS-carded?
Yes. If you need card details for site access, let us know and we’ll send them with the quote.
How do you deal with asbestos in old sealant?
Managing asbestos is the dutyholder’s responsibility, so for older buildings we ask for the asbestos register first. If anything suspect turns up, we stop until it’s tested.
Do you hold CHAS accreditation?
Yes. CHAS accredited, Constructionline member, and our applicators hold CSCS cards.
Also near Elson
More services for Elson
What sets the cost
Quotes vary with the job. It mainly depends on:
- Induction, permit and paperwork requirements
- How much there is to seal
- Whether old sealant has to be cut out first
- Travel to remote or island sites
The product called for affects the cost, and so does the preparation. Access, phasing and site rules also count.
What we need to price the job
Whether it’s one area or a whole building, these details speed things up:
- The site address and postcode
- Access details, including height
- Approximate linear metres or a joint schedule
- Your programme or deadline
A good quote starts with a clear picture: what’s there, how much of it, how we reach it and what’s specified. Share whatever details you have and we will fill any gaps with a visit.
On site: what to expect
Before we leave any area, we remove the tape, clean down and inspect every joint, ready for your sign-off. If an area should be left alone while the sealant cures, we say how long and put signs out. Work in places the size of Elson is planned as a single visit where we can. Photos with rough sizes let us arrive with everything needed.
- We start with photographs, approximate lengths and any drawings, visiting where needed.
- Joint widths and expected movement are checked against what the sealant can take, and flag anything that needs an engineer.
- Old sealant and debris are cut out of every joint.
- Edges are checked, and we tell you if any need repairing before sealing.
- The right sealant goes in at the right depth, bonded to the two sides only.
- Areas reopen once cured, and the work carries our 12-month guarantee.
Preparing the site
- Send any specification or drawings in advance
- Warn occupants and staff about the work
- Tell us which areas need to stay in use
Get a fixed quote
Tell us about the building, the joints and when you need the work done, and we’ll put a fixed quote together. To get it moving, call the office on 01277 525 020 or email a schedule or drawings.
Read more
Doing it in-house
For a quick touch-up, site staff may be fine, but anything bigger is another matter: a specialist works through quantities efficiently, leaves a consistent finish and backs it with a 12-month guarantee.
Paperwork matters too. Many sites expect CSCS cards, RAMS and proof of insurance, and we will confirm the paperwork you need with the quote.
Warehouse floors and decks around Elson
The sea is no more than about 1 mile from Elson. Open joints in coastal car parks and yards let in salt-laden water as well as grit, and edges left open tend to break up faster. Rainfall across the South East, Elson included, is lower than in many parts of the UK. External slab and deck joints still need a dry, clean joint to seal, and gritting in cold spells finds its way into open joints.
At places like Cranbourne Industrial Estate, 1.7 miles to the south-east of Elson, joints are sealed a section at a time so operations carry on. Retail parks like Brockhurst Gate Retail Park (0.5 miles north-west of Elson) have long runs of car park and yard joints taking daily traffic. In a school such as Elson Infant School, movement joints in brick, block and hall floors tend to be forgotten until they leak.
Elson is about 1 mile north of Gosport, in Hampshire. If you are looking for expansion joint sealing in Elson, we can help, as we do across Hampshire. Across Hampshire, 723 places are covered, Elson among them.
We cover the PO12 and PO13 postcode districts for movement joints. Among the streets we cover are Ham Lane, Quay Lane and Avery Lane, and sites on any of them can send details for a fixed quote. Main routes into Elson include the A32, useful when we plan access and materials. If your building is just outside Elson, we cover Gosport (1 mile south), Forton (1 mile south), Bridgemary (1 mile north-west), Priddy's Hard (1 mile south-east) and Rowner (1 mile north-west). Bigger towns within reach include Havant (8 miles north-east), Eastleigh (14 miles north-west), Fareham (3 miles north-west), Horndean (9 miles north-east), Hedge End (10 miles north-west) and Waterlooville (7 miles north-east).
Landmarks near Elson
Locally, jobs take us to sites close to The Kings Head pub, St Vincent College and Brune Park Community School and the streets around them. For rail, the closest station is Portsmouth Harbour station, about 2.1 miles south-east. Other landmarks nearby include Search (1.6 miles south-east) and Portchester Castle (2.2 miles north-east). Open spaces near Elson include West of the River Alver and Portsdown Hill.