Expansion and movement joint sealing in Aultbea, Highland
Our CSCS-carded applicators take on expansion and movement joint sealing in walls, decks and floors in Aultbea. Send photos or drawings for a fixed quote.
- Expansion joints filled with dirt and stones
- Previous reseals laid over old sealant
- Damp inside where a wall movement joint has failed
Need expansion joint sealing in Aultbea?
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Expansion joint sealing for commercial buildings in Aultbea
Brickwork and blockwork walls have vertical movement joints at intervals that most people only notice when the sealant has gone. Failed sealant here lets rain into the wall and can leave the joint full of debris. The old seal comes out, backing goes in and a sealant with the right movement class is applied. If you have movement joints with split or torn sealant and water getting into the wall through a failed joint, we can help, whatever the surface. A specialist sealant contractor works differently from a general builder: on jobs in Aultbea, preparation and product choice get the time they need.
Travel to smaller places like Aultbea is planned so the work is done in one trip where possible. Photos, approximate widths and what uses the floor help us bring the right materials.
The 12-month guarantee covers our workmanship: preparation, application and finish. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Where
- Aultbea (IV22)
- Wider area
- Highland
- Guarantee
- 12 months on every job
- Quote
- Quoted before any work starts
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Warehouse floors and decks around Aultbea
Aultbea sits close to the coast, within about 1 mile. Near the sea, external slabs, ramps and decks see salt air and driven rain as well as their usual loads, which is why split joints are worth sealing before the edges deteriorate. Aultbea is in the west of Scotland, the wetter side of the country. External slab joints left open take plenty of rain. Dry spells are used for the external joints.
Around Aultbea, open joints collect water and debris, and the arrises are the next to go; we’ll tell you if the edges need repairing first.
Aultbea is in Highland. Across the IV22 postcode area, the process is the same: details in, fixed quote out, then sealing and a 12-month guarantee. Aultbea is one of 256 places we cover in Highland for movement joints.
Postcode districts covered here: IV22 for movement joints. We also cover Àird (1 mile west), Laide (2 miles north-east), Inverasdale (4 miles south-west), Poolewe (5 miles south) and Gairloch (9 miles south-west). Where a site is remote or on an island, we plan travel and materials carefully, so include the location in your enquiry.
Landmarks near Aultbea
Other landmarks nearby include Arctic Convoy Museum (under half a mile north-west). Open spaces near Aultbea include Loch a' Bhaid-luachraich.
When to bring in a specialist
There’s also the paperwork. Many sites expect CSCS cards, RAMS and proof of insurance, and we’ll confirm the paperwork you need with the quote.
Site maintenance staff can often handle a short internal joint. The usual problems come from preparation: sealing over old material, sealing onto damp or dusty surfaces, or a product that can’t take the movement.
When something else is needed
Part of a good diagnosis is knowing where sealant stops. You will hear from us if the cause turns out to be any of the following:
- Waterproofing layers buried beneath the sealant
- Damaged metal nosings or cover plates over a joint
- Concrete or masonry repairs along the arrises
If you are not sure, just phone 01277 525 020 or email a schedule or drawings and we will give you a straight answer.
Joints and surfaces we work on
- Precast concrete panel joints
- Car park decks and ramps
- Cladding panel joints
- Podiums and floor movement joints
- Blockwork control joints
- Brickwork movement joints
Diagnose, treat, sign off
In a busy building, we agree a sequence with your contact so the disruption stays in one area at once. Each area is protected, prepared and sealed, then handed back before the next one starts. Tell us who will meet us and how to get in at your building near Aultbea. We’ll confirm the plan with the fixed quote.
- First the joints are inspected, widths measured and the type of failure noted.
- You receive a fixed quote stating the product and the movement it is rated for.
- Where areas have to stay open, we agree a phased sequence before starting.
- The failed seal is cut out and both joint faces cleaned back to sound material.
- Backing rod or bond-breaker sets the depth, primer goes on where specified, and the sealant is applied and tooled.
- We check each joint with you, confirm the cure time and sign off under our 12-month guarantee.
Getting the site ready
- Tell us what induction or permit system the site runs
- Tell us your opening times and when work is allowed
- Make sure the joints can be reached
Quotes
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. To take the first step, ring 01277 525 020 or email us.
Related advice
What we are called out for in Aultbea
Three-sided adhesion is a common cause of early failure. Sealant fixed to the base and sides can’t flex, so it tears.
If one of these sounds familiar, it’s time for a closer look:
- Joints packed with grit and debris
- Torn sealant in brick or block movement joints
- Arrises breaking up along floor joints
- Leaks through car park deck joints onto the level below
Around Aultbea, each joint gets a filler or sealant matched to what crosses it and how much it moves.
Questions to ask before you book
- Are they CHAS accredited or on Constructionline?
- How they handle RAMS and site documents
- Whether primer will be used where the manufacturer specifies it
- How the existing material will be dealt with
Commercial clients in Aultbea
If you look after buildings for someone else, clear figures and clear communication matter. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative, plus a 12-month guarantee.
Whether you’re a managing agent, a property factor or an owner’s representative: send the details, accept a fixed quote, and we carry out and guarantee the work. We can agree access arrangements and keyholder contacts beforehand.
Questions we’re asked in Aultbea
Must our site in Aultbea stop work while the joints are done?
Rarely. Work is phased around your operations. The phasing plan comes with the quote.
Does a coastal location like Aultbea affect which sealant is used?
It can, yes: buildings near the sea take more wind-driven rain, and salt in the air nearer the shore. That puts more weight on product choice, primers where the manufacturer specifies them, and correct joint sizing.
Is colour matching possible?
It depends on the product. Some ranges offer many colours, others very few, so the available colours are confirmed with the quote.
Which sealant will you use?
If the job is specified, we follow the specification. If not, we choose for the movement, the surfaces and the conditions, in line with the manufacturer’s guidance.
Do you hold CHAS accreditation?
Yes. We’re CHAS accredited and a Constructionline member, which helps with supplier vetting.
Are you fully insured?
Yes. We’re fully insured, including public liability cover.
What happens if old sealant might contain asbestos?
The duty to manage asbestos sits with the building’s dutyholder, so for older buildings we ask for the asbestos register first. If anything suspect turns up, we stop until it’s tested.
Other services in Aultbea
What the job involves on each surface
Concrete and precast panel joints
Joints between precast panels open and close with temperature and loading. The sealant needs the right movement capability and a controlled depth.
Podium joints
Podium decks are exposed and often trafficked. A sealant suited to both traffic and exposure is used.