Commercial sealant contractors in Sturry, Kent
Sealant work in Sturry for main contractors, managing agents and facilities managers: sealant work for offices, shops, hotels and other commercial buildings, quoted at a fixed price.
- Shrunken sealant along kitchen worktops and splashbacks
- Messy, uneven beads from earlier work that let the building down
- External beads that have gone brittle and cracked
Commercial sealant contractors for Sturry sites
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Commercial mastic work in Sturry
On a commercial site, sealant turns up in more places than people expect: washroom fittings, kitchen worktops, window boards, partition heads and the line where floors meet walls. Externally it keeps rain out of frame perimeters, panel joints and movement joints. Our applicators work on both the inside and the outside of the building, matching the sealant to the location instead of using one product throughout. We work on window and door perimeters, kitchen worktops and splashbacks and movement joints in walls and floors, and what we’re called in for most is frame mastic that has hardened and come away from the wall and messy, uneven beads from earlier work that let the building down. Most enquiries from Sturry start with one failed joint and grow into a wider look at the building: we check the joints around it and give you an honest view of what needs doing now and what can wait.
On a typical commercial building in Sturry, the joints that fail first are the hardest-worked ones: frame perimeters in the sun, floor joints at doorways and anything that gets wet every day.
In a smaller place such as Sturry, commercial buildings are typically a mix of shops, a pub or café, a school, a surgery and perhaps a few business units. Each job is modest, yet a joint in a small café needs the same cutting out, cleaning and sealing as one in a city office.
Building owners and contractors get the same cover: a 12-month guarantee on our workmanship. It doesn’t extend to damage, faults in the building or work by others, and we are upfront about that.
- Place
- Sturry (CT2)
- Wider area
- Kent
- Cover
- 12 months on our workmanship
- Price
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Working on commercial sites near Sturry
Rainfall across the South East, Sturry included, is lower than in many parts of the UK. Even so, outside sealing waits for a dry joint, and cold, damp mornings can delay it. At least three named trading, business or retail sites lie within about 3 miles of Sturry. Sites like these see regular refits, with shopfronts, offices and staff areas to seal.
For a retailer at a site such as Buddy's Retail Park, under half a mile north-west of Sturry, the joints clients see are as much part of the fit-out as the shelving. For premises near Sturry station, which lies south of Sturry, footfall is part of the plan: work is phased so shops and offices keep trading.
Sturry is about 3 miles north-east of Canterbury, in Kent. If you’re looking for commercial sealant contractors in Sturry, we can help. 931 places across Kent fall within our area, Sturry among them. For work in that direction, see our London page, about 54 miles away.
Commercial sites across CT2 are covered for sealant joints. Streets here include High Street, Park View and Link Road, and sites on any of them can send details for a fixed quote. Nearby places we also cover include Broad Oak (1 mile west), Westbere (1 mile east), Calcott (1 mile north), Hersden (2 miles east) and Hicks Forstal (2 miles north) for sealant joints. Bigger towns within reach include Canterbury (3 miles south-west), Margate (12 miles north-east), Dover (14 miles south-east), Folkestone (15 miles south), Ramsgate (13 miles east) and Broadstairs (14 miles east).
Local landmarks in Sturry
Locally, jobs take us to sites close to Frank Montgomery School, Chequer's Wood and Old Park and The Swan Inn. There’s a railway station in Sturry itself: Sturry station. Other landmarks nearby include Canterbury Roman Museum (2.6 miles south-west) and St Martins Hospital (2.1 miles south). For a walk, there’s West Blean and Thornden Woods.
What sealant work can’t fix
Being straight saves everyone time. New sealant won’t cure:
- Broken glass or blown double-glazed units
- Roof leaks that only look like a joint problem
- Structural cracks or movement the joints weren’t designed for
If in doubt, call the office on 01277 525 020 or email drawings and photos and we’ll say what we think before you book.
Joints and surfaces we work on
- Washrooms and tea points
- External facade joints
- Kitchen worktops and splashbacks
- Window and door perimeters
- Floor and threshold joints
- Movement joints in walls and floors
Site staff or a sealant specialist?
The visible bead is only part of the job. Correct depth, the right primer and a sealant matched to the movement are easy to get wrong without experience.
Putting right a botched joint often costs more than sealing it well at the start, because the whole bead must be removed and the faces cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.
Your questions answered
Can you match sealant colours for premises in Sturry?
Yes, sealants come in a wide range of standard colours, and matching to RAL references, cladding, stone or frames is a common request. Available colours for the product are confirmed with the quote.
Is Sturry too small for you to travel to?
No. Small places get the same service as large ones. London and every South East county are within our area. Where we can, we group nearby jobs to make the most of each trip.
Will you just go over the old sealant?
No. We cut the old material out and clean the joint back before sealing, because fresh silicone will not bond with aged silicone.
Do you check for asbestos before removing sealant?
In buildings from before 2000 in particular, some old mastics and sealants may contain asbestos. We ask to see the asbestos register or survey before disturbing old sealant, and anything suspect is left until it has been tested.
Is it OK to apply fresh sealant over existing beads?
Every scrap of failed sealant is removed before the new bead goes on. Sealing over traps water and lifts once the joint moves and isn’t worth paying for.
Does commercial sealant work come with a guarantee?
It’s backed by our 12-month guarantee. Should a joint we sealed give trouble during those 12 months, let us know and we will look at it.
How long does a job like this take?
It depends on the scope, though a typical visit typically takes a few hours for one area, or a planned series of visits across a bigger building. For bigger or phased jobs, we’ll set out a timescale with the quote.
Towns and villages near Sturry
What else we do in Sturry
What happens if it’s left?
A cheaper quote sometimes means the old bead stays in. New sealant laid on old silicone has nothing to bond to, so it peels. Our prices always include removal of the failed bead and full joint preparation. Over time, UV, weather and movement wear any sealant out. Renewing it in good time keeps the building weathertight.
The price depends on how many linear metres there are, how much old material needs removing and how the joints are reached. Call for a quote once you have the details.
Why appoint us
- Colour options checked against the specified product
- Workmanship guaranteed for 12 months
- Joints cleaned back to sound surfaces
- Commercial sealant work since 2005
See what affects the cost and our accreditations.
Diagnose, treat, sign off
Working in a building that stays open takes some planning. We sign and contain the area we are in, keep walkways clear and work section by section so the rest of the building stays in use. Several jobs near Sturry can be grouped on one trip. Tell us your site hours and we’ll plan around them.
- Send details through our quote form, or ask for a site visit.
- We diagnose the cause of failure and price a fixed scope.
- Work is phased around your occupiers where areas need to stay in use.
- Every failed bead is removed rather than covered.
- Each joint gets a suitable sealant, laid to depth and tooled.
- A final walk-round, then the 12-month guarantee applies.
Preparing the site
- Arrange parking or a loading space
- Have the specification and drawings to hand
- Send asbestos survey details if the building is pre-2000
Request a quote
Need a figure for a tender or a budget? We will quote against your scope and drawings that you can work with. For a chat about it beforehand, speak to us on 01277 525 020 or send details through our quote form.
Related advice
What the job involves on each surface
Shop fronts and retail fit-outs
Most shops can’t close for a reseal. We plan around the access windows the store gives us, working in sections where that helps.
Commercial kitchens and tea points
In kitchens, sealant lines at worktops, sinks and wall panels take heat, grease and daily cleaning. Proper degreasing comes before any new sealant, with a food-safe or hygienic product wherever food contact can happen.
When to call us in Sturry
A good share of the joints we inspect were topped up instead of being renewed. New silicone has nothing to key into, so the top layer lifts, holds water and hides what’s going on. By the time it shows, there can be two or three layers to cut out.
Clients usually get in touch after noticing something like this:
- Frame sealant that has cracked, shrunk or pulled away
- Black mould through washroom sealant that won’t clean off
- Hardened, chalky sealant on south-facing or exposed elevations
- Shrunken sealant along kitchen worktops and splashbacks
If you have premises on more than one site, say at Buddy's Retail Park and Canterbury Retail Park, one contractor and one quote can cover both.
Comparing quotes
- What site paperwork they can supply
- How the existing material will be dealt with
- Which product they’ll use, and why it suits the joint
- Can the work be phased to keep areas open?