Commercial sealant contractors in Furzeley Corner, Hampshire
Planning work on a sealant joint in Furzeley Corner? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Movement joints packed with grit and debris
- Hardened, chalky sealant on south-facing or exposed elevations
- A top-up bead over failed sealant, now lifting
Commercial sealant contractors in Furzeley Corner
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Commercial mastic work in Furzeley Corner
Sealant joints are easy to overlook until one lets water in. Mastic Doctor works as a commercial sealant contractor for facilities managers, managing agents and main contractors. Our job is to diagnose the failure, remove the old bead and seal again using a product chosen for the movement and exposure. If you are dealing with untidy joints in a reception, shop floor or lobby and black mould through washroom sealant that won’t clean off, we can put it right, whatever the surface. For commercial sealant work in Furzeley Corner, you deal with one contact from quote to sign-off, whether it’s one building or several.
In an occupied building in Furzeley Corner, the job is planned so areas stay in use: washrooms in turn, floors in sections and entrances kept open.
Work in smaller places such as Furzeley Corner tends to come one building at a time: a pub kitchen, a hall, a small office. We plan the visit so everything on the list is done in one go, with the right products and colours on hand.
The 12-month guarantee covers our workmanship: the preparation, the sealing and the tooling. It doesn’t extend to damage, other trades’ later work or movement the joint was never designed to take.
- Location
- Furzeley Corner (PO7)
- Wider area
- Hampshire
- Guarantee
- A 12-month guarantee
- Quotes
- Fixed quote, scope in writing
- Call
- 01277 525 020
- Updated
- 3 November 2026
Surface by surface
Shop fronts and retail fit-outs
In retail, sealant is on show. Counters, display units, shopfront frames and floor trims all need a neat line, frequently colour-matched to the fit-out. We will confirm the colours available for the specified product.
Facade and cladding joints
Facade sealant failures can be hard to spot from the ground. Close-up photos or a site visit tell us what’s needed, with colours confirmed for the product chosen.
After the work
Every sealant joint needs some looking after, and their life depends on movement, exposure, cleaning and use. We suggest:
- On pre-2000 buildings, share the asbestos information before work starts
- Make sure ventilation in wet areas is switched on and working
- Brief cleaning contractors to avoid scourers and blades on sealant
- Put external and wet-area joints on a regular inspection round
Our workmanship on each job is backed by a 12-month guarantee. File the handover note with the building records so it’s easy to find if a joint we sealed gives trouble inside the 12 months.
Tenants and staff spot black or split sealant quickly, and in a hotel, office or shop it makes the whole space look neglected. Replacing it on a planned cycle keeps complaints down.
How a job runs
Where the site stays busy, the work is phased so only one area is out of use at a time. Each section is protected, cleaned back and sealed before we move to the next. For a building around Furzeley Corner, tell us how to find it and who will meet us. Send that with the details and we’ll confirm the plan with the quote.
- We start with the evidence: photographs, drawings or a look on site.
- A fixed quote follows, with removal and preparation included.
- Sequence, access and working times are settled before the first joint is touched.
- The failed sealant comes out and the faces are prepared, with primer where required.
- Depth is set with backing, then the sealant is applied, tooled and the area tidied.
- Completed areas are signed off with you under our 12-month guarantee.
Preparing the site
- Explain the parking and delivery arrangements
- Confirm the product named in the specification
- Let us know about inductions and permits
Getting a fixed quote
Need a figure for a tender or a budget? We will quote against your scope and drawings you can plan around. For a chat about it beforehand, phone 01277 525 020 or email the details over.
Advice
For managing agents and facilities managers
Building owners and managing agents use us on sealant work across single buildings or whole portfolios around Furzeley Corner. Several sites can go on one quote, which keeps the paperwork simple.
Main contractors use us as their sealant subcontractor, on new build and refurbishment alike. We work to your programme, your specification and your site rules.
Shops, offices and hotels in and around Furzeley Corner
Furzeley Corner sits close to the coast, within about 3 miles. Shopfronts, frames and external joints on commercial buildings there take wind-driven rain and, closer to the shore, salt in the air. We choose a product rated for the exposure, then confirm the colours available for it. The 3 miles around Furzeley Corner take in two named trading estates, business parks or retail parks. Units on sites like these change tenants and get refitted, and each refit leaves joints to seal.
If you have premises on more than one site, say at Parklands Business Park and Dunsbury Hill Business Park, one contractor and one quote can cover both. If you run an office at a site such as Parklands Business Park, under half a mile north of Furzeley Corner, the sealant at reception desks, tea points and frames ages with each fit-out. Premises within reach of Cosham station (3.3 miles south of Furzeley Corner) often have busy frontages where joints are seen by everyone passing.
Furzeley Corner is about 1 mile west of Waterlooville, in Hampshire. Our applicators travel to Furzeley Corner for work on sealant joints. Furzeley Corner is one of 723 places we cover in Hampshire. Portsmouth is covered too, some 6 miles away.
Work on sealant joints is covered throughout PO7, for business premises of every kind. For a building on Furzeley Corner, Sheepwash Lane and Furzeley Road or nearby, we can quote for sealant joints. Just outside Furzeley Corner, we also work in Soake (1 mile north-east), Waterlooville (1 mile east), Purbrook Heath (2 miles south), Hart Plain (2 miles east) and Cowplain (2 miles east). Nearby towns on our patch include Gosport (7 miles south-west), Havant (4 miles south-east), Eastleigh (13 miles north-west), Fareham (6 miles south-west), Horndean (3 miles north-east) and Chandler's Ford (15 miles north-west).
What’s near Furzeley Corner
In Furzeley Corner, that means premises near The Mead End pub and Cowplain Community School, among other places. The nearest railway station is Cosham station, about 3.3 miles south. Other landmarks nearby include Portchester Castle (4.2 miles south-west) and Queen Alexandra Hospital (2.7 miles south). Open spaces near Furzeley Corner include Portsdown Hill and St Clair's Meadow.
When something else is needed
We check first that sealant really is the fix. It isn’t the answer for:
- Roof leaks that only look like a joint problem
- Cracking that needs a structural engineer to look at it
- Broken glass or blown double-glazed units
Not sure which it is? You can call the office on 01277 525 020 or email drawings and photos and we will tell you honestly before you book.
Where we work in Furzeley Corner
- Kitchen worktops and splashbacks
- Floor and threshold joints
- External facade joints
- Window and door perimeters
- Washrooms and tea points
- Movement joints in walls and floors
Questions we’re asked in Furzeley Corner
Is Parklands Business Park, near Furzeley Corner, within your area?
Yes, sites like Parklands Business Park are within our area, along with the rest of Furzeley Corner. A few photos and the unit address let us price the work.
Our building in Furzeley Corner is near the coast: does that change the sealant?
It can. Wind-driven rain and, closer to the shore, salt air are harder on external joints. We choose the product for the exposure, prime where the manufacturer requires it and size the joint for its movement.
Do you work directly for building managers?
Yes. Use our quote form to send the site details, or phone or email us, and tell us what site paperwork you need.
Is it fine to apply new sealant on top of old?
No. We cut the old material out and clean the joint back before sealing, since fresh sealant will not bond reliably to aged material.
What about asbestos in old mastic?
Some older mastics did contain asbestos. So we check the register first and stop work on anything suspect until it’s tested.
Do you take on multi-site sealant work?
Yes. We regularly take on multi-site work and planned maintenance programmes.
Will your applicators have CSCS cards?
Yes. Should the site need card details in advance, tell us and we will confirm them with the quote.
Should maintenance staff do it?
General builders and handymen seal joints, but it isn’t their main trade. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint.
Some joints are best left to specialists: fire-rated seals that must follow a tested detail, trafficked floor joints and external movement joints among them. Getting these wrong normally costs more in the end than doing them right.