The Mastic Doctor team standing beside their branded vans outside an office building
Highland · Scotland

Commercial Sealant Contractors in Corry

Commercial sealant contractors in Corry, backed by over 20 years in commercial sealing. Fully insured and CHAS accredited.

  • Earlier reseals applied straight onto the failed bead
  • Untidy joints in a reception, shop floor or lobby
  • Sanitary sealant that has gone black and patchy
1
Send details
Send the specification, photos or a marked-up plan.
2
Get a quote
One fixed quote covering the agreed scope.
3
We seal
Prepared joints, the specified product, a tidy finish.
4
Guaranteed
12-month guarantee on our workmanship.
Covering the South East & Scotland
CHAS accredited
£5m PL insurance

Commercial sealant contractors for businesses in Corry

Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.

Do you need commercial sealant contractors in Corry?

A split down the middle of the bead tells a different story. Normally the movement was too much for the sealant chosen because the bead was too thin, the joint over-stretched or the movement class wrong. The same product in the same joint tends to fail the same way, which is why we look at the joint design as well.

It’s worth sending us details if you spot any of the following:

  • Shrunken sealant along kitchen worktops and splashbacks
  • Wall and floor joints that have lost their seal
  • Black mould through washroom sealant that won’t clean off
  • Messy, uneven beads from earlier work that let the building down

For any commercial premises in Corry, a lasting joint depends on full removal of the old sealant and clean, dry faces.

What your quote should include

  • The terms of the workmanship guarantee
  • How they’ll work around occupants
  • Is the sealant right for the movement and the substrate?
  • Health and safety accreditation such as CHAS

Our contractor checklist

About our commercial sealant contractors in Corry

On a commercial site, sealant turns up in more places than people expect: washroom fittings, kitchen worktops, window boards, partition heads and the line where floors meet walls. Externally it keeps rain out of frame perimeters, panel joints and movement joints. Our applicators work on both the inside and the outside of the building. Site teams most often ask us about untidy joints in a reception, shop floor or lobby and damp patches where an external joint has failed, on washrooms and tea points, kitchen worktops and splashbacks and movement joints in walls and floors. Whether you call it commercial sealant work, mastic application or joint sealing, in Corry it comes down to the same thing: failed joints cut out, faces prepared and the right sealant laid to the right depth.

Quotes for commercial sealant in Corry can come from photos and a joint schedule, or from a walk-round, with the scope listed so everyone knows what’s included.

Around smaller places such as Corry, the commercial buildings tend to be hospitality, local shops, schools, health centres and converted rural buildings. Their kitchens, washrooms and window perimeters all need joints that keep water out.

We stand by our work with a 12-month guarantee. That covers our preparation and application.

Where
Corry (IV49)
Region
Highland
Guarantee
12 months on every job
Price
A fixed quote before we start
Phone
01277 525 020
Last updated
3 November 2026
Mastic Doctor team members lined up next to their branded vans outside an office building

How the quote is worked out

Sealant work doesn’t have a standard rate, because every site is different. What we look at:

  • Removal of failed or old sealant
  • Any access equipment needed
  • Joint width, depth and condition
  • Travel to remote or island sites

The specified product makes a difference, as does the preparation each joint needs, such as cutting out, priming or new backing rod. Access, phasing and site requirements come into it too.

What we need to price the job

The more we know, the firmer the quote. When you get in touch, include:

  • Access details, including height
  • The postcode of the building
  • What the building is and how it’s used
  • The product your specification calls for

To get a fixed quote, call the office on 01277 525 020 or send details through our quote form with the site address and an outline of the work. Our quote form is another easy route.

When it isn’t the sealant

We seal joints; we don’t mend everything behind them. Sealant alone won’t deal with:

  • Broken glass or blown double-glazed units
  • Cracking that needs a structural engineer to look at it
  • Old mastic that tests positive for asbestos

If you’re not sure, just phone 01277 525 020 or send details through our quote form and we’ll give you a straight answer before you book.

Surfaces we seal

  • Floor and threshold joints
  • External facade joints
  • Washrooms and tea points
  • Movement joints in walls and floors
  • Kitchen worktops and splashbacks
  • Window and door perimeters

What happens if it’s left?

A failed seal around a window, worktop or panel doesn’t mean the element itself has to go. Often the fitting is sound and the joint is the only thing letting it down. Resealing normally costs far less than renewal. In Scotland, wind-driven rain finds a failed joint quickly, and for a smaller place like Corry, a repair visit takes planning, so it’s better to act early.

Small jobs and large programmes are priced from the same things: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote, and you will have a fixed figure to work with.

Why choose Mastic Doctor in Corry

  • Workmanship guaranteed for 12 months
  • Failed material removed, not covered up
  • Specification-led, product-correct work
  • Clear, fixed quotes

Take a look at our cost guide or how we’re accredited.

How a job runs

Our CSCS-carded applicators arrive with the sealants, primers and backing rod the job calls for. Joint faces are cleaned back to sound, dry surfaces, primer goes on where the manufacturer specifies it, and the sealant is tooled off neatly. Where we can, we combine work around Corry with other jobs nearby. Tell us how flexible your dates are.

  1. We start with the evidence: photos, drawings or a look on site.
  2. A fixed quote follows, with removal and preparation included.
  3. Sequence, access and working times are settled before the first joint is touched.
  4. The failed sealant comes out and the faces are prepared, with primer where required.
  5. Backing goes in, the new sealant is laid and tooled, and the area is left neat.
  6. We hand back each area with its cure time and our 12-month guarantee.

Getting the site ready

  • Let us know about inductions and permits
  • Have the specification and drawings to hand
  • Tell us which areas need to stay in use

Get a fixed quote

We quote a fixed sum against the scope you give us, so the cost is agreed before work starts. To ask for one, ring 01277 525 020 or email us.

Ask for a quote

Read more

Work for main contractors and building owners

Agents, factors and owners’ representatives all follow the same route: send details, get a fixed quote, we seal, guaranteed. We can agree access arrangements and keyholder contacts beforehand.

If you look after buildings for someone else, you need clear quotes and clear reporting. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative.

Shops, offices and hotels in and around Corry

Corry is within about 1 mile of the coast. Buildings near the sea put their external joints through more driven rain, with salt air nearer the beach. Where a frontage needs a particular colour, the product still has to suit that exposure. Corry is in the west of Scotland, the wetter side of the country. Frontage work is booked with a few days’ give for the weather. Weather-facing frames tend to need resealing before the sheltered ones

In hotels such as Broadford Hotel, under half a mile to the south of Corry, refurbishments usually mean bathroom, bar and reception joints where a matched sealant colour has to sit with the finishes.

Corry is in Highland. We send applicators to Corry for sealant joints. We work across 256 places in Highland, from busy centres to rural villages.

Postcode districts covered here: IV49 for sealant joints. Among the streets we cover are Ford Road, Riverbank and Liveras Park, and sites on any of them can send details for a fixed quote. Just outside Corry, we also work in An t-Àth Leathann (1 mile south), Blackpark (1 mile south-east), Harrapul (1 mile south-east), Kyleakin (7 miles east) and Kyle of Lochalsh (8 miles east). Remote and island addresses take more planning, from travel and ferries to the weather, so give the site location in your enquiry.

What’s near Corry

Well-known places in the area include Mackinnon Memorial Hospital (under half a mile north). The countryside around Corry includes Bheinn Shuardail and Lochan Cruinn.

Map of Corry © OpenStreetMap contributors

Corry: questions and answers

Is a smaller place like Corry outside your area?

Not at all: smaller places are covered as well as towns. Our area covers all of Scotland, cities, towns and islands alike. Where we can, we group nearby jobs to make the most of each trip.

Our building in Corry is near the coast: does that change the sealant?

It can. Wind-driven rain and, closer to the shore, salt air are harder on external joints. Product choice and preparation matter more, and sea-facing elevations are worth inspecting more often.

Can you handle sealant work across several sites?

Yes, within the areas we cover: South East England, Greater London and Scotland. One contact and one process for every building makes a portfolio easier to manage.

Can weather delay the job?

It can, when the joints are outside. Sealant won’t bond properly to a wet or frosty joint, so external work may be moved if conditions aren’t right. Internal work is far less affected.

Could the old sealant in an older building contain asbestos?

It’s possible in older buildings, especially those built before 2000. We ask to see the asbestos register or survey before disturbing old sealant, and anything suspect is left until it has been tested.

Who decides which product is used?

A specification, where there is one, decides it. If there isn’t one, it comes down to the joint: its movement, its surfaces and what it has to cope with.

Are you CHAS accredited and on Constructionline?

Yes. CHAS accredited, Constructionline member, and our applicators hold CSCS cards.

Accreditations

Trusted. Accredited. Insured.