The Mastic Doctor team standing beside their branded vans outside an office building
Kent · England

Coloured and colour-matched sealant in Little Chart, Kent

Coloured and colour-matched sealant for visible joints in Little Chart and across Kent. CHAS accredited and fully insured, with a 12-month guarantee.

  • Old colour-matched joints lifting at the edges
  • Previous reseals that don’t match the original
  • Standard-colour sealant spoiling a high-end finish
1
Send details
Send the specification, photos or a marked-up plan.
2
Get a quote
Scope agreed and priced before anything starts.
3
We seal
CSCS-carded applicators, the right product for each joint.
4
Guaranteed
12-month guarantee on our workmanship.
Covering the South East & Scotland
Constructionline member
£5m PL insurance

Need coloured sealant in Little Chart?

Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.

Common questions from Little Chart clients

Will our hotel in Little Chart need to close for the work?

Almost never. The work is phased so most rooms stay available. Tell us your quiet periods and access windows and we will plan around them.

Is Little Chart off your patch?

Not at all. Little Chart is within our area. We work across Greater London and the South East. We plan jobs in smaller places so return trips are kept to a minimum.

How much does the work cost?

That depends on the job: quantities, access, the product and any phasing. Call for a quote and we will price it properly.

Can you match any colour exactly?

No, not always. We choose the nearest standard colour.

How long does a typical visit take?

The duration is planned around your programme and the access we are given. You’ll have an expected duration with the quote.

Do your applicators hold CSCS cards?

Yes. If you need card details for site access, let us know and we’ll send them with the quote.

Does a coloured sealant perform differently from a standard one?

Colour is a choice within a product’s range, not a separate type of sealant. A properly prepared and tooled joint performs as the product intends, whatever the colour.

How we handle coloured sealant in Little Chart

On a finished interior or a high-quality elevation, the sealant is part of the look. We install coloured and colour-matched sealant so joints sit quietly against cladding, stone, brick, frames and shop-fit finishes, for clients in Little Chart. Performance decides the product; the colour is chosen from that product’s range. If you are dealing with smeared sealant on stone or joinery and fit-outs with a sealant colour in the specification, we can put it right, on shop-fit joinery and counters, hotel bathrooms and public areas and natural stone and brick alike. Whether you call it commercial sealant work, mastic application or joint sealing, in Little Chart it comes down to the same thing: the right product in a properly prepared joint.

In and around smaller places such as Little Chart, the commercial buildings we are asked about are often pubs, shops, village halls and barns converted to offices. Each has kitchens, washrooms and frames whose joints need renewing in time.

We stand behind the joints we seal: 12 months, guaranteed. It covers how we prepared and applied the sealant, and if something we did falls short, we return to it.

The Mastic Doctor team standing beside their branded vans outside an office building
Location
Little Chart (TN27)
Wider area
Kent
Guarantee
A 12-month guarantee
Quotes
A fixed quote before we start
Telephone
01277 525 020
Updated
3 November 2026

General trades versus a specialist

For a quick touch-up, site staff may be fine, but larger jobs are different: a specialist works through quantities efficiently, leaves a consistent finish and backs it with a 12-month guarantee.

General builders and handymen seal joints, but it isn’t their main trade. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint.

Working on commercial sites near Little Chart

Rainfall across the South East, Little Chart included, is lower than in many parts of the UK. Even so, outside sealing waits for a dry joint, and cold, damp mornings can delay it. A 2-mile radius around Little Chart takes in several hotels. Refits in hotels bring joints at vanity tops, bar counters and reception desks where the colour has to suit the scheme, and the work can be phased so the rest of the hotel keeps trading.

For any commercial premises in Little Chart, a lasting joint depends on full removal of the old sealant and clean, dry faces. Premises within reach of Charing station, 2.1 miles north of Little Chart, often have busy frontages where joints are seen by everyone passing.

Little Chart is about 5 miles north-west of Ashford, in Kent. If you are looking for coloured sealant in Little Chart, we can help. Little Chart is one of 931 places we cover in Kent for colour-matched joints. Sites around London have their own page, roughly 44 miles from Little Chart.

Postcode districts covered here: TN27. Just outside Little Chart, we also work in Little Chart Forstal (1 mile east), Pluckley (1 mile west), Fir Toll (2 miles south-west), Pluckley Thorne (2 miles west) and Chambers' Green (2 miles south-west). A short drive away, we cover Maidstone (13 miles north-west), Ashford (5 miles south-east), Canterbury (15 miles north-east), Sittingbourne (12 miles north), Faversham (10 miles north-east) and Hythe (15 miles south-east).

Around Little Chart

We work on buildings around The Swan Inn And Former Stables, among other places. The nearest railway station is Charing station, roughly 2.1 miles north. A little further out are Romden Castle (3.8 miles south-west).

Map of Little Chart © OpenStreetMap contributors

Diagnose, treat, sign off

Site rules come first: sign-in, induction and whatever permit system the building uses. Once we are cleared to begin, the joints are worked through in the order agreed with your site contact. Jobs in and around smaller places like Little Chart are normally planned as a single visit, so we ask for photographs and rough sizes first. That way the right products come on the day.

  1. We confirm the joint type and the product it needs.
  2. Your RAL reference, sample or photo is checked against that product’s colours.
  3. The nearest colour is agreed, with a sample bead where needed.
  4. The existing bead comes out, then faces are cleaned and backed.
  5. Edges are masked and the coloured sealant applied and tooled.
  6. We remove the masking and walk the finished joints with you.

Getting the site ready

  • Send asbestos survey details if the building is pre-2000
  • Clear stock, furniture or equipment away from the joints
  • Flag any permit to work we will need

Ask for a quote

Send us photos, drawings or a joint schedule are often enough for a fixed quote. Where a site visit makes more sense, we’ll arrange one.

Get a quick quote

Related advice

Aftercare for building managers

Regular inspection catches problems early. In particular:

  • Ask contractors to check the colour before resealing
  • Check a trial length in real light
  • Avoid abrasive pads on coloured sealant
  • Use one colour standard across multi-site work

Colours can soften with light and weathering. That is normal for exposed sealant.

Put the sealant colour into the specification or finishes schedule. Late decisions lead to substitutes and mismatches; fixing it early prevents rework.

Work for main contractors and building owners

FMs need a contractor who is easy to get on site. Tell us what site paperwork you need, such as RAMS, an insurance certificate or CSCS details, and we will confirm with the quote.

Housing associations and managing agents often need work done across blocks and communal areas. We phase the work so people keep access, with each stage agreed with your site contact.

What sets the cost

What shapes the price:

  • Joint width, depth and condition
  • The site’s rules and procedures
  • Removal of failed or old sealant
  • Phasing around occupants

The product called for affects the cost, and so does the preparation, such as cutting out, priming or new backing rod. Access, phasing and site requirements come into it too.

What we need to price the job

Diagnosis starts before we arrive. Let us know:

  • Specification clauses that apply
  • Any dates the work must fit around
  • A wide shot and a close-up of the area
  • Where the site is, with the postcode

A good quote starts with a clear picture: what’s there, how much of it, how we reach it and what’s specified. Share whatever details you have and we’ll fill any gaps with a visit.

Leave it or put it right?

Across a chain of shops or hotels, consistency matters. Setting one product and colour for every site avoids variation across the programme. Older rural buildings around Little Chart move with the seasons, and rigid or tired sealant can’t keep up. The right product, sized to the joint, copes much better.

Every site prices differently: the joint sizes, the specified product, access and working hours each have a bearing. Send the details and a fixed figure follows.

Why us?

  • One phone line for London, the South East and Scotland
  • Coloured sealants to suit the setting, where available
  • Colour agreed before work starts
  • Health and safety: CHAS accredited

See how commercial sealant jobs are priced or our accreditations and insurance.

Accreditations

Trusted. Accredited. Insured.