Forres coloured sealant
Coloured and colour-matched sealant for visible joints throughout Forres and nearby, by CSCS-carded applicators. Fully insured and CHAS accredited.
- Failed coloured sealant that has split or peeled
- Standard-colour sealant spoiling a high-end finish
- Patch repairs in several different colours
Coloured sealant across Forres
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Coloured sealant in Forres
We can agree a short trial length before the full run. Sealant can look slightly different once it has cured, and again in different light. Tell us who needs to approve the colour and we will plan for it. If you have old sealant that has yellowed, darkened or faded and fit-outs with a sealant colour in the specification, we can help, on shop-fit joinery and counters, natural stone and brick and cladding panels alike. Searching for sealant specialists in Forres? Mastic Doctor has worked for contractors, FMs and building owners since 2005.
In a town the size of Forres, one owner may look after a shop, an office and a unit on an estate. Bringing the sealant for every building under one contractor and one quote saves time.
Every job ends the same way: guaranteed. You get a 12-month guarantee on our workmanship, and the quote explains what it covers.
- Where
- Forres (IV36)
- Region
- Moray
- Guarantee
- A 12-month guarantee
- Price
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Our process
Occupied buildings need a little choreography. We sign and contain the area we’re in, keep walkways clear and work section by section so the rest of the building stays in use. Several buildings in and around Forres can be done on one programme, with one quote. Give us access times for each.
- First we agree which sealant type the joint needs.
- We compare the target colour with the colours available.
- You approve the colour, on site if it’s critical.
- We cut out the existing bead, clean and set the depth.
- We mask, seal and tool to a clean line.
- Masking comes off and the work is checked with you.
Getting the site ready
- Warn occupants and staff about the work
- Let us know about inductions and permits
- Agree which areas must stay open
Request a quote
A good quote starts with a clear picture: the joints involved, quantities, access and the product called for. Send what you have, and we’ll arrange a site visit if anything is unclear.
Advice
What sets the cost
We price every job individually. The things that drive the figure:
- Backing rod, priming and other preparation
- Any access equipment needed
- Removal of failed or old sealant
- The total length or number of joints
Pricing colour-matched joints depends on quantities, condition and access, and any specification that applies. Call for a quote.
What to include in your enquiry
A good diagnosis starts with the right details. Let us know:
- Photos of the joints, close up and from further back
- When you need the work done
- Whether the building will be occupied during the work
- Asbestos survey details if the building is older
We quote a fixed sum against the scope you give us, so you know the figure before anyone is on site. To start the process, ring 01277 525 020 or send photos by email.
Questions we’re asked in Forres
Does a hotel in Forres need to shut while its sealant is renewed?
Rarely. Rooms or floors are done in turn, so the rest of the hotel keeps trading. Housekeeping and our team agree each day’s rooms.
Is Waterford Industrial Estate, near Forres, within your area?
Yes, sites like Waterford Industrial Estate are within our area, along with the rest of Forres. To start, just speak to us on 01277 525 020 or use the quote form with the unit, the joints involved and your access times.
How do you deal with asbestos in old sealant?
Managing asbestos is the dutyholder’s responsibility, so for older buildings we ask for the asbestos register first. If anything suspect turns up, we stop until it’s tested.
Can you quote from photographs?
It depends on the job. Straightforward work can often be priced from photos and measurements, and bigger or more complex jobs normally get a visit.
Do you cover Forres?
Yes. We take on work across Forres, and the same phone number covers every area.
Do your applicators hold CSCS cards?
Yes. We use CSCS-carded applicators, which many sites require.
Can we approve the colour on site?
Yes. We can fit a sample into the programme so sign-off doesn’t hold up the work.
Also in Forres
Frontages, fit-outs and joints in Forres
Forres lies within about 3 miles of the sea. Exposed frontages near the sea are hard on sealant, so the product has to suit the weather as well as the look. We choose a product rated for the exposure, then confirm the colours available for it. Forres has at least three named business or industrial parks inside a 3-mile radius. Each new occupier on a park like these tends to refit, from reception to staff kitchen.
If you run a unit on an estate such as Waterford Industrial Estate, 0.5 miles north of Forres, the trade counter, offices and staff facilities have joints to look after as well as the warehouse. A hotel such as Victoria Hotel, less than half a mile to the north-west of Forres, shows how much sealant a hospitality building has on show, from bathroom joints to the bar.
Forres is about 12 miles west of Elgin, in Moray. We cover Forres, with the same fixed quotes and 12-month guarantee as everywhere else. 59 places across Moray fall within our area, Forres among them. Sites around Aberdeen have their own page, about 64 miles away.
Work on colour-matched joints is covered throughout IV36. If your site is on Church Road, Market Street and High Street or close by, we can quote for colour-matched joints. With the A96 and A940 nearby, Forres is easy to get to with materials and equipment. Close to Forres, our area also takes in Red Craig (1 mile south-west), Mundole (2 miles south-west), Rafford (2 miles south-east), Dyke (3 miles west) and Moor of Granary (3 miles south-east). Nearby towns on our patch include Elgin (12 miles east), Lossiemouth (14 miles north-east), Ashgrove (12 miles east), Burghead (8 miles north-east), Hopeman (10 miles north-east) and Lhanbryde (15 miles east). Forres is one of the busier places in Moray, and its commercial and public buildings are all within our area. Where a site is remote or on an island, travel and materials need planning ahead, so the full address helps from the start.
Around Forres
Locally, jobs take us to sites close to Forres Academy, Red Lion Hotel and Roysvale Park and the streets around them. The closest station to Forres is Forres station, about 0.5 miles north-west. A little further out are Forres Castle (less than half a mile north) and Leanchoil Hospital (1 mile east). Not far away are Sanquhar Loch and Cluny Hill.
Different surfaces, different methods
Cladding panels
Multi-coloured cladding needs a joint colour that works across it. A neutral tone from the range often works best and we can trial it first.
Powder-coated and anodised frames
Window, door and shopfront frames in RAL colours often need a sealant to suit. The frame colour is checked against what the product is made in, and you confirm the choice.
Signs you need coloured sealant in Forres
Most enquiries start with a joint that looks wrong: a pale bead on a dark frame, or an old seal that has discoloured. A better-matched colour fixes the appearance without changing the joint’s job.
Typical triggers for a call:
- Dirty, discoloured joints in public areas
- Weathered sealant that no longer matches
- A bead that fights the cladding or frame colour
- Previous reseals that don’t match the original
Occupiers with premises at both Waterford Industrial Estate and Greshop Industrial Estate could have the sealant at each handled under one quote.
Questions to ask before you book
- How they’ll work around occupants
- Whether primer will be used where the manufacturer specifies it
- Who will actually carry out the work
- What level of public liability insurance do they hold?
What sealant work can’t fix
We check first that sealant really is the fix. It won’t put right:
- A colour that never alters with age
- A guaranteed perfect match to every finish
- Restoring stained stone or masonry next to old sealant
If in doubt, give us a call on 01277 525 020 or email us and we will say what we think.
What we seal
- Hotel bathrooms and public areas
- Shop-fit joinery and counters
- Office fit-out finishes
- Natural stone and brick
- Cladding panels
- Powder-coated and anodised frames
Leave it or put it right?
Standard white or grey sealant is cheaper to stock, but it doesn’t always suit the finish. On visible work, the small extra effort of a colour from the product’s range pays off in how the finished space looks. Wet weather and frost are hard on failed joints in a Scottish town like Forres, so small failures grow. Resealing early keeps it a simple job.
The price depends on how many linear metres there are, what has to come out first and how the joints are reached. Call for a quote once you have the details.
Why clients in Forres choose us
- Fully insured
- RAL and finish matching where the product range allows
- Work to your specification and the manufacturer’s guidance
- Coloured sealants to suit the setting, where available
See our cost guide and how we’re accredited.