Commercial sealant contractors in OX33

Commercial sealant contractors across OX33: what to expect

A reseal stands or falls on the preparation underneath it. Silicone has no grip on cured silicone, so the failed bead is cut out completely, then both faces are cleaned back to sound, dry material with no dust or grease on them. Primer is used wherever the manufacturer calls for it on that surface, and a backing rod limits the depth to give the sealant room to work. We work on washrooms and tea points, kitchen worktops and splashbacks and floor and threshold joints, and what we’re called in for most is untidy joints in a reception, shop floor or lobby and weathered facade sealant that no longer flexes.

Where the site stays busy, we agree a sequence with your contact so the disruption stays in one area at once. Each section is protected, cleaned back and sealed, then handed back before the next one starts.

1. Site photos, drawings or a visit tell us what’s there and how it has failed.
2. A fixed quote follows, with removal and preparation included.
3. We agree the order of work, access windows and site hours with you.
4. The failed sealant comes out and the faces are prepared, with primer where required.
5. Backing goes in, the new sealant is laid and tooled, and the area is left neat.
6. Completed areas are signed off with you under our 12-month guarantee.

How we quote

What a job costs comes down to the quantity of joints, how much old material needs removing and the access. Call for a quote once you have the details.

Why appoint us

• 12-month guarantee on workmanship
• Colour options checked against the specified product
• RAL and finish matching where the product range allows
• Over 20 years of commercial sealing

Get a fixed quote

Every job follows the same four steps: send details, get a quote, we seal, guaranteed. To take the first step, call 01277 525 020 or send photos by email.

What’s near Wheatley

In Wheatley, that means premises near Church of St Mary, Wheatley Park School and 19 pub, among other places. Other landmarks nearby include Slade Hospital (2.8 miles west) and Templars Square (3.6 miles west). Open spaces near Wheatley include CS Lewis Nature Reserve and Shotover.

Quoting for work in OX33

We price every job individually. The things that drive the figure:

• Location, for remote and island sites
• The size and state of each joint
• Removal of failed or old sealant
• Any access equipment needed

The work involved drives the cost: stripping out, preparation, sealing, access and phasing. Call for a fixed quote.

Before you send an enquiry

For an accurate fixed quote, we need to understand the site. Send us:

• A wide shot and a close-up of the area
• The type of building and who uses it
• Drawings or a marked-up plan, if available
• Any dates the work must fit around

If there’s a specification, drawings or a tender package, send it with your enquiry, and we’ll price the work to it. For smaller jobs, photographs and a description will do.

Maintenance after handover

Cleaning and maintenance staff play a part too. Share these points with them:

• Look at the sealant around anything that has been moved or replaced
• Add sealant to the planned maintenance inspection list
• Brief cleaning contractors to avoid scourers and blades on sealant
• Keep a record of which joints were resealed and when

New joints need their full cure time before they take water, cleaning or traffic. That time depends on the product, the temperature and the joint depth, and we confirm it when each area is handed back. Leaving the area closed until then keeps the bead neat.

Sealant rarely fails all at once across a building. The first failures are often a warning about the rest. We’ll tell you which sealant joints need doing first and which can wait.