
Lychpit floor joint sealing
Looking for floor joint sealing in Lychpit? It’s simple: send details, get a quote, we seal, guaranteed.
- Untidy open joints in a retail unit
- Old filler gone hard, cracked or loose
- Broken arrises where pallet trucks cross
Floor joint sealing for businesses in Lychpit
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Looking after the joints
After handover, these steps help:
- Tell us about strong cleaning chemicals before we quote
- Put loading bays at the top of the list
- Keep photographs of joints that look like they’re failing
- Keep grit out of unfilled joints in the meantime
Walk the main truck routes every few months and look along the joint lines. Watch for filler pulling away from an edge, fresh chipping or grit collecting, and photograph anything that changes.
Every vehicle on a busy aisle hits a damaged joint. Sorting it early looks after your equipment as well as the slab.
Floor joint sealing in Lychpit
Across Lychpit and the rest of Hampshire, it runs the same way: you send details, we send a fixed quote, the joints are done and the 12-month guarantee follows. A rough length of joint, photos of the worst areas and a site plan let us give a quick quote and a visit can be arranged where that is easier. If you are dealing with sealant pulled out along a truck route and drivers complaining about joints on a route, we can help, on forklift and pallet-truck routes, retail and showroom floors and saw-cut induced joints alike. Sealant contractors, mastic applicators, sealant specialists: whatever the job title on the order, the work in Lychpit is the same: the right product in a properly prepared joint.
In and around smaller places like Lychpit, the concrete floors we see are often in converted farm buildings, small workshops and storage units. Joints in those slabs take vehicles, trolleys and foot traffic, and need a filler or sealant to match.
The 12-month guarantee is for workmanship rather than wear and tear. How long a sealant joint lasts depends on movement, exposure, cleaning and use, so we spell out the cover before we begin.

- Location
- Lychpit (RG24)
- Wider area
- Hampshire
- Cover
- 12 months on our workmanship
- Quotes
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Places near Lychpit
Also in Lychpit
When to call us in Lychpit
Joints near dock doors see colder air, rain blown in and water off vehicles, as well as the tightest turning loads. They are often the first on a site to break down.
Clients normally get in touch after noticing something like this:
- Filler that has parted from one face
- A rough ride across broken joints
- Brittle joint filler breaking up
- Flexible sealant torn out by wheels
If you manage units on an estate such as Daneshill East Industrial Estate, which lies west of Lychpit, the floor joints under forklifts and pallet trucks and the slab joints in the yard are the ones to watch.
Before you book anyone
- Their plan for phasing and protecting the area
- Is depth set with backing rod, or bond-breaker tape in shallow joints?
- The terms of the workmanship guarantee
- What site paperwork they can supply
Why act early in Lychpit
Holding off until the whole floor can close can take a long time. Phased in zones, the busiest routes can be treated first and the remainder follows on a plan that suits you. Halls, stores and units around places like Lychpit may not be checked every day, so a failed joint can leak for a while before anyone sees it. Renewing joints in good time avoids the problem.
The specified product makes a difference, and so does the preparation. Access, phasing and site rules also count.
Why us?
- CHAS accredited
- Sealing commercial buildings since 2005
- A Constructionline member, so easy to vet
- One number for every site we cover
Take a look at our cost guide and our accreditations.
What we can’t put right
Sealant solves a lot, but not everything, and we are upfront when that’s the case. It won’t fix:
- Structural cracking in the slab
- Worn screed or surface finishes
- Joint edges that have already broken away, which need repairing before filling (we’ll tell you if so)
If you are not sure, just ring 01277 525 020 or send details through our quote form and we will give you a straight answer.
Joints and surfaces we work on
- Forklift and pallet-truck routes
- Joints along racking aisles
- Retail and showroom floors
- Saw-cut induced joints
- Construction joints
- Loading bays
Traffic, movement and joints around Lychpit
Lychpit lies roughly 44 miles out from central London. Distribution warehouses and industrial estates are common around the motorway corridors that serve the capital; their floors carry heavy traffic every shift. Lychpit has at least three named business or industrial parks inside a 3-mile radius. Their warehouses, yards and car parks are exactly where joints take the most punishment.
At a retail site such as The Malls (1.5 miles west of Lychpit), trolleys, cages and cars run over floor and slab joints all day. In a school such as Old Basing Infant School, movement joints in brick, block and hall floors tend to be forgotten until they leak.
Lychpit is about 2 miles east of Basingstoke, in Hampshire. Businesses, contractors and managing agents in Lychpit use us for work on floor joints, as part of our coverage of Hampshire. We work across 723 places in Hampshire, from busy centres to rural villages. Sites around Reading have their own page, about 13 miles away.
Business premises anywhere in RG24 are within our area for floor joints. Among the streets we cover are Park Lane, Crown Lane and Manor Lane, and sites on any of them can send details for a fixed quote. Just outside Lychpit, we also work in Old Basing (1 mile east), Eastrop (1 mile west), Chineham (1 mile north), Oakridge (2 miles west) and Mapledurwell (2 miles east). Nearby towns on our patch include Farnborough (12 miles east), Fleet (9 miles east), Aldershot (13 miles east), Alton (9 miles south), Yateley (11 miles north-east) and Tadley (7 miles north-west).
Near you in Lychpit
We work on buildings around The Costello School, Eastrop Park and The Crown Public House, among other places. Lychpit’s nearest station is Basingstoke station, about 1.6 miles west. Well-known places in the area include Basingstoke and North Hampshire Hospital (2.6 miles west) and Basing House (less than half a mile south). For a walk, there’s Farleigh Hill and The Mill Field.
Our process
Diagnose, treat, sign off: that’s the shape of every visit. We inspect the joints and confirm what’s in scope, then the work is carried out to the specified product and detail, and the job ends with a walk round and sign-off. Rural sites near Lychpit may need directions, gate codes or a contact on site. Add it to your enquiry and we will build it into the plan.
- We agree the traffic routes and phasing with your site team.
- We point out joints whose edges need repairing first.
- We clear each run back to clean concrete.
- We fill the joints with the agreed product, finished level.
- You get a time for each zone to reopen.
What we need from you
- Point out parking and an unloading spot
- Tell us which areas need to stay in use
- Tell staff and tenants when we will be in
Getting a fixed quote
We quote a fixed sum against the scope you give us, so the cost is agreed before work starts. To start the process, give us a call on 01277 525 020 or email drawings and photos.
Read more
Doing it in-house
General builders and handymen seal joints, but it isn’t their main trade. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint, which is what makes a joint last.
For a quick touch-up, site staff may be fine, but anything bigger is another matter: a specialist works through quantities efficiently, leaves a consistent finish and backs it with a 12-month guarantee.
Common questions from Lychpit clients
Is Daneshill East Industrial Estate, near Lychpit, within your area?
Yes. We cover Lychpit and the area around it, including industrial estates, business parks and retail parks such as Daneshill East Industrial Estate. Send details of the unit and the work through our quote form for a quick quote.
Is hospital work, at somewhere like Basingstoke and North Hampshire Hospital, something you do?
Yes, healthcare and care buildings are part of our work. The estates team’s permit system and infection-control rules come first, and the work is planned around them.
Is it normal for joint filler to separate?
On newer slabs, the concrete keeps shrinking after the joints are filled, so a semi-rigid filler can part from one face. It is normally dealt with by topping up.
Does the weather affect the work?
It can, for external work. Wet joints and cold, damp or frosty conditions stop the sealant bonding properly, so we watch the forecast and rearrange outside work if we have to. Indoors, the weather is rarely a problem.
Can you phase floor joint work around operations?
We phase it. We work aisle by aisle or zone by zone so the rest of the floor stays in use. Tell us your site hours and access windows and we will plan around them.
Is it fine to apply new sealant on top of old?
No. Failed sealant is removed and the faces cleaned back to sound, dry material first, because fresh silicone will not bond with aged silicone.
What do you need from us to quote?
A rough joint length, a few photographs and a site plan let us give a quick quote. For larger floors, a site visit is often best, and you can speak to us on 01277 525 020 or email drawings and photos to arrange it.