Fire stopping in Latton
Fire-rated and intumescent sealing of service penetrations and linear gaps in Latton. CHAS accredited, Constructionline member, with a 12-month guarantee on workmanship.
- Service penetrations left open after M&E works
- Builders’ foam or ordinary silicone in compartment walls
- Unsealed penetrations discovered above suspended ceilings
Fire stopping across Latton
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Why it’s worth doing now in Latton
It is cheaper to seal service penetrations as each services package finishes than to come back for them later. While the area is still open, every opening is easy to see and reach, and the right detail can be checked at the time. Converted and older buildings near places like Latton tend to move, and aged sealant cracks. The right product, sized to the joint, copes much better.
The price depends on the quantity of joints, how much old material needs removing and the access. Call for a quote when you are ready.
Why choose Mastic Doctor in Latton
- A Constructionline member, so easy to vet
- Public liability insurance in place
- Commercial sealant work since 2005
- CHAS accredited
About our fire stopping in Latton
Where pipes, cables and other services cross a compartment wall or floor, the opening around them has to be closed so fire and smoke can’t move between compartments. Our job is fitting fire-rated and intumescent sealant at those service penetrations, and along linear gaps, where it is the specified product. We work to the product’s tested detail for every seal. If you have hidden openings found during inspections and fire-rated sealant that has cracked or shrunk back, we can put it right, on small duct penetrations where the tested detail allows, joints between fire-resisting walls and floors and linear gaps at wall heads alike. Searching for sealant specialists in Latton? Mastic Doctor has worked for contractors, FMs and building owners since 2005, CHAS accredited and a Constructionline member.
Smaller places such as Latton still have buildings with fire-resisting walls and floors: schools, halls, care homes and commercial conversions. Any service penetration through those walls should be closed with the specified product, set out as its test evidence shows.
Every job we finish is backed by a 12-month workmanship guarantee. If a joint we sealed fails because of how it was installed, we come back and put it right.
- Place
- Latton (CM17, CM18, CM20)
- Region
- Essex
- Guarantee
- A 12-month guarantee
- Price
- Quoted before any work starts
- Phone
- 01277 525 020
- Updated
- 3 November 2026
Fire stopping in Latton: the local picture
Harlow, one of the planned towns of the twentieth century, takes in or adjoins Latton. Older buildings in planned towns have often been re-serviced several times, so penetrations left behind should be sealed with the specified product. There are several hotels within about 2 miles of Latton. A hotel refit often runs new services through compartment walls between bedrooms and corridors, and each opening needs the specified seal.
Hotels like Park Inn Hotel, 0.6 miles to the south of Latton, are refurbished in phases, and each phase can open up compartment walls. Older community buildings such as Church of St Andrew that have been rewired or given new heating can have service gaps through walls worth checking against the specification.
Latton is about 1 mile south-east of Harlow, in Essex. Across the CM17 postcode area, the process is the same: send details, get a fixed quote, we seal, and the work is guaranteed. Latton is one of 644 places in Essex on our list for service penetrations. London is covered too, around 21 miles from Latton.
Work on service penetrations is covered throughout CM17, CM18 and CM20, whatever the building. We cover commercial and managed buildings on London Road, Minton Lane and Tumbler Road and the roads nearby. You’ll find Latton on or near the A414, so getting applicators and materials to site is simple. We also cover Harlow (1 mile north-west), Mark Hall South (1 mile north-west), Newhall (1 mile north-east), Bush Fair (1 mile south-west) and Netteswell (1 mile north-west). Nearby towns on our patch include Brentwood (12 miles south-east), Loughton (8 miles south), Waltham Abbey (7 miles south-west), Great Dunmow (13 miles north-east), Epping (5 miles south) and Stansted Mountfitchet (10 miles north).
Around Latton
Recent enquiries here include premises near Passmores Academy, Harlow Marsh and Purple Emperor pub and the streets around them. For rail, the closest station is Harlow Town station, roughly 1.7 miles north-west. Well-known places in the area include Princess Alexandra Hospital (1.7 miles west) and Mark Hall Cycle Museum (0.9 miles north). Green spaces nearby include Hunsdon Mead.
On site: what to expect
A typical day starts with protection: tape along each joint edge and covers over finishes, stock and equipment close by. On site, the work typically takes longer where risers, ceiling voids or occupied floors have to be worked through in sequence, and our waste is bagged and taken away as we go. Rural sites near Latton may need directions, gate codes or a contact on site. Send that with the details and we will confirm the plan with the quote.
- We start with your penetration schedule, drawings or specification.
- We plan the sequence of floors, risers and voids with you.
- We compare every service penetration with its tested detail before sealing.
- Unsuitable material is removed and the opening cleaned.
- The specified backing and sealant go in to depth and are finished neatly.
- Anything outside the detail is reported to you rather than sealed.
Preparing the site
- Have the specification and drawings to hand
- Explain the parking and delivery arrangements
- Tell us which areas need to stay in use
Ask for a quote
If there’s a specification, drawings or a tender package, send it with your enquiry, and we’ll price against exactly what is specified. For smaller jobs, photos and a description will do.
Related advice
FAQs: Latton
What happens to BS 476 references for fire stopping in Latton?
Approved Document B loses its BS 476 references from 2 September 2029, and BS EN 13501-2 becomes the route, subject to transitional arrangements. Our part doesn’t change: the specified product, to its tested detail.
Can you seal penetrations in a hotel in Latton after a refit?
Yes, where the specification calls for fire-rated sealant. We match the product to the wall or floor and the services, and say if something other than sealant is needed.
Does the weather affect the work?
It can, for external work. Sealant won’t bond properly to a wet or frosty joint, so we watch the forecast and rearrange outside work if we have to. Internal work is far less affected.
Can you follow the specification on our project?
Yes. We follow the specification, along with the manufacturer’s installation guidance, and any queries are raised before we start.
What hours do you work?
Give us your site hours and any access windows in your enquiry, and we will schedule the work to suit. Our office runs Monday to Friday, 8am until 5pm.
Can you handle several sites?
Yes. A group of buildings can go on one quote, with one point of contact.
Are your applicators CSCS-carded?
Yes. Should the site need card details in advance, let us know and we will send them with the quote.
Nearby places to Latton
What else we do in Latton
When something else is needed
We seal joints; we don’t mend everything behind them. Sealant alone won’t deal with:
- Reviewing a building’s overall fire safety
- Plastic pipes whose detail calls for a collar or wrap
- Writing the fire-stopping specification
If you’re not sure, just give us a call on 01277 525 020 or email us and we will give you a straight answer before you book.
Surfaces we seal
- Linear gaps at wall heads
- Joints between fire-resisting walls and floors
- Service gaps in risers
- Small duct penetrations where the tested detail allows
- Pipe penetrations
- Cable penetrations
For managing agents and facilities managers
Main contractors use us as their sealant subcontractor on new-build and refurbishment projects. We work to your programme, your specification and your site rules, with CSCS-carded applicators on site.
Facilities managers want contractors who arrive with the paperwork sorted. Tell us what site paperwork you need, such as RAMS, an insurance certificate or CSCS details, and we’ll confirm with the quote.
Should maintenance staff do it?
The visible bead is only part of the job. Backing rod, primer where specified and a joint designed to move with the building are easy to get wrong without experience.
Paperwork matters too. Main contractors and clients often ask for CSCS cards, RAMS and insurance details, and we’ll confirm the paperwork you need with the quote.
Do you need fire stopping in Latton?
Some seals fail because the wrong product went in: expanding foam or a general-purpose sealant pushed into a gap to tidy it. It may look closed, but it has no tested fire performance in that position and has to be removed.
If one of these sounds familiar, it’s time for a closer look:
- Service penetrations left open after M&E works
- Fire-stopping items raised at inspection or handover
- Fire stopping installed outside its tested range
- Head-of-wall gaps with no fire seal
Hospital estates such as Princess Alexandra Hospital, 1.7 miles to the west of Latton, are divided into fire compartments, and any service penetration through them should be sealed to the specified, tested detail.
Comparing quotes
- How the joint faces will be prepared and primed
- Their pre-qualification and accreditations
- Is depth set with backing rod, or bond-breaker tape in shallow joints?
- Can the work be phased to keep areas open?