Fire stopping in Hillhouse
Work needed on a service penetration in Hillhouse? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Head-of-wall gaps with no fire seal
- Fire stopping installed outside its tested range
- Seals disturbed by maintenance and left open
Fire stopping for Hillhouse sites
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
FAQs: Hillhouse
Is Hillhouse too far out for you?
Not at all. Hillhouse is within our area. We cover the whole of Scotland. Send photographs and a list of what needs doing, and we will plan the job to need as few trips as possible.
Will you work in a care home in Hillhouse without moving residents out?
Yes, with the manager deciding the order and timing of rooms. Any site rules, from signing in to infection control, are agreed before we start.
Do the same rules apply to fire stopping in Scotland?
Scotland sets its own building regulations, with Technical Handbooks, while England relies on Approved Document B. Either way, we install the specified sealant to its tested detail.
Are you members of a third-party fire-stopping installer scheme?
No. We are not members of a third-party fire-stopping installer scheme. Our credentials are CHAS accreditation, Constructionline membership and CSCS-carded applicators, and we are fully insured. If your contract requires third-party installer certification, we are not the right fit for that package.
How do you choose the sealant?
If the job is specified, we follow the specification. Otherwise, we recommend a product to suit the joint’s movement, the substrate and the conditions, following the manufacturer’s guidance.
Will you just go over the old sealant?
No. We cut the old material out and clean the joint back before sealing, since fresh sealant will not bond reliably to aged material.
What does an EI 60 rating mean?
In short, BS EN 1366-3 and 1366-4 are the fire tests and BS EN 13501-2 is how results are classified. An EI 60 seal kept its integrity and insulation for 60 minutes as tested.
How we handle fire stopping in Hillhouse
Sealant is the specified answer for plenty of openings, such as metal pipes, cables and some small ducts where the detail covers them. Other openings need collars, wraps, batts, pillows or boards. If the detail calls for something other than sealant, we say so rather than force sealant into it. If you have head-of-wall gaps with no fire seal and unsealed openings around new pipes and cables, we can help, whatever the surface. A single leaking joint is often how a building in Hillhouse first comes to us: we look at the rest while we’re there and tell you what we find.
Hotels and care homes around smaller places like Hillhouse often have services added during refurbishment. We fit the specified fire-rated sealant as its published detail shows and raise it if another product is needed.
We sign every job off with a 12-month guarantee. It’s a plain promise: if the work we did fails within twelve months, we return to fix it.
- Where
- Hillhouse (ML3, G72)
- Region
- South Lanarkshire
- Cover
- A 12-month guarantee
- Price
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Leave it or put it right?
It is cheaper to seal service penetrations as each services package finishes than to come back for them later. Openings are visible, access is open and nothing has to be taken down. Renewing every failing joint on one visit is the sensible approach for a place like Hillhouse. Send photos and we’ll quote for everything together.
Every site prices differently: the joint sizes, the specified product, access and working hours each have a bearing. Send the details and a fixed figure follows.
What you get with us
- One contact handling all your sites
- Our applicators hold CSCS cards
- Health and safety: CHAS accredited
- Workmanship guaranteed for 12 months
See how commercial sealant jobs are priced and our accreditations.
When it isn’t the sealant
Our job is the joint, not everything around it. Sealant alone won’t deal with:
- Walls or floors that aren’t fire-resisting to begin with
- Deciding what a wall or floor needs, which belongs to the designer
- Openings that need collars, wraps, batts or boards rather than sealant
If in doubt, give us a call on 01277 525 020 or email us and we will say what we think before you book.
Joints and surfaces we work on
- Small duct penetrations where the tested detail allows
- Service gaps in risers
- Cable penetrations
- Joints between fire-resisting walls and floors
- Pipe penetrations
- Linear gaps at wall heads
On site: what to expect
Tell us your site hours and access windows and we will plan around them. On the day, the work area is kept contained and tidy, and your contact hears from us before we move to the next area. For a building near Hillhouse, directions, keys and a contact on the day are worth sorting early. That goes into the plan alongside the quote.
- We start with your penetration schedule, drawings or specification.
- We plan the sequence of floors, risers and voids with you.
- We compare every service penetration with its tested detail before sealing.
- Unsuitable material is removed and the opening cleaned.
- Backing and fire-rated sealant are installed to the detail and tooled.
- We tell you about openings that need a different product.
Getting the site ready
- Let us know about inductions and permits
- Send any specification or drawings in advance
- Move anything stored against the joints
Request a quote
Photos, drawings or a schedule of the joints and a fixed quote comes back to you. If the job needs a look first, we will arrange a site visit.
Read more
When to call us in Hillhouse
Some seals fail because the wrong product went in: builders’ foam or ordinary silicone used to fill a hole. It may look closed, but it has no tested fire performance in that position, so it has to come out.
Look out for the following:
- Improvised or mixed-product fire seals
- Fire-stopping items raised at inspection or handover
- Openings left by services added after handover
- Unsealed penetrations discovered above suspended ceilings
On a hospital site such as Udston Hospital, less than half a mile to the north-east of Hillhouse, fire-rated sealant goes in where the specification calls for it, with the work planned around the estates team’s permits.
Questions to ask before you book
- The named product and why it was chosen
- How they handle RAMS and site documents
- How long is the guarantee, and what does it include?
- Their approach to joint depth and backing
When to bring in a specialist
There’s also the paperwork. Main contractors and clients often ask for CSCS cards, RAMS and insurance details, and our CSCS-carded applicators are used to working under those rules.
General builders and handymen seal joints, but it isn’t their main trade. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint, which is what makes a joint last.
Penetration seals near Hillhouse
Two care or nursing homes sit less than 2 miles from Hillhouse. In a care home, any new pipe or cable through a fire-resisting wall should be sealed to the specified detail. We install fire-rated sealant to the tested detail where it is specified. A 2-mile radius around Hillhouse takes in a number of hotels. Hotels are divided into compartments, and refurbishments that add pipes and cables through bedroom and corridor walls leave gaps to close.
In a hotel such as The Villa Hotel, 1.2 miles to the east of Hillhouse, new pipework or cabling through bedroom and corridor walls needs sealing with the specified product. Holiday works at schools like John Ogilvie High School often leave service openings to seal before pupils return.
Hillhouse is about 1 mile west of Hamilton, in South Lanarkshire. Any commercial site in Hillhouse is covered, whether it’s a single job or part of a planned programme. Hillhouse is one of 134 places we cover in South Lanarkshire for service penetrations. Sites around Glasgow have their own page, roughly 9 miles from Hillhouse.
Anyone looking for fire stopping in ML3 and G72 gets the same process as the rest of our area: details, then a fixed price, then sealing and a 12-month guarantee. Streets here include Elie Road, Farm Road and Largo Lane, and sites on any of them can send details for a fixed quote. Close to Hillhouse, our area also takes in Auchinraith (1 mile north), High Earnock (1 mile south), Burnbank (1 mile north-east), Laighstonehall (1 mile south-east) and Hamilton (1 mile east). Further afield, our area takes in East Kilbride (4 miles west), Cambuslang (4 miles north-west), Uddingston (4 miles north), Larkhall (5 miles south-east), Carluke (10 miles east) and Rutherglen (6 miles north-west).
What’s near Hillhouse
Locally, jobs take us to sites close to Iona Ridge Park, among other places. The nearest railway station is Hamilton West station, about 1.3 miles east. A little further out are David Livingstone Centre (2 miles north) and Calderwood Castle (1.8 miles west). Not far away are Cathkin Braes and Strathclyde Loch.
How the job changes by surface
Cables and cable bundles
Cable penetrations are frequently sealed with fire-rated sealant where the detail allows. Bundle size, cable type and the space between cables all matter and we work within those limits.
Drylining partitions
Drylined fire walls are tested in a particular build-up. We check that the product’s detail covers that partition type and board thickness.