Fire-rated sealing and fire stopping in Elsenham, Essex
Fire-rated and intumescent sealing of service penetrations and linear gaps throughout Elsenham and nearby, carried out by CSCS-carded applicators. CHAS accredited and fully insured.
- Fire-stopping items raised at inspection or handover
- Fire sealant pulled out of the opening
- Openings found when ceilings come down for a refit
Fire stopping near Elsenham
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Fire stopping for commercial buildings in Elsenham
Where pipes, cables and other services cross a compartment wall or floor, the opening around them has to be closed so fire and smoke can’t move between compartments. Our part is installing fire-rated and intumescent sealant at those openings and along linear gaps, where the specification calls for it. Each seal follows the manufacturer’s tested detail, not a rule of thumb. We work on service gaps in risers, pipe penetrations and small duct penetrations where the tested detail allows, and the usual reasons a site gets in touch are fire sealant pulled out of the opening and damaged fire seals in risers and voids. Searching for sealant specialists in Elsenham? We have been sealing commercial buildings since 2005, with CSCS-carded applicators.
Buildings in a smaller place such as Elsenham that need fire-rated sealing are typically schools, care homes, surgeries, small offices and flats over shops. Specified fire-rated sealant goes around new services there, built to match the manufacturer’s detail.
We stand behind the joints we seal with a 12-month guarantee. That covers our preparation and application, and if something we did falls short, we return to it.
- Where
- Elsenham (CM22)
- Wider area
- Essex
- Guarantee
- A 12-month guarantee
- Quote
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
What we can’t put right
Before quoting, we check that sealant is the right answer. It isn’t the answer for:
- Approving the work on behalf of building control
- Reviewing a building’s overall fire safety
- Large openings beyond what any sealant detail covers
If in doubt, give us a call on 01277 525 020 or send details through our quote form and we’ll say what we think.
Where we work in Elsenham
- Linear gaps at wall heads
- Pipe penetrations
- Small duct penetrations where the tested detail allows
- Cable penetrations
- Service gaps in risers
- Joints between fire-resisting walls and floors
Your questions answered
Can you work around term dates at a campus such as Arthur Findlay College?
Yes, holiday working periods are the norm on campus jobs. Let us know which documents your site asks for, and we’ll confirm them alongside the quote.
Is Elsenham too far out for you?
No. Places such as Elsenham are covered as much as the big towns. Our area covers London and the South East counties. Good photos up front let us bring everything on the first visit.
What about RAMS and site documents?
Requirements differ from site to site, so list what you need, whether RAMS, insurance or CSCS details, and we’ll confirm with the quote.
Can you fire stop behind the services contractors?
Yes. Share the penetration schedule and product details for a fixed quote. We can follow the services contractor floor by floor keeping pace with the programme.
Do you hold third-party fire-stopping installer certification?
No. We don’t hold a third-party fire-stopping installer certificate. Our credentials are CHAS accreditation, Constructionline membership and CSCS-carded applicators, and we are fully insured. Where a client or main contractor requires a scheme member, we will say so right away rather than waste your time.
How long will the new sealant last?
There isn’t a single answer, because life depends on how much the joint moves, how exposed it is and how it’s cleaned and used. Regular checks let you plan resealing before leaks or damage.
How long does a typical visit take?
The duration is planned around your programme and the access we’re given. You will have an expected duration with the quote.
General trades versus a specialist
There’s also the paperwork. Main contractors and clients often ask for CSCS cards, RAMS and insurance details, and our CSCS-carded applicators are used to working under those rules.
Redoing a failed joint usually costs more than getting it right at the outset, because the whole bead must be removed and the faces cleaned back again. That’s why many clients bring in a specialist from the beginning.
Compartments and services around Elsenham
There are several hotels within about 2 miles of Elsenham. In hotels, bedroom and corridor walls are usually fire-resisting, so services added in a refit need sealing with the specified product. For England, the fire stopping of penetrations is dealt with in Approved Document B. The national BS 476 classes are due to drop out of it from 2 September 2029, leaving the European BS EN 13501-2 route, subject to transitional arrangements. What we install is set by the specification, and it goes in to the tested detail.
In a building such as Church of St Mary the Virgin, any service penetration through a fire-resisting wall should be sealed to the specified detail. At a college such as Arthur Findlay College, which lies south-west of Elsenham, checking penetration seals after summer M&E works is good practice. Wherever services are added at a hospital such as Herts and Essex Hospital (to the south-west of Elsenham) the compartment line has to be made good with the specified product.
Elsenham is about 4 miles north-east of Bishop's Stortford, in Essex. Commercial clients in Elsenham can call on us for service penetrations. We work across 644 places in Essex, from busy centres to rural villages. London is covered too, around 32 miles from Elsenham.
Business premises anywhere in CM22 are within our area for service penetrations. For a building on Station Road, High Street and Isabel Drive or nearby, we can quote for service penetrations. Nearby places we also cover include Fuller's End (1 mile south-east), Ugley Green (1 mile north-west), Henham (2 miles north-east), Ugley (2 miles north-west) and Brick End (3 miles east). A short drive away, we cover Braintree (14 miles east), Harlow (11 miles south-west), Saffron Walden (7 miles north), Great Dunmow (6 miles south-east), Great Notley (13 miles east) and Bocking (14 miles east).
Around Elsenham
We work on buildings around Robin Hood Public House, among other places. There’s a railway station in Elsenham itself: Elsenham station. A little further out are House On The Hill Toy Museum (1.3 miles south-west) and Little Easton Moat (4.8 miles south-east). Green spaces nearby include Aubrey Buxton Nature Reserve and Portingbury Hills.
Maintenance after handover
After handover, a little attention goes a long way:
- Treat an open penetration as a priority repair
- Agree the fire-stopping specification before services go in
- Arrange inspection before areas are covered up
- Leave fire sealant to cure fully before covering it
Allow the manufacturer’s stated cure time before boxing in or decorating. Not every fire-rated product can be painted.
Keep a register of where seals are and what they are made of. When a new service goes through, everyone knows which product and detail to match.
What affects the price in Elsenham
Before we quote, we look at:
- The site’s rules and procedures
- Whether old sealant has to be cut out first
- Distance, for remote addresses
- Which sealant the job calls for
A quote for service penetrations depends on quantities, condition and access. Call for a quote.
Details that help us quote
However big the job, the same details help:
- What the building is and how it’s used
- Rough lengths or quantities, or drawings if you have them
- Any dates the work must fit around
- The site address and postcode
Quotes are fixed against the scope you send, so the cost is agreed before work starts. To ask for one, give us a call on 01277 525 020 or email us.
On site: what to expect
In a busy building, the work is phased so only one area is out of use at a time. Each section is protected, cleaned back and sealed before we move to the next. For a job in Elsenham, the main thing is a clear picture of the work. You will then get a fixed price for the work.
- First we go through the drawings, schedule or specification for the seals and ask about anything unclear.
- On site, each opening is checked against the tested detail it is meant to follow.
- Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
- Mineral wool or other backing goes in wherever the detail asks.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- If an opening needs something other than sealant, we tell you instead of improvising.
Before we start on site
- Arrange parking or a loading space
- For older buildings, check the asbestos register before work
- Point out any areas we must not close
Get a fixed quote
Specifications, drawings and tender packages are welcome with any enquiry, and we’ll price against exactly what is specified. Smaller jobs need nothing more than photographs and a few notes.
Read more
How the job changes by surface
Risers and ceiling voids
Openings above suspended ceilings are easy to miss. We work through the areas on your schedule methodically and tell you about openings outside the list.
Plastic pipes
Plastic waste pipes through slabs come up often. Whether sealant alone is acceptable depends entirely on the tested detail, and we’ll never swap a specified collar for sealant.