The Mastic Doctor team standing beside their branded vans outside an office building
Surrey · England

Fire Stopping in Camberley

Fire stopping for Camberley, from a contractor working since 2005. Fully insured and CHAS accredited.

  • Head-of-wall gaps with no fire seal
  • Openings found when ceilings come down for a refit
  • Unsealed openings around new pipes and cables
1
Send details
Drawings, photos, a joint schedule or a site visit.
2
Get a quote
A fixed quote for the work, with the scope in writing.
3
We seal
Prepared joints, the specified product, a tidy finish.
4
Guaranteed
Signed off, with 12 months’ guarantee.
London, the South East & Scotland
CHAS accredited
Fully insured: £5m PL

Fire stopping across Camberley

Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.

Where services cross fire walls in Camberley

There are two care or nursing homes within about 2 miles of Camberley. Where new services have gone through compartment walls in a care setting, the gaps need the specified product. We install fire-rated sealant to the tested detail where it is specified. Camberley has several hotels close by, all within 2 miles. A hotel refit often runs new services through compartment walls between bedrooms and corridors, and each opening needs the specified seal.

For a hospital such as Frimley Park Hospital, 1.1 miles south-west of Camberley, penetration sealing is typically phased ward by ward, with infection-control rules agreed first. At a college such as The Sixth Form College Farnborough, 2.2 miles to the south-west of Camberley, checking penetration seals after summer M&E works is good practice.

Camberley is about 9 miles north-west of Guildford, in Surrey. Businesses, contractors and managing agents in Camberley use us for work on service penetrations, as part of our coverage of Surrey. We work across 379 places in Surrey, from busy centres to rural villages. There’s a separate page for Reading, about 13 miles away.

We cover the GU15, GU16 and GU47 postcode districts. Streets here include High Street, London Road and Waverley Drive, and sites on any of them can send details for a fixed quote. You’ll find Camberley on or near the A30 and A321, so getting applicators and materials to site is simple. If your building is just outside Camberley, we cover Old Dean (1 mile north-east), York Town (1 mile west), Frimley (1 mile south), Watchmoor (2 miles south-west) and Deepcut (2 miles south-east). A short drive away, we cover Guildford (9 miles south-east), Woking (7 miles east), Farnham (9 miles south), Egham (10 miles north-east), Walton-on-Thames (14 miles east) and Staines-upon-Thames (12 miles north-east). Camberley is one of the busier places in Surrey, and its commercial and public buildings are all within our area.

What’s near Camberley

Around Camberley, our work takes us to commercial buildings near Royal Military Academy Library, Tekels Park and Tomlinscote School and the streets around them. Nearby too are The Claude du Vall pub (0.7 miles west) and Tomlinscote School (1 mile south). The nearest railway station is Camberley station, roughly 0.7 miles west of the centre. Nearby you will also find Frimley Park Hospital (1.2 miles south-west) and Surrey Heath Museum (0.7 miles north-west). The countryside around Camberley includes Wildmoor Heath and Horseshoe Lake.

Map of Camberley © OpenStreetMap contributors

Fire stopping in Camberley

A lot of fire-stopping work comes after M&E installation, a refit or a tenant fit-out. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind. Those on your schedule are closed with the specified product. We work on cable penetrations, linear gaps at wall heads and service gaps in risers, and the failures we’re asked to look at most are fire-stopping items raised at inspection or handover and unsealed joints where partitions meet the slab. Whoever orders the work in Camberley, the brief is normally the same: a clear scope, tidy work and joints that don’t fail again.

Many town-centre buildings in places like Camberley have had layer upon layer of new services, with gaps around pipes and cables left after each change. Intumescent or fire-rated sealant is used wherever the specification asks for it, built up exactly as tested.

We stand by our work: 12 months, guaranteed. It covers how we prepared and applied the sealant, and if something we did falls short, we return to it.

Where
Camberley (GU15, GU16, GU47)
Wider area
Surrey
Cover
A 12-month guarantee
Price
Fixed quote, scope in writing
Telephone
01277 525 020
Page updated
3 November 2026
The Mastic Doctor team standing beside their branded vans outside an office building

General trades versus a specialist

Site maintenance staff can often handle a short internal joint. The usual problems come from preparation: new sealant over old, damp or dusty faces, or the wrong product for the movement.

Redoing a failed joint typically costs more than getting it right at the outset, because the whole bead must be removed and the faces cleaned back again. That’s why many clients bring in a specialist from the beginning.

Surface by surface

Risers and ceiling voids

Voids hide a lot of unsealed openings. We follow your schedule area by area and tell you about openings outside the list.

Small ducts

Small ductwork can sometimes be sealed with sealant where the tested detail includes it. Larger or fire-rated ductwork usually needs a different solution set by the designer.

Camberley: questions and answers

Do you take on work at healthcare sites like Frimley Park Hospital?

Yes. Healthcare sites are among the places we work. The estates team’s permit system and infection-control rules come first, and the work is planned around them.

What does the BS 476 change mean for fire-rated sealant in Camberley?

References to BS 476 classes are being removed from Approved Document B from 2 September 2029, after which BS EN 13501-2 classification is the route, subject to transitional arrangements. The designer or fire engineer sets the specification, and we install the product to the manufacturer’s tested detail.

Can the sealant be colour-matched?

In many cases, yes. Many products come in a range of standard colours, and matching to RAL references or surrounding finishes is often possible. We’ll confirm the colours available for the specified product.

Are you CHAS accredited?

Yes. We’re CHAS accredited, we’re a Constructionline member and we use CSCS-carded applicators.

Can you follow the specification on our project?

Yes. We follow the specification, along with the manufacturer’s installation guidance.

What happens if old sealant might contain asbestos?

Managing asbestos is the dutyholder’s responsibility, so we’ll ask for the register before work on an older building. Work pauses if suspect material is found, until it has been tested.

What do you charge?

There isn’t a price list, because every site is different. With photos or drawings, we can give you a fixed quote.

From enquiry to sign-off

Diagnose, treat, sign off: that’s the shape of every visit. We inspect the joints and confirm what’s in scope, then we prepare and seal each joint with the specified product, and the job ends with a walk round and sign-off. Parking and loading for town-centre jobs in Camberley are worth mentioning when you send details. On estates and business parks it’s usually simpler.

  1. First we go through the drawings, schedule or specification for the seals and raise any questions before we price.
  2. Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
  3. Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
  4. We fit the backing the detail asks for, to the stated depth.
  5. Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
  6. Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.

Preparing the site

  • Make sure the joints can be reached
  • Tell us which areas need to stay in use
  • Explain the parking and delivery arrangements

Ask for a quote

Every job follows the same four steps: send details, get a quote, we seal, guaranteed. The first step is to call 01277 525 020 or send photos by email with what you know.

Get a quick quote

Read more

Why it’s worth doing now in Camberley

An open or wrongly sealed service penetration lets fire and smoke reach the next compartment much sooner than the building was designed for. Putting it right is usually a modest job when the openings are accessible. Wait until ceilings close or areas are occupied and the same work becomes harder to reach. For businesses and landlords in Camberley, a tidy, sound joint also matters for appearance. Fresh sealant makes a building look maintained.

Every site prices differently: joint size, product, access and site hours all play a part. Send the details and a fixed figure follows.

Why choose Mastic Doctor in Camberley

  • One phone line for London, the South East and Scotland
  • Sealing commercial buildings since 2005
  • Specification-led, product-correct work
  • Clear, fixed quotes

Take a look at our cost guide or our accreditations and insurance.

For managing agents and facilities managers

When you manage a building on behalf of an owner, you need clear quotes and clear reporting. You get a fixed quote, an agreed scope and a walk round at the end.

Agents, factors and owners’ representatives all follow the same route: send the details, accept a fixed quote, and we carry out and guarantee the work. Keys, access and contacts can be agreed in advance.

Signs you need fire stopping in Camberley

Some service penetrations were never sealed at all because they sat out of sight above a ceiling or inside a riser. They come to light during inspections, refits or when another trade lifts a tile.

Things that normally lead to an enquiry:

  • Non-fire-rated filler around services
  • Fire sealant pulled out of the opening
  • Unsealed joints where partitions meet the slab
  • Fire-stopping items raised at inspection or handover

Where a unit on an estate such as St. Georges Industrial Estate (1.3 miles south-west of Camberley), has fire-resisting walls between offices and warehouse, any new service through them should be sealed to the tested detail.

Questions to ask before you book

  • Do they follow the manufacturer’s priming guidance?
  • Who will actually carry out the work
  • Health and safety accreditation such as CHAS
  • The named product and why it was chosen

Choosing a commercial sealant contractor

Accreditations

Trusted. Accredited. Insured.