Expansion and movement joint sealing in Peel, Scottish Borders
Work needed on a movement joint in Peel? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Previous reseals laid over old sealant
- Sealant peeling off one face of the joint
- Car park joints leaking onto vehicles below
Expansion joint sealing for businesses in Peel
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Expansion joint sealing in Peel
For movement joints in Peel, photographs and approximate lengths are the best start. We’ll come and look where photographs don’t show enough, then send a fixed quote that names the sealant. To discuss the joints first, call 01277 525 020 or use the quote form. We work on brickwork movement joints, podiums and floor movement joints and cladding panel joints, and the usual reasons a site gets in touch are spalled or broken joint edges in floors and decks and weathered movement joint sealant that no longer flexes. Looking for mastic applicators who cover Peel? Mastic Doctor has worked for contractors, FMs and building owners since 2005, CHAS accredited and a Constructionline member.
For floor or movement joints around smaller places like Peel, we plan to finish in one visit where we can. Send photographs, joint widths and details of the traffic first.
Building owners and contractors get the same cover: a 12-month guarantee on our workmanship. It doesn’t extend to damage, faults in the building or work by others, and we’re upfront about that.
- Where
- Peel (TD1)
- Wider area
- Scottish Borders
- Guarantee
- A 12-month guarantee
- Quote
- A fixed quote before we start
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
What we can’t put right
Part of a good diagnosis is knowing where sealant stops. We’ll tell you if the real problem is any of the following:
- Damaged metal nosings or cover plates over a joint
- Joints too narrow for the movement, which need redesigning by the engineer
- Waterproofing layers buried beneath the sealant
Not sure which it is? You can ring 01277 525 020 or send details through our quote form and we’ll tell you honestly.
Surfaces we seal
- Blockwork control joints
- Podiums and floor movement joints
- Precast concrete panel joints
- Car park decks and ramps
- Brickwork movement joints
- Cladding panel joints
For managing agents and facilities managers
Planned maintenance programmes are welcome: working through a building or an estate in stages that fit your budget. Peel can form part of a wider programme.
For main contractors, we work as the sealant subcontractor. We work to your programme, your specification and your site rules.
Towns and villages near Peel
What else we do in Peel
Joints that move: notes for Peel
Peel is on Scotland’s drier eastern side. Frost and winter road salt still work into open joints in car parks and yards. Sealing them before winter limits the damage.
Around Peel, each joint gets a filler or sealant matched to what crosses it and how much it moves. Campuses like Heriot-Watt University - Scottish Borders Campus, 4.5 miles east of Peel, mix old and new buildings, with movement joints wherever they meet.
Peel is about 4 miles west of Galashiels, in the Scottish Borders. We send applicators to Peel for movement joints. Our the Scottish Borders coverage takes in 91 places. For work in that direction, see our Edinburgh page.
Anyone looking for expansion joint sealing in TD1 gets the same process as the rest of our area: send details, get a quote, we seal, guaranteed. Close to Peel, our area also takes in Ashiestiel (1 mile north-west), Caddonfoot (1 mile east), Clovenfords (1 mile north-east), Broadmeadows (3 miles south-west) and Yarrowford (3 miles south-west). A short drive away, we cover Hawick (13 miles south), Peebles (12 miles west), Selkirk (5 miles south-east), Wilton (13 miles south), Innerleithen (6 miles west) and Melrose (7 miles east).
What’s near Peel
The closest station to Peel is Galashiels station, about 3.8 miles east of the centre. Nearby you will also find Old Gala House (3.6 miles east) and Peel Hill (4.8 miles south-east). Open spaces near Peel include Haining Loch and Ashiesteel Hill.
Looking after the joints
To get the most from the new sealant:
- Reopen bays and walkways only after the stated cure time
- Inspect exposed joints once the cold weather has passed
- Include every elevation and deck joint in periodic inspections
- Avoid parking heavy plant or pallets on joint lines
In warehouses, forklift and pallet-truck routes take the most wear. Avoid standing heavy loads or racking legs on the joints.
When one joint fails, others of the same age are rarely far behind. It pays to check every joint, not just the obvious one, so the work can be planned rather than rushed. We can suggest an order, worst joints first.
What sets the cost
Each job is priced on its own details. The main factors are:
- Access and working height
- Location, for remote and island sites
- Phasing around occupants
- Which sealant the job calls for
The specified product makes a difference, as does the preparation each joint needs, such as cutting out, priming or new backing rod. Access, phasing and site requirements come into it too.
What to include in your enquiry
There’s no need for a formal survey. These details are enough to start:
- Rough lengths or quantities, or drawings if you have them
- The asbestos register, for older buildings
- What the building is and how it’s used
- Photos of the joints, close up and from further back
We quote a fixed sum against the scope you give us, so you know the figure before anyone is on site. To ask for one, give us a call on 01277 525 020 or email a schedule or drawings.
From enquiry to sign-off
Occupied buildings need a little choreography. The work area is signed and kept contained, keep walkways clear and move on in phases so staff and visitors can carry on around us. For work around Peel, we aim for one trip, so photographs, sizes and a full list matter. External joints need a dry spell as well.
- We assess the joints on site or from photos, noting widths and how each has failed.
- You receive a fixed quote stating the product and the movement it is rated for.
- Phasing is agreed so decks, floors or entrances can stay in use where needed.
- We strip the old sealant or filler and prepare each face until it’s sound and dry.
- Depth is controlled with backing, the faces are primed where the maker calls for it, then the bead is laid and tooled.
- Finished joints are inspected, the cure time confirmed and the 12-month guarantee applies.
What we need from you
- Make sure the joints can be reached
- Confirm the product named in the specification
- Warn occupants and staff about the work
Get a fixed quote
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. To take the first step, call the office on 01277 525 020 or send photos by email.
Advice
Site staff or a sealant specialist?
Certain joints really need a specialist: for instance fire-rated seals that must match a tested detail, trafficked floor joints and external movement joints. Getting these wrong typically costs more in the end than doing them right.
Paperwork matters too. Main contractors and clients often ask for CSCS cards, RAMS and insurance details, and we will confirm the paperwork you need with the quote.
Questions about Peel
Does a site in Peel have to shut while its joints are sealed?
In the majority of cases the site keeps working. Joints are done in phases, a bay, aisle or deck at a time. We agree the sequence and timings with you before we start.
Is Peel too small for you to travel to?
No. Small places get the same service as large ones. Our area covers all of Scotland, cities, towns and islands alike. Where we can, we group nearby jobs to make the most of each trip.
How do I request a quote?
There are four steps: send details, receive a fixed quote, we carry out the work, and it’s guaranteed. The first step only needs photos and a postcode.
How long do sealant joints last?
It depends on movement, UV and weather, cleaning, traffic and the product. Sealant joints are maintenance items, so inspect them regularly.
Can you send site paperwork?
Let us know which documents the site needs, such as RAMS, an insurance certificate or CSCS details, and we’ll confirm them with the quote.
Are your applicators CSCS-carded?
Yes. Our applicators hold CSCS cards.
What causes movement joint sealant to fail?
It depends on how the sealant has let go: a split through the middle points to over-stretching, while peeling from one face points to preparation or primer. Broken edges are a third possibility.