Expansion joint sealing in Geirinis
Our CSCS-carded applicators take on expansion and movement joint sealing in walls, decks and floors in Geirinis and the surrounding area. Send photographs or drawings for a fixed quote.
- Car park joints leaking onto vehicles below
- Movement joints with split or torn sealant
- Rain penetration at brick or block movement joints
Expansion joint sealing for Geirinis sites
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
From enquiry to sign-off
We schedule the visit to fit the site hours and access windows you give us. On the day, the work area is kept contained and tidy, and we check in with your contact before moving on to each new area. Tell us who will meet us and how to get in at your building near Geirinis. We’ll confirm the plan with the fixed quote.
- We assess the joints on site or from photographs, noting widths and how each has failed.
- A fixed quote names the sealant we propose and its movement class.
- Where areas have to stay open, we agree a phased sequence before starting.
- We strip the old sealant or filler and prepare each face until it’s sound and dry.
- Backing rod or bond-breaker sets the depth, primer goes on where specified, and the sealant is applied and tooled.
- Finished joints are inspected, the cure time confirmed and the 12-month guarantee applies.
Getting the site ready
- Point out any areas we must not close
- Arrange parking or a loading space
- Warn occupants and staff about the work
Ask for a quote
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. The first step is to give us a call on 01277 525 020 or email a schedule or drawings with what you know.
Advice
Expansion joint sealing in Geirinis
Internal floor joints take trolleys, pallet trucks and forklifts. Unsupported edges break up under wheels, so the right filler or sealant for the traffic and movement matters. We will tell you if the edges need repairing before sealing, and phased work keeps areas in use. We work on car park decks and ramps, brickwork movement joints and blockwork control joints, and the failures we are asked to look at most are expansion joints filled with dirt and stones and water dripping through deck or ramp joints. Sealant applicators who only do sealant are a different proposition from a general trade with a gun in the van: in Geirinis, that means joint design, primers and backing rod as standard.
For floor or movement joints around smaller places like Geirinis, we plan to finish in one visit where we can. Photos, approximate widths and what uses the floor help us bring the right materials.
We stand behind the joints we seal: 12 months, guaranteed. That covers our preparation and application, and we come back if anything isn’t right.
- Where
- Geirinis (HS8)
- Region
- Na h-Eileanan Siar
- Cover
- 12 months on every job
- Quotes
- A fixed quote before we start
- Call
- 01277 525 020
- Page updated
- 3 November 2026
Traffic, movement and joints around Geirinis
With the shore within about 1 mile, Geirinis counts as a coastal location. Coastal yards and decks give their joints salt and wet weather to deal with, not just wheels, and edges left open tend to break up faster. Island jobs, Geirinis among them, are planned around the ferry and the forecast. Photos and joint sizes help us load the right products.
Around Geirinis, open joints collect water and debris, and the arrises are the next to go.
Geirinis (Gaelic: Gerinish) is in Na h-Eileanan Siar. Geirinis sits inside our coverage and the rest of Na h-Eileanan Siar, with the same fixed quotes and 12-month guarantee as everywhere else. Geirinis is one of 87 places we cover in Na h-Eileanan Siar for movement joints.
Anyone looking for expansion joint sealing in HS8 gets the same process as the rest of our area: send details, get a quote, we seal, guaranteed. If your site is on Cille Bha'nain and Dun Mor or close by, send details and we will quote for movement joints. Just outside Geirinis, we also work in Creag Ghoraidh (4 miles north), Grimsay (5 miles north-east), Balivanich (8 miles north), Baile a' Mhanaich (8 miles north) and Dalabrog (13 miles south). Island and remote sites need extra planning, with travel, ferry crossings where needed and weather to allow for, so mention the location when you call the office on 01277 525 020 or email the details over.
What’s near Geirinis
Open spaces near Geirinis include Loch Bee and Ben Tarbert.
Questions we are asked in Geirinis
Can being near the sea in Geirinis affect the sealant we need?
It can. Driven rain and salt are tougher on outside sealant than sheltered inland conditions. We check the specified product suits the exposure and pay close attention to preparation.
Do we have to stop operations in Geirinis while the joints are sealed?
In the majority of cases the site keeps working. Joints are done in phases, a bay, aisle or deck at a time. The phasing plan comes with the quote.
How long does movement joint sealing take?
It normally takes a short visit for a handful of joints, or several days or more for a car park deck or long runs of facade joints. Cure time before reopening is confirmed on the day.
Will you quote for a small job?
We quote for single jobs as well as large packages and programmes. Send details for a fixed quote.
Who decides which product is used?
The specification comes first, if there is one. If there isn’t one, it comes down to the joint: its movement, its surfaces and what it has to cope with.
How long before the joints can be used?
That comes down to the sealant and the temperature. Some products skin over quickly but need longer to cure fully, and we confirm it before leaving site.
Can staff carry on working while you are here?
Yes, with some planning. Tell us your site hours and access windows and we’ll plan around them.
After the work
A few simple habits keep the new joints working:
- Clear dirt from joint lines during routine cleaning
- Record the sealant used and the date in the O&M file
- Avoid parking heavy plant or pallets on joint lines
- Keep traffic off new joints until the cure time is up
Every joint we seal is backed by a 12-month guarantee on workmanship. Keep the handover details, product and date with your O&M records.
Floor joints with failed fillers break up quickly under wheels. Damaged edges make the floor rough and wear wheels faster, and the damage spreads along the joint. Keeping the filler or sealant sound protects the floor.
Building owners, agents and FMs in Geirinis
Housing associations and managing agents often need work done across blocks and communal areas. Work can be phased so residents and staff keep access throughout, with each stage agreed with your site contact.
FMs need a contractor who is easy to get on site. Let us know the documents you need (RAMS, insurance certificate, CSCS details) and we will confirm them with the quote.
Towns and villages near Geirinis
What else we do in Geirinis
Different surfaces, different methods
Brickwork and blockwork joints
Vertical movement joints in brick and block walls let the masonry grow and shrink. They take a low-modulus sealant with a movement class to suit laid over backing rod at the correct depth.
Cladding panel joints
Cladding panels move more than masonry as they heat and cool. The joints need a low-modulus sealant with enough movement capability, and we will confirm the colours available for the specified product.
Leave it or put it right?
Sealing over a failed movement joint is a common shortcut. A bead laid on top of the failed one neither grips nor flexes properly. We cut out the old seal and prepare the faces every time. Renewing every failing joint on one visit is the sensible approach for a place like Geirinis. Photos of each area help us quote the whole job.
Cost follows what’s involved: stripping out, preparation, sealing, access and phasing. Call for a quote.
Why appoint us
- Constructionline member
- Work to your specification and the manufacturer’s guidance
- Sealing commercial buildings since 2005
- Coloured sealants to suit the setting, where available
Take a look at how commercial sealant jobs are priced and our accreditations.
When to call us in Geirinis
The edges of the material can fail rather than the sealant. Weak or crumbling concrete, brick or render edges give the sealant nothing sound to grip so edge repair has to come before resealing.
What tends to prompt an enquiry:
- Sealant peeling off one face of the joint
- Weathered movement joint sealant that no longer flexes
- Torn sealant in brick or block movement joints
- Joints packed with grit and debris
Around Geirinis, each joint gets a filler or sealant matched to what crosses it and how much it moves.
Before you book anyone
- Whether primer will be used where the manufacturer specifies it
- Their approach to joint depth and backing
- The terms of the workmanship guarantee
- The named product and why it was chosen