Expansion and movement joint sealing in Cobham, Kent
Our CSCS-carded applicators take on expansion and movement joint sealing in walls, decks and floors in Cobham and the surrounding area. Send photographs or drawings for a fixed quote.
- Weathered movement joint sealant that no longer flexes
- Sealant pulling off the joint face
- Damp inside where a wall movement joint has failed
Expansion joint sealing across Cobham
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Expansion joint sealing in Cobham, done properly
The seal is what lets a movement joint do its job. When the sealant splits or lets go, the gap fills with dirt and water; the joint jams, its edges take the load and the arrises spall. Dealt with early, it stays a sealant job rather than a concrete or masonry repair. We work on car park decks and ramps, cladding panel joints and blockwork control joints, and what we’re called in for most is torn sealant in brick or block movement joints and leaks through car park deck joints onto the level below. Sealant contractors, mastic applicators, sealant specialists: whatever the job title on the order, the work in Cobham is the same: the right product in a properly prepared joint.
In and around smaller places like Cobham, the concrete floors we see are often in converted farm buildings, small workshops and storage units. Whether it’s a farm store turned workshop or a storage unit, the joints need a product that suits the traffic.
A 12-month guarantee applies to all our work in Kent. Should something we installed fail, ring 01277 525 020 or use the quote form and we will come back to it.
- Where
- Cobham (DA12)
- Wider area
- Kent
- Cover
- 12 months on our workmanship
- Quotes
- A fixed quote before we start
- Call
- 01277 525 020
- Updated
- 3 November 2026
Keeping the joints sound
A few simple habits keep the new joints working:
- Reopen bays and walkways only after the stated cure time
- Clear dirt from joint lines during routine cleaning
- Inspect exposed joints once the cold weather has passed
- Report split or peeling joint sealant early
Grit is the slow enemy of a joint seal. Grit trodden or driven into the joint works at the surface until it tears. Regular sweeping keeps joint lines clear.
When one joint fails, others of the same age are rarely far behind. It pays to check every joint, not just the obvious one. We can suggest an order, worst joints first.
Site staff or a sealant specialist?
Certain joints really need a specialist: fire-rated seals that must follow a tested detail, trafficked floor joints and external movement joints among them. A poor seal in places like these tends to cost more to put right later.
Redoing a failed joint normally costs more than getting it right at the outset, since all of it has to come out and the faces be cleaned back again. That’s why many clients bring in a specialist from the beginning.
How the job changes by surface
Car park decks and ramps
Car park joints are some of the hardest-working joints in any building. We use a sealant made for wheel loads and the expected movement, phased so parts of the car park stay open.
Joints between different materials
Hybrid or MS polymer sealants bond to many substrates. The choice depends on the substrates and how much the joint moves.
Questions we are asked in Cobham
Will you take on work at estates like Bowes Industrial Centre, close to Cobham?
Yes. Our area takes in Cobham and its surroundings, with estates and business parks such as Bowes Industrial Centre included. Send details of the unit and the work through our quote form for a quick quote.
Is Cobham off your patch?
No. Small places get the same service as large ones. Our area covers London and the South East counties. Where we can, we group nearby jobs to make the most of each trip.
What site paperwork can you supply?
Each site asks for different documents, so list what you need, whether RAMS, insurance or CSCS details, and we will confirm with the quote.
Who decides which product is used?
If the job is specified, we follow the specification. If not, we choose for the movement, the surfaces and the conditions, in line with the manufacturer’s guidance.
Can you fit around our working hours?
Give us your site hours and any access windows in your enquiry, and we’ll plan around them. Our office runs Monday to Friday, 8am until 5pm.
Do you offer coloured sealant?
That depends on the product. Some ranges offer many colours, others very few, so the available colours are confirmed with the quote.
What if the joint edges are damaged?
Spalled edges need repairing before a new seal will last. Sealing over them leads to early failure.
Why deal with it now?
A failed joint seal doesn’t mean the slab, panel or wall needs replacing. Where the edges are sound, cutting out and resealing is enough. If the edges have broken up, we’ll tell you they need repairing first. Around Cobham, it’s better to renew all the failing joints at once. Send photos of each area and we’ll quote for the lot.
The product called for affects the cost, as does the preparation each joint needs. Access, phasing and site requirements come into it too.
What you get with us
- Clear, fixed quotes
- Colour agreed before work starts
- One number for every site we cover
- Constructionline member for supplier checks
See what affects the cost or our accreditations and insurance.
Diagnose, treat, sign off
We bring the products specified for the job, along with primers and backing rod. Any old material is cut back to clean, sound faces, the manufacturer’s primer is applied where it’s called for, and the sealant is tooled off neatly. For work around Cobham, we aim to finish in one visit, so photos and measurements up front really help. Then the right materials arrive with us.
- Photos, joint lengths and drawings come to us, or we visit.
- We compare each joint’s width with the movement and the sealant’s capability.
- Every joint is cleared of the failed seal and any grit packed into it.
- Any broken arrises or friable edges are flagged before work goes further.
- The right sealant goes in at the right depth, bonded to the two sides only.
- Areas reopen once cured, and the work carries our 12-month guarantee.
Before we start on site
- Explain the parking and delivery arrangements
- Agree which areas must stay open
- Share the asbestos register for older buildings
Request a quote
The quickest route to a quote is a few photographs and the site postcode. Upload them with the quote form, or give us a call on 01277 525 020 or email drawings and photos to discuss it first.
Read more
Slabs, ramps and loading bays in Cobham
The South East is one of the drier parts of the UK. Even so, yard and car park joints are only sealed when they’re dry and clean, and gritting in cold spells finds its way into open joints. Central London is about 23 miles from Cobham. Warehousing clusters around the motorways that ring and radiate from London.
For estates staff at a university like University for the Creative Arts - Rochester (4.9 miles east of Cobham), building and paving joints are part of the planned maintenance list. On industrial estates such as Bowes Industrial Centre (3 miles south-west of Cobham), saw-cut floor joints, loading bay slabs and yard joints take the heaviest traffic. For an estate such as Gravesham Community Hospital (3.9 miles north-west of Cobham), the joints in ramps, decks and long building elevations all need attention over time.
Cobham is about 3 miles south of Gravesend, in Kent. If you’re looking for expansion joint sealing in Cobham, we can help, as we do across Kent. Cobham is one of 931 places in Kent on our list. We also cover London, around 23 miles from Cobham.
Work on movement joints is covered throughout DA12, for business premises of every kind. If your site is on The Street, Lawrence Drive and Cobhambury Road or close by, we can quote for movement joints. Nearby places we also cover include Upper Bush (2 miles south-east), Lower Bush (2 miles south-east), Cuxton (2 miles south-east), North Halling (3 miles south-east) and Upper Halling (3 miles south). Bigger towns within reach include Maidstone (10 miles south-east), Sittingbourne (15 miles east), Dartford (8 miles north-west), Sevenoaks (12 miles south-west), Gravesend (3 miles north) and Tonbridge (14 miles south).
Around Cobham
We work on buildings around Thamesview School, The Ship Inn and Jeskyns, among other places. Cobham’s nearest station is Sole Street station, about 1.2 miles south-west. Nearby you’ll also find Rochester Castle (4.3 miles east) and Gravesham Community Hospital (3.9 miles north-west). Not far away are Gad's Hill and Ranscombe Farm.
Building owners, agents and FMs in Cobham
As a CHAS accredited contractor and Constructionline member, we make supplier vetting simple. We’re fully insured, and our insurance certificate can go with the quote.
Main contractors use us as their sealant subcontractor, on new build and refurbishment alike. Programme, specification and site rules come first, with CSCS-carded applicators on site.