Expansion and movement joint sealing in Binsted, West Sussex
Planning work on a movement joint in Binsted? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Torn sealant in brick or block movement joints
- Expansion joints filled with dirt and stones
- Car park joints leaking onto vehicles below
Expansion joint sealing near Binsted
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
How we handle expansion joint sealing in Binsted
A movement joint only works while its seal does. When the sealant splits or lets go, the gap fills with dirt and water; the joint jams, its edges take the load and the arrises spall. Resealing at the first signs of failure is far cheaper than repairing the material either side. Site teams most often ask us about weathered movement joint sealant that no longer flexes and sealant peeling off one face of the joint, across precast concrete panel joints, car park decks and ramps and brickwork movement joints. For commercial sealant work in Binsted, you deal with one contact from quote to sign-off, whether it’s one building or several.
Around smaller places such as Binsted, floor joints are often in barns and farm buildings turned into workshops, stores and offices. Whether it’s a farm store turned workshop or a storage unit, the joints need a product that suits the traffic.
The 12-month guarantee is for workmanship rather than wear and tear. How long a sealant joint lasts depends on movement, exposure, cleaning and use, so we are clear about what is covered before work starts.
- Where
- Binsted (BN18)
- Region
- West Sussex
- Cover
- 12 months on our workmanship
- Price
- A fixed quote before we start
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
Keeping the joints sound
Problems stay small when the joints are checked regularly. In particular:
- Clear dirt from joint lines during routine cleaning
- Include every elevation and deck joint in periodic inspections
- Keep racking legs and heavy point loads off floor joints
- Leave barriers in place until fresh joint sealant has cured
Movement joints belong on the planned maintenance inspection list. Early splits and edges starting to lift show up on a routine check, when they’re still cheap to deal with. Should you spot a problem, you can ring 01277 525 020 or send details through our quote form and send a picture.
Joints sealed at the same time generally fail around the same time. It pays to check every joint, not just the obvious one, so the work can be planned rather than rushed. We will tell you which movement joints need doing now and which can wait.
When it isn’t the sealant
Being straight saves everyone time. New sealant won’t cure:
- Movement on a scale no sealant is meant to absorb
- Changing the joint layout or spacing of a structure
- Damaged metal nosings or cover plates over a joint
Not sure which it is? You can give us a call on 01277 525 020 or email a schedule or drawings and we’ll tell you honestly before you book.
Where we work in Binsted
- Brickwork movement joints
- Podiums and floor movement joints
- Blockwork control joints
- Precast concrete panel joints
- Car park decks and ramps
- Cladding panel joints
Also in Binsted
Common questions from Binsted clients
Do you take on work at healthcare sites like Arundel & District Community Hospital?
Yes, hospitals are one of the sectors we cover. Each area is agreed with the ward or department and the estates team in advance.
Is Tokar Industrial Park, near Binsted, within your area?
Yes, sites like Tokar Industrial Park are within our area, along with the rest of Binsted. A few photos and the unit address let us price the work.
Do your applicators hold CSCS cards?
Yes. If you need card details for site access, let us know and we’ll send them with the quote.
Who decides which product is used?
Where there’s a specification, we use the product it names. Otherwise, we recommend a product to suit the joint’s movement, the substrate and the conditions, following the manufacturer’s guidance.
When is resealing likely to be due?
There’s no fixed lifespan: movement, exposure, cleaning, traffic and the product all play a part. Sealant joints are maintenance items, so inspect them regularly.
Can one quote cover more than one building?
Yes. A group of buildings can go on one quote, and you deal with one contact throughout.
Do you have public liability insurance?
Yes. We are fully insured, including public liability cover.
Common problems we fix in Binsted
Some joints were never sealed with the right product. A stiff or general-purpose sealant across a joint with large movement won’t cope. Movement capability is set out in BS EN ISO 11600, and specifications often refer to it.
Common reasons buildings call us in:
- Joints packed with grit and debris
- Water getting into the wall through a failed joint
- Previous reseals laid over old sealant
- Sealant pulling off the joint face
Campuses like University of Chichester (Bognor Campus) (4.8 miles south-west of Binsted) mix old and new buildings, with movement joints wherever they meet.
What your quote should include
- Whether their applicators hold CSCS cards
- Whether primer will be used where the manufacturer specifies it
- How joint depth will be controlled
- How they handle RAMS and site documents
Different surfaces, different methods
Joints between different materials
Junctions between brick and render, or concrete and cladding, move independently. We choose a sealant that grips both faces, with primer where specified.
Brickwork and blockwork joints
A brick movement joint full of old mortar or debris can’t close. We clear the joint fully before sealing.
Diagnose, treat, sign off
On arrival, we sign in, go through any site induction and check how permits are handled. Floors, finishes and fittings next to the joints are covered before anything is cut or cleaned, with the work itself typically taking a short visit for a handful of joints, or several days or more for a car park deck or long runs of facade joints. Rural sites near Binsted may need directions, gate codes or a contact on site. Send that with the details and we will confirm the plan with the quote.
- We start with photos, approximate lengths and any drawings, visiting where needed.
- We compare each joint’s width with the movement and the sealant’s capability and tell you if the design looks wrong for the movement.
- Old sealant and debris are cut out of every joint.
- Edges are checked, and we tell you if any need repairing before sealing.
- The right sealant goes in at the right depth, bonded to the two sides only.
- Each area is handed back after its cure time, under our 12-month guarantee.
Getting the site ready
- Clear stock, furniture or equipment away from the joints
- Warn occupants and staff about the work
- Send any specification or drawings in advance
Getting a fixed quote
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. The first step is to speak to us on 01277 525 020 or send details through our quote form with what you know.
Advice
Expansion joint sealing in Binsted: the local picture
At least three named trading, business or retail sites lie within about 3 miles of Binsted. Their warehouses, yards and car parks are exactly where joints take the most punishment. Binsted is about 50 miles from central London. The roads out of London are lined with trade parks and distribution sheds, and their floor joints take forklift and pallet-truck traffic all day.
Hospitals like Arundel & District Community Hospital (1.9 miles east of Binsted) have multi-storey or surface car parks whose joints carry vehicles round the clock. Across sites such as Sussex Business Village, 1.2 miles to the south-west of Binsted, floor and movement joints can be sealed in phases so units keep working.
Binsted is about 4 miles north-west of Littlehampton, in West Sussex. Any commercial site in Binsted is covered, whether it’s a single job or part of a planned programme. Our West Sussex coverage takes in 373 places, from busy centres to rural villages. Sites around Portsmouth have their own page, about 21 miles away.
Commercial sites across BN18 are covered for movement joints. Nearby places we also cover include Avisford (1 mile west), Walberton (1 mile west), Slindon Common (1 mile north-west), Slindon (2 miles north-west) and West Barnham (2 miles south-west). A short drive away, we cover Worthing (9 miles east), Bognor Regis (5 miles south-west), Chichester (7 miles west), Selsey (11 miles south-west), Littlehampton (4 miles south-east) and Shoreham-by-Sea (15 miles east).
Around Binsted
Locally, jobs take us to sites close to St Philip Howard Catholic High School. The closest station to Binsted is Ford station, roughly 1.9 miles south-east of the centre. Well-known places in the area include Arundel Castle (2.4 miles east) and Arundel and District Hospital (1.9 miles east). Not far away are WWT Arundel and Bignor Hill.
Work for main contractors and building owners
As a CHAS accredited contractor and Constructionline member, we’re straightforward to vet for your supplier list. We’re fully insured, and our insurance certificate can go with the quote.
Hospitality, education, healthcare, office and retail clients book us directly too. We plan around the way the building is used, so the building keeps working while we do.